Sodium silicate

environment the student had, was water and sodium chloride. In this instance water was the model cell (what was in the dialysis tubing) and Sodium chloride was the surround environment (plastic cup). The initial weight of the model cell was 13.2g, but after sitting in the sodium chloride solution over night the cell lost water and only weighted 11.6g. Since the solution of the model cell- in this case water- left the cell and entered the surrounding Sodium Chloride it meant the cell had a…

The % relative standard deviation (% RSD) was found to be below 5 % for all the four analytes in system precision and below 6 % in method precision. The data as shown in Table 3.4.3.3.3 and 3.4.3.3.4. LOD values observed for Hydrazine carbamate and Hydrazone carbamate were 0.0018 µg per mL and 0.00092 µg per mL respectively. The LOD value observed for both 1-Hydroxy benzotriazole and 2R, 3S Chlorohydrine hydrochloride were 0.0019 µg per mL. The LOQ values observed for all four analytes were…

Part one Make a 3 list of chemical safety hazards? The three chemical safety hazards are: Poison Toxic Corrosive Reactive Environmental hazards 2. What is Amalgam? Amalgam is mixture of metals of mercury with another metal and other metal. Almost all metal can be an amalgam with a form of mercury. 3. If you had to train someone on how to separate the mercury from the amalgam, what training would they need? WHY? If I had to train someone on how to separate the mercury…

Effect of Organic Solvents on Particle Size When anti solvent was 0.4% (w/v) F68 aqueous solution, the effect of various good solvent was investigated. These organic solvents include ethanol, methanol, PEG 400, propylene glycol. The result as mention in Table 16 & Figure 27 showed that the particles prepared by methanol were the smallest (317 nm) among other organic solvents. Ethanol, PEG 400, and propylene glycol produced the particles having the mean particle size of 525nm, 1274nm, 864nm,…

Acid Base Balance Study Guide Definition: The body’s ability to regulate and compensate for variances of the acidity or alkalinity of body fluids through mechanisms in the brain, kidneys, lungs, and buffering system. Concept Key Terms: • Acid: any substance that has a pH less than 7.0 • Acidosis: the condition of having too much acid build up in body fluids, below 7.35 • Alkalosis: the condition of having too much alkaline build up in body fluids, above 7.45 • Anion: a negatively charge…

purpose and objective of this experiment was to determine the percent by mass of acetic acid within a sample of vinegar using volumetric analysis with the titration technique. The theory is that if the volume and molar concentration of the standardized sodium hydroxide (NaOH) solution is known, then the percent by mass of the acetic acid (CH3COOH) in vinegar can be calculated after a titration.1 Within this experiment, a NaOH solution was standardized with a primary standard acid of potassium…

Table 1 Composition of Lansoprazole microparticles Formulation code Amount of drug(mg) Amount of polymer chitosan (mg) Drug polymer Ratio Tween 80 (%w/v) F1 100 100 1:1 1.25 F2 100 200 1:2 1.25 F3 100 300 1:3 1.25 F4 100 400 1:4 1.25 F5 100 500 1:5 1.25 F6 100 600 1:6 1.25 Characterization of Lansoprazole microparticle The microparticle will be characterized for following parameters: Percentage yield: After complete drying, the drug loaded microparticle was collected and weighed accurately…

Batch adsorption experiments Adsorption of the Pb2+ ions by the Fe3O4@GMA-AAm nanocomposite was measured from batch adsorption experiments by mixing 10 mg of adsorbent with an aqueous solution containing a predetermined concentration of Pb2+ ions (50 mL). The mixture was shaken at 200 rpm to reach equilibrium. After a specified time, the solid and liquid were separated by external magnet and the concentrations of Pb2+ ions were measured by AAS. To find the optimized pH in adsorption of Pb2+ ions…

Sterile Saline (0.9% w/v NaCl) Dissolve 9.0gm of NaCl in 1000ml water and dispense 9.0ml of the solution into 20ml test tubes. Autoclave the tubes as per the validated cycle and cool to room temperature. Sterile saline with polysorbate 80: Dissolve 9.0gm of NaCl in 1000ml water and add .5gm of tween 80 to the resulting saline solution, dispense 9.0 ml of the solution into a number of 20ml test tubes. Autoclave the tubes Preparation of Inoculums and its Standardization: 1) Take loop full of…

Proximate analysis The analysis result of proximate composition of dried laver (P. species) has presented in Table 1. In our study, the crude protein of commercial dried laver was found to be (42.99 ± 0.051g/100g DW) and the moisture content was (9.40 ± 0.056 g/100g DW). The ash content was found (10.30 ± 0.033 g/100g DW). Laver, in this study, contained a very small amount of crude lipids (0.49 ± 0.04 g/100g DW). The total dietary fibre of dried laver was (31.63 ±0.032 g/100g DW). The total and…