Paper chromatography

Calculations for Dissolved Gas Analysis in Water Samples Using a GC Headspace Equilibration Technique, EPA National Risk Management Research Laboratory, RSKSOP-175, Rev.2, May 2004. 1.2 Light Hydrocarbons in Aqueous Samples via Headspace and Gas Chromatography with Flame Ionization Detection (GC/FID), Pennsylvania Department of Environmental Protection Bureau of Laboratories, PA-DEP 3686, Rev.0, April 2012. 1.3 Lange’s Handbook of Chemistry, 14th edition (1992), McGraw Hill. 1.4 Gas…

Gas chromatography (like any other chromatography) is a separation technique in which the mobile phase is a gas. This technique is applied for the separation of volatile substances. This method separates a mixture into its components and is used to measure the concentration as well as it identifies the components. GC creates a time separation rather than physical separation which means that the components are separated in time. After they are detected, a chromatogram is generated. Each peak in…

Isolation of Chlorophyll and Beta-Carotene from Plant Leaves Yokoyama Yuri B1 (A0142349E) 1. Aim: a) To separate beta-carotene and chlorophyll via column chromatography. b) To analyse the contents of the plant extract as well as the separated beta-carotene and chlorophyll via thin layer chromatography (TLC) c) To analyse the absorption peaks of both beta-carotene and chlorophyll using UV-Vis spectroscopy 2. Results: Fig 1. UV-Vis spectroscopy results for S2 (Beta-Carotene extract) Wavelength at…

Isolation of Component Via Extraction Objective: Separation of organic acid from a neutral compound using liquid/liquid extraction. Experimental: Similar to the “Thin Layer Chromatography” experiment, a TLC plate was ran with 2 ml of EtOAc and 8 mL of hexane in the jar. The Rf value was calculated using the formula located in the data for all the TLC plate. The mixed compound that was dotted on the TLC plate had 0.300 g of the impure benzoic acid and 10 mL of dichloromethane. A 50 mL flask…

Methods Column chromatography was set up using a 60 ml syringe clamped to a ring stand. The syringe was plugged using a small amount of cotton. An Erlenmeyer flask was placed underneath the column to collect any excess material. Eleven 20 ml vials were labeled numbers 1 through 11. Silica gel was measured to 42 ml using a graduated cylinder and then moved into a 150 ml beaker. A slurry was created by adding 50 ml of hexane to the beaker containing the silica gel. The slurry was stirred for…

experiment was carried out using 128 & 157 GSM art matt paper, 60 & 100 GSM offset paper; and Offset glossy and quick-drying ink of TGS brand. Papers were printed with different color and 10 different volume inks. Primary colors were overprinted in sequence CY; MY and CM. Then various primary…

TLC and HPTLC Introductions Thin layer chromatography (TLC) is derived from liquid chromatography where liquid serves as mobile phase and thin layer of substance on a flat late surface serves as stationary phase. The thin layer of materials act as sorbent while the mobile phase known as solvent. Solvent will send the solutes through the sorbent depends on the strength of the mobile phase as it dissolved the solute and send them up the plate against gravity ,and resistance of sorbent…

Utilizing column chromatography and recrystallization, separation and purification of the two products was obtained. The mass of 4-NBB, the para product, was 1.57 grams, while the mass of 2-NBB, the ortho product, was 0.80 grams. The para product was expected to have the higher yield, since it is more stable and consequently harder to break down throughout the experiment. Keywords Nitration, Bromobenzene, Substitution, 4-nitrobromobenzene, 2-nitrobromobenzene, Column Chromatography, Infrared…

Abstract In this paper CuO-NH-NH2 nanoparticle was synthesized and used to remove anionic dyes from single and binary systems. The scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FT-IR), Energy-dispersive X-ray spectroscopy (EDAX) and X-ray diffraction (XRD) were used to characterize the nanoparticle. Direct Red 80 (DR80) and Direct Green 6 (DG6) were used as anionic dyes. The effect of adsorbent dosage, dye concentration and pH on dye removal was evaluated. Kinetic…

The goal of this experiment was to use the technique of thin layer chromatography (TLC) to identify the active analgesic ingredient of Advil and monitor the transesterification of methyl salicylate from acetylsalicylic acid. The synthesized methyl salicylate was then purified using acid-base chemistry and analyzed using H NMR spectroscopy. Identification of a proper mobile phase to separate common analgesics used in over-the-counter pain relievers was essential in being able to determine the…