Organometallic chemistry

INTRODUCTION 1.1What is an acid-base titration? An acid –base titration is the determination of the concentration of an acid or base by neutralizing the acid or base with an acid or base of known concentration. An acid-base titration is the analysis of the concentration of acids and bases; through this process an acid or base of known concentration neutralizes an acid or base of unknown concentration. The neutralization of an acid or base in acid-base titration can be measured with either a…

III. RESULTS AND DISCUSSIONS: A. Characteristics of Aluminum-Graphite composites and the in-situ reaction To examine the reaction condition of carbon flakes and Al powders, 4 wt. % carbon flakes were added to Al powders. Fig. 1 shows the DSC plot obtained during heating and cooling of the green compact from room temperature to 750 0C and from 750 0C to room temperature at a heating/cooling rate of 3 0C /min under argon gas atmosphere. From the DSC heating curve it is evident that the total…

Kent Grand Plus 8-Litre Mineral RO + UV/UF with TDS Controller Water Purifier: price, Facts, Reviews, and Tips This Kent RO water purifier is an alternate model of “Kent Grand 8-Litre Wall Mountable RO+UV+UF+TDS Water Purifier” with no UF filtration technique and higher purification capacity. This wall mountable Kent Grand RO Plus water purifier has a capacity to purify 100 litres of water per day. Working on a technique with the double purification of Reverse Osmosis, and Ultraviolet, the…

Phase 2 – Agarose Gel Electrophoresis 1. Obtain our four H, E, L, and P labeled micro tubes and place them on ice. 2. Set the micro pipet to 2.0 ul. 3. Transfer 2.0 ul blue dye to each of the four H, E, L, and P micro tubes. 4. Mix the four micro tubes by using this two-step method: * Place each tube briefly on the vortex to get the components to collect at the bottom of the micro tubes * Pulse spin the four micro tubes in the centrifuge to mix all of the components completely. 5.…

4.1 Maintenance and sub-culturing of endophytic fungi The cultures were procured from already maintained repository in laboratory. The maintenance of the cultures involved preparation of Potato dextrose agar (PDA) plates, sub culturing of cultures and long term preservation. 4.1.1 Preparation of PDA (Potato dextrose agar) plates 39g of PDA was dissolved in 1000 ml double distilled water, stirred to mix properly and was transferred into 250 ml Erlenmeyer flasks and autoclaved at 121˚C at 15…

1.4 Effect of Microcrystalline Cellulose (MCC)Type Formula F12 was utilized to study the effect of changing the type of MCC(Avecil PH-101 ) as a carrier material instead of (Avecil PH-102) in F8 on the dissolution behavior of the prepared Zolmitriptan liquisolid ODTs. Although the DT of formula F12 (79 sec.) was greater than F8 (48 sec.) as in Table(18),the dissolution behavior of the formula F12 was faster than F8 as in Table (18) and Figure (48), this difference was non…

INTRODUCTION Chemically and thermodynamically foam is an unstable, dispersed system of entrapment of gaseous molecules in solid or liquid matter. Instability of foam is caused generally due to coalescence, liquid drainage and disproportion of bubbles. Foam being aqueous system can be produced using surfactants available commercially. The types of surfactants used in preparation of aqueous foam influence the foam properties (Eisner et al., 2007; Bhakta and Ruckenstein, 1995). Successful foam…

4.0 INTRODUCTION TO RESULT AND DISCUSSION This chapter covers the result and also the discussion on the experiment of lab scale soap production. All of the findings which are the analysis of pH value, saponification value and moisture content of the formulation soap bar is discussed thoroughly throughout the chapter. 4.1 RESULT AND DISCUSSION The purposes of the experiment were to identify the weights of materials to be used in the formulation of soap and also to produce the average quality…

Experiment 1 and 2 Recrystallization: Purification of Solids and Melting points Purpose: In the fist experiment, impure Vanillin was purified through the process of recrystallization. Desired solutes were recovered through the technique of vacuum filtration, and then dried to take percent recovery In the second experiment, a percent recovery of the recrystallized Vanillin from the first experiment was performed. The percent recovery of Vanillin was 77.18% A mixed…

According to R.A Aitken, “An asymmetric synthesis may be defined as a synthesis in which an achiral unit is an ensemble of substrate molecules is converted to a chiral unit such that the possible stereoisomers are formed in unequal amounts.” It relates to any synthetic process that incorporates one or more new elements of chirality during a functional group transformation. Asymmetric synthesis involves the formation of chiral molecules. An object is said to be chiral, if it cannot be…