Nernst equation

When a magnet is in motion near a non-magnetic conductor such as copper and aluminium eddy currents are induced in the conductor, causing a dissipative force called magnetic braking force, or a change in magnetic flux (figure 2). This force is dependent on: The size and shape of the conductor and magnet The strength of the magnet (μ) The conductors conductivity (σ_c) The distance between the conductive surface and the magnet (d) The velocity of the magnet (v) According to Faraday’s law,…

(2) through transposing Eq (2) The activation energy was found from the following equation E = 8.314 * slope (3) The activation energy values were later used for computing the pre-exponential factors (A) by equation (1). In the meantime, activation energies (Ea) for these energetic compounds were calculated by the Ozawa method. The Ozawa equation according to ASTM E698 is equal to the following…

A rate law is an equation used to determine how much the concentrations of solutions will change as times goes on. In this experiment, the rate changed based on the five degree Celsius temperature change and concentration change in three different reactions. In this lab,…

All the scenes in the play were short and barely any characters were called by name. They also did not go in order of the pamphlet that spells “Shakespeare.” Throughout my paper, I try to describe each scene to the best of my ability with the info of which play they are acting out or about just the scenes in general. The beginning of the play began with people cleaning up the stage with brooms. The three people were slouched over sweeping close together. This showed medium topography and close…

The rate at which a reaction occurs, referred to as reaction rate, is a type of reaction property that directly measures the extent of a reaction. Changes in concentration affect reaction rates in chemical formulas, and if the reaction is not specifically known, the rate cannot be determined. The rates are given in negative or positive measurements depending on whether the concentration is a reactant or product. Knowing this, the first step in finding the reaction rate would be to determine the…

root is a complex number? Answer: If the equation is 7th degree then it has 7 roots. Those roots can be complex or real. Complex roots always come in pairs, so if it has one, then it has 2, the other one being the conjugate of the first one. This in other words, if one complex root is a + bi, then the other complex root is a – bi. If at least one root were complex, then we would have a minimum of 2 complex roots with a maximum of 5 real roots. The equation can have at most 6 complex roots (3…

Introduction This extended experimental investigation (EEI) investigated the effect in which concentration had on the rate of reaction. The purpose of this experiment is to test different concentrations of hydrochloric acid with sodium thiosulfate and to see how long it would take until the cross underneath the flask is no longer visible through the milky white solution. Collision theory A collision is when two or more object run into each other. But collision theory is, that only some…

To give an another definition of complex number, we have to show z= ew for w, where z is any non-zero complex number. If we assume w = u + iv then eueiv = |z|e^i arg z and this means that |z| = e^u , v = arg z . The equation |z| = e^u is a real equation, so we can write u = ln |z|, where ln |z| is the ordinary logarithm with positive real numbers. Hence, w = u + iv = ln |z| + i arg z = ln |z| + i(Arg z + 2n) , n = 0 , ±1 , ±2 , ±3 , . . .6 We profoundly examined the connection between…

Questions: (a) Show that: (b) What value of ε ss would you expect at 800°C and 16000 psi? A= 0.0043 Using your Larson-Miller curve, what temperature should you use for a life of 20 years at the lowest stress level? For the extensive length of time, a temperature of approximately 25 oC which is close to room temperature. With increasing stress or temperature, what changes will you notice in a typical creep curve? When you increase temperature or stress, the creep curve will increase in…

and equation 3.2 and 3.4 become: ∇.J=∇.(σE)=0 (3.6) Based on equation 3.6, the field distribution is depended on conductivity variation inside the material [1, 45, 46]. Furthermore, according to equations 3.5 and 3.6, space charge can be accumulated in insulation material in steady state condition due to the variation of permittivity to conductivity. As a result, by combining equation…