Organometallic chemistry

1. Is mercury an appropriate target for AGI? Why or why not? Please clearly cite examples for your reasons. (10 points) There are many reasons that mercury is an appropriate target for AGI. • Both companies are in the same industry of footwear products. • First off the two companies have differentiating strategies and markets that they sell to. AGI will be adding a new market to their company goals and increasing their revenue streams. • AGI strives in the casual footwear segment with a…

Subject: Science Concept: Solid, liquid, or gas Sunshine State Standards/Access Points/Common Core: SC.2.P.8.2- Identify objects as solid, liquid, or gas. Primary Instructional Objectives: - Students will be able to identify what the difference is between a solid, liquid, and gas. - Students will be able to identify examples of solids, liquids, and gasses. - Students will be able to sort objects by whether they are solid, liquid, or gas. - Students will be able to define matter and where you…

Effect of Organic Solvents on Particle Size When anti solvent was 0.4% (w/v) F68 aqueous solution, the effect of various good solvent was investigated. These organic solvents include ethanol, methanol, PEG 400, propylene glycol. The result as mention in Table 16 & Figure 27 showed that the particles prepared by methanol were the smallest (317 nm) among other organic solvents. Ethanol, PEG 400, and propylene glycol produced the particles having the mean particle size of 525nm, 1274nm, 864nm,…

Fig 4.12 shows the comparison of product density of hydrotreated GO obtained using CAT-E and CAT-C. The density of hydrotreated GO from CAT-C at 370◦C was 0.8148g/ml whereas at the same temperature the density of hydrotreated GO obtained from CAT-E was 0.8302 g/ml despite sulphur and nitrogen in the GO has been reduced to less than 50 ppm and 1 ppm respectively. The reason for higher density would be due to higher aromatic content in the hydrotreated product obtained from CAT-E. This indicates…

Characterization of the oxidized amylose and the linalool/oxidized amylose inclusion complex. The high water solubility of oxidized amylose can broaden the applications in water environment.14, 32 The Table 1 shows the properties of amylose and oxidized amylose. As expected, the solubility of oxidized amyloses in water is highly improved due to the introduced carboxyl and carbonyl groups. And it increases greatly with the increase of carboxyl content. The results suggest that due to the two-step…

The 'Wingate Cycle Ergometer Test' is an anaerobic test that is performed on a cycle ergometer. Eg. Monark. (Vandewalle et al. 1987). The aim of our test is to measure Peak Power Output(PPO), Relative Peak Power Output(RPP), Fatigue Index(FI) and Anaerobic Capacity(AC) throughout the Wingate Anaerobic Test. For both our participants we will compare our findings and provide an explanation for the similarities/differences we encounter between the two. Peak Power Output is the highest power output…

The purpose and objective of this experiment was to determine the percent by mass of acetic acid within a sample of vinegar using volumetric analysis with the titration technique. The theory is that if the volume and molar concentration of the standardized sodium hydroxide (NaOH) solution is known, then the percent by mass of the acetic acid (CH3COOH) in vinegar can be calculated after a titration.1 Within this experiment, a NaOH solution was standardized with a primary standard acid of…

Abstract In this paper CuO-NH-NH2 nanoparticle was synthesized and used to remove anionic dyes from single and binary systems. The scanning electron microscopy (SEM), Fourier transform infrared spectroscopy (FT-IR), Energy-dispersive X-ray spectroscopy (EDAX) and X-ray diffraction (XRD) were used to characterize the nanoparticle. Direct Red 80 (DR80) and Direct Green 6 (DG6) were used as anionic dyes. The effect of adsorbent dosage, dye concentration and pH on dye removal was evaluated. Kinetic…

Result and discussion: Substrate specificity The substrate specificity for the PPO is represented in table. The Km values for catechol, L-DOPA, L-tyrosine, and p-Cresol are 4.12 × 10-3, 16.4 × 10-3, 6.12 × 10-3, and 5.01 × 10-3, respectively. Catechol was the best suited substrate, having the lowest Km value and highest Vmax value when compared to other 3 substrates (Table 1). Table 1: Substrate specificity of PPO enzyme Substrates Specific activity (units mg-1 protein) Km (µM) Vmax (abs min-1)…

2. RESEARCH ON THE STRUCTURE OF METALS AND TYPES OF BONDING. What are metals? 24% of our planet’s mass is metal. They are used as mainly because of their properties; metals are strong, ductile, have high melting points and are excellent conductors of electricity. Other properties of metals are given below: • Can be made stronger by alloys and heat treatment. • Easily machined. • Most of them are heavy. • Susceptible to corrosion. Metals can be divided into two; Ferrous and Non-ferrous. Ferrous…