Standard Oil

/* 1 */ - This variable is equal to a constructor function called Winston. A constructor function is a function that is called everytime a new instance of this variable is created The parameters of this specific function are nickname, age, x, and y. /* 2 */ - In this line, this. refers to the current object instance which in this case is nickname. It is basically saying that the nickname property of this is equal to whatever is passed in the constructor function itself. This object is…

each radian measure to degree measure and sketch the angles in standard position. 1. / 3 rad 2. -3 / 4 C. Determine which of the following angles are quadrantal angles. 1. 850 = __________________ 3. 5600 = ___________________ 2. 2700 = ________________ 4. 2,4500= __________________ 1.5 COTERMINAL ANGLES Co terminal angles are angles in standard position which have the same terminal side. Y …

2.2 The method At the searcher will do the searching process as follows: I. Start at the origin and search the cell number 1 and then number 2, 3. Now, the first revolution is completed. If the target not found, then go to step II. II. Since, the target is not detected, then the searcher will do the second revolution which contain the cells number 4 to number 14 as in Fig.1(a). And so on until the hole will detect. Assuming that the target is randomly located in the space at the…

Jamie's Whaling Station Ltd., the owner/ operator, crew, and or captain. The plaintiff must prove one or all of the defendants owed a duty of care to the passengers on the tour to act carefully towards the situation. and that the defendant breached the standard of care by acting carelessly which caused harm, damages, injury, or death to the plaintiffs (McInnes 135) The plaintiff could claim Jamie's Whaling Station Ltd. is responsible for the safety of all persons on-board the passenger boat on…

%\addcontentsline{toc}{section}{Activity 1.16} \section*{Activity 1.16} \begin{enumerate} \item The graphs are different because of scaling, and the bar chart A start at zero while the bar chart B start at 25. \item Yes, the graphs tell the same story, even though the scale is different, he used the scale of 20 units in Bar chart A and 5 units in Bar chart B. \item Jairos should use Bar chart B because it represents the information clearly and accurately, In Bar chart A is not easy to tell…

there are not enough bits to obtain the MSB of last block, multiplier is sign extended by one bit. Therefore Modified Booth Multiplication is a technique that allows for smaller, faster circuits by recoding the numbers that are multiplied. It is a standard technique used in chip design, and provide significant improvement over long multiplication technique [6]. III. SOFTWARE DESIGN Modified Booth Multiplier consist of three basic components namely Booth encoder (BE), Booth Selector (BS) and…

The key distinction between correlation and casual connection is the effect that one has on the other regarding the outcomes in scientific test results. In a study, the investigator is looking for the possible effect on the dependent variable that might be induced by changing the independent variable. Casual connection is an occurrence or action that can cause another and the results are predictable and certain. With that being said, casual connection can also determine how the two events are…

To determine differences among the three groups, the researchers used a (3 groups x 2 phases) analyses of variances. Initially, the researchers looked at the number of AR quizzes passed in high, middle, and low readers across both the baseline and intervention phases of the study. Then, the book levels read by the three varied groups were studied across both phases. Last, differences were examined for significance. The data revealed that the high group passed more AR quizzes than the low group.…

The first part of the experiment required one to trace the light rays going through a converging and diverging lenses. By setting up the light source towards the end of the paper and placing the lenses about 5 cm in front of the light the focal distances were found to be 14 cm for the converging lens and -5.5cm for the diverging lens. These focal distances theoretically make since because the converging lens causes the light rays to combine in front of the lens making it positive and the…

An 10X12 IR was used to produce the image and the SID was set at 40”. The Right Phantom foot was placed in the center of the IR. The CR was aligned perpendicular to IR to medial malleoli. A 4-sided collimation was created that included outer margins of the foot and ankle. A 68kVp, a 3.2mAs and a small FS was selected. The right marker was placed in IR. PACER Patient in a lateral recumbent position, affected side down. Flex affected limb 45°. Center and align ankle joint to CR. The plantar…