Sodium hypochlorite

assigned with glucose and sucrose. Diluting 1 M of sodium chloride with water made six solutions. The six solutions ranging from 0M to 1M were prepared. These 6 solutions composed of 50 mL of solutions with different concentration of NaCl. The uses of concentrations of NaCl were 0M, 0.2M, 0.4M, 0.6M, 0.8M, and 1M. Then 6 equally sized and shaped cylinders of potato were obtained and weighed initially. Then these 6 potatoes were put inside of the sodium chloride solutions. After 45 minutes, the 6…

The reaction of soda ash (Na2CO3) with calcium sulfate in water is represented by the following chemical reaction: Na2CO3 + CaSO4 >>> CaCO3 + Na2SO4. Assuming that this reaction is complete and that there is 153 mg/l of CaSO4 initially present, what is the mass of soda ash that must be added to 1 liter of the water? How many grams of CaO are required to be the chemical equivalent of 246 g of Mg(HCO3)2? A complete reaction requires the number of CaSO4 to be equal to the number of moles…

properties of Sodium Chloride, being that it is not Hygroscopic, Efflorescent or Deliquescent. Thus, based on this experiment solely, it is not ensured that the salt is Sodium Chloride as 3 other salts share this…

In this lab, the percent composition of each component in the mixture was calculated. The mixture contained NaCO, CaCO3, and sand. NaCO or salt had a physical change when it completely dissolved in water. A chemical change occurred when hydrochloric acid was added to CaCO3 or chalk because the mixture changed to a yellow green color. In order to obtain the percent composition, a filtration system was used to separate the sand from the liquid, by straining the solid with the use of filter paper.…

Obtain a piece of paper that is approximately 5cm x 10cm, and tear it into small fragments. Place the pieces of paper on a watch glass, and light the paper with a match. Observe and record reactions. Deposit a microspatula of NaCL (sodium chloride) into a test tube, and dilute the substance by infiltrating approximately an inch of water to the test tube. Let the NaCL dissolve into the water by shaking the test tube with one’s thumb over the opening of the test tube. Using a dropper, place…

Salt use on roads in winter salt is a common way to clear slippery roads. Salt lowers the temperature of the water which causes it to melt and it's one of the effective way of lower weather related collision. Using salt on road lower car accidents on highway up to 80%. However, salt used on roads causes rust on cars and environmental studies had showed that salt use for de-icing could affect water supplies, soil,and wildlife. Negative effect of using road salt The more salt that gets into…

Purpose I’m writing to propose ATC purchase an alternative traction device instead of snow chains. The current method of complying with mandatory snow chain laws is to purchase metal snow chains for the drivers to carry through the states and provinces where it is mandatory to have them in the trucks during the winter months. Situation Snow chains are cumbersome, heavy, and are often stolen when left behind for the ETLLC group to retrieve. The approximate weight of a set of snow chains is…

Summary: Put on any necessary personal safety equipment, and one person from each team should collaborate with people from other teams to create the NaOH solution. The other team members should focus on setting up the buret by rising it with distilled water as well as building the titration apparatus and preparing the HCl solution. In order to prepare the NaOH solution, first take some solid NaOH and measure its mass. Then get a 250 mL volumetric flask and fill it about halfway with distilled…

In this experiment the molarity of ammonia is calculated using the process of titration. A chemical reaction occurs when two or more substances change to form different molecules. In each reaction there are ratios between each reactants. Certain amounts of each reactant are needed to fully complete the chemical reaction. Stoichiometry is the relationship between the quantities of the reactants. An acid is a substance that reacts and donates H+ ions. A base is a substance that accepts H+ ions. An…

Soap and Detergent Soap and Detergent are the cornerstones of human cleanliness. Soap is, “a substance used with water for washing and cleaning, made of a compound of natural oils or fats with sodium hydroxide or another strong alkali, and typically having perfume and coloring added”( Soap 2018 ). Detergent is, “ a water-soluble cleansing agent that combines with impurities and dirt to make them more soluble and differs from soap in not forming a scum with the salts in hard water” ( Detergent…