Sodium

NANOCARRIERS AS PROMISING NOVEL SYSTEMS FOR CONTROLLED DELIVERY OF DICLOFENAC SODIUM [N.B: Authors' details blinded by Pro Journals for Review] ABSTRACT The formulation and evaluation of Diclofenac sodium from liposomes, niosomes and nanoemulsion are analyzed. The release profiles of Diclofenac sodium were almost similar in all the formulations. It is found that 85% of Diclofenac sodium diffused out from the colloidal systems within 8hrs and practically all the drug was released within…

vary, much like salt water. Also similar to salt water, slime often consists of H2O, either as a solvent or in a chemical bond. For example, “One variety of slime that can be easily made in the lab involves the addition of a saturated solution of sodium tetraborate decahydrate (Na2B4O7⦁10H2O), commonly known as borax, to a solution of glue and water” (Rohrig 3). Borax is commonly used…

Figure 3. Possible reaction mechanism for the decomposition of ammonium perchlorate. Based on the findings from all of the used techniques, the species formed in the beginning are ammonium ion, oxygen and chlorine species. The decomposition products of ammonium ion were hydroxylamine, ammonia and nitrogen dioxide. The perchlorate ion loses one of the oxygen atoms and forms chlorate ion. The ammonia is lost in reaction through formation of hydroxylamine, which is formed in reaction between…

“With increasing degree of calcification, the concentration of NaOH increases. The relationship between the concentration of NaOH and the factors in the calcified red mud liquor is given by three Equations (16–18): N_NaOH=1.29(N_1 m_1-N_2 (m_2-N_NaOH/1.29) (16) m2 = m1+m1N3 (17) r = 1000/m2…

1-Paper 2-gallon size Zip- Loc bag 3-Iodine beads (available from forensic supply companies) Note: Iodine crystals can be used along with a small amount of powdered vermiculite. 4-Rubber or plastic gloves are recommended 5-Safety glasses or goggles Safety Precautions Firstly,Wear safety glasses or goggles to protect our eyes from iodine vapors. Iodine is very toxic in nature , both as vapor and through excessive skin contact. Work in a well ventilated area is necessary. We must Keep all…

Using qualitative analysis, two cations in an unknown solution was identified. After repeated mixing, centrifugation, and decanting, lead was confirmed in Part A and barium in Part B. In Part C, different colored flames of metal species were observed using cation flame tests. Formula unit, total ionic, and net ionic equations were then composed for the identified cations. If the experiment were to be repeated, step 13 could be ommitted as barium was already confirmed in step 12 with the…

Since suitable crystals for X-ray single crystal analysis was not obtained, to have reliable structural information, HR-TEM analysis of the product was carried out. The average size of the assembly calculated from HR-TEM measurement is found to be 2.8 nm which is in good agreement with the size of the previously reported Pd6L8 assembly where L is the non N-methylated (2.5nm, Fig. 2).9 As first step, to explore the catalytic activity of 1 in copper and phosphine free Sonogashira coupling reaction…

Research Question: How do different concentrations of nitric acid (measured in molars) with copper powder (grams) affect the rate of reaction (measured in seconds) measured using a stopwatch? Hypothesis: The copper powder placed in the most concentrated amount of nitric acid, measured in molar, will take the least amount of time, measured in seconds, to react compared to the amounts of copper powder in other less concentrated amounts of nitric acid. This is as if the concentration of nitric acid…

Introduction: In this lab, seven test tubes containing solutions in equilibrium had different stresses added to them to examine the balance in each example. The purpose of the experiment was to indentify the details of shifting in equilibrium reactions and determine how the adding of a stress can affect a reaction. A chemical reaction that is in equilibrium is reversible, where a reactants can create products and products can go back to products. Equilibrium is reached when the rate of a…

Endothermic or Exothermic? The energy changes lab was an interesting lab in which the class compared two chemical reactions, the solute baking soda and the solvent vinegar, and the solvent baking soda solution with the solute of calcium chloride to see whether the changes were endothermic or exothermic reactions. I concluded that vinegar and baking soda was the endothermic reaction and baking soda solution and calcium chloride was the exothermic reaction. I knew this because in the vinegar and…