III. RESULTS AND DISCUSSIONS: A. Characteristics of Aluminum-Graphite composites and the in-situ reaction To examine the reaction condition of carbon flakes and Al powders, 4 wt. % carbon flakes were added to Al powders. Fig. 1 shows the DSC plot obtained during heating and cooling of the green compact from room temperature to 750 0C and from 750 0C to room temperature at a heating/cooling rate of 3 0C /min under argon gas atmosphere. From the DSC heating curve it is evident that the total…
1.4 Effect of Microcrystalline Cellulose (MCC)Type Formula F12 was utilized to study the effect of changing the type of MCC(Avecil PH-101 ) as a carrier material instead of (Avecil PH-102) in F8 on the dissolution behavior of the prepared Zolmitriptan liquisolid ODTs. Although the DT of formula F12 (79 sec.) was greater than F8 (48 sec.) as in Table(18),the dissolution behavior of the formula F12 was faster than F8 as in Table (18) and Figure (48), this difference was non…
Intermolecular Forces Intermolecular forces are the result of attractive or repulsive forces between atoms, molecules or ions, primarily as a result of electrostatic attractions; these forces act between discrete molecules. Intermolecular forces are weak forces but without them life as we know it would not be possible: water vapor would not condense into its liquid (or solid forms) if its molecules did not attract each other, and all matter, in fact, would exist as gases. The physical states…
The unique composition and purity of as-deposited SnS2 thin films prepared with different precursor solution volumes from 5 ml to 25ml were determined by EDX analysis as shown in fig 5, which brought out the presence of Tin and Sulfur as elementary components. Two different peaks were observed in the spectrums from fig 5 relevant to the tin and sulfur. The EDX spectra show that the weight percentage for the film prepared at the precursor solution volume of 5 ml is 36.8% and 63.2%, which is…
Magnesium Alloy: Microstructure Characteristics: Fig (8) : Shows the microstructure of Magnesium alloy. Picture source: http://www.omicsonline.org/JMSTimages/2155-9589-2-114-g001.html Magnesium alloys have a hexagonal lattice structure. They are the lightest of all structural metals. Magnesium alloys possess a low galling tendency as a bearing surface in conjunction with shaft hardness above 400…
temperature of about fifty degrees Celsius, and 100g of fine powders of antimony sulfide are added in small amounts periodically to the heated mixture. After all of the crystals of antimony sulfide have been added to the mixture and evolution of hydrogen sulfide has subsided, the temperatures are adjusted to higher levels gradually until the resultant solution starts to boil (Karl‐Heinz and Magnus 20). It is left to boil for an hour, adding boiling water periodically as it evaporates which…
CORROSION STUDIES WITH ANTIGONON LEPTOPUS IN 1M HCl S.Aejitha 1, P P.K.Kasthuri 2andGeethamani 3 1 Department of Chemistry, Asian College of Engineering & Technology, Coimbatore- 641110, India 2 Department of Chemistry, L.R.G.Government Arts College for Women, Tirupur- 638604, India 3 Department of Chemistry, Sriguru Engineering College of Technology, Tamil Nadu, Coimbatore -641110, India Correspondence should be addressed to S.Aejitha ,aejitha_subbaian@yahoo.co.in ABSTRACT The inhibition…
INTRODUCTION Conformational isomerism is a type of stereoisomerism whereby the isomers are interconverted by rotations about the single bonds. There be terms used below such as eclipsed conformation, staggered conformation,dihedral angle and a few more. Eclipsed conformation is the conformation whereby the C-H bonds on one carbon is directly aligned with the C-H bonds of the adjacent carbon. When the C-H bond of one carbon bisects the H-C-H bond on the adjacent carbon, it is known as staggered…
Polarization curve Fuel cell creates 1.16 V of equilibrium potential between hydrogen and oxygen. However, the actual open circuit voltage is around 1 V due to temperature, pressure, and the concentration of the reactant. The ohmic loss is the resistance loss induced by the unique resistances of the component of fuel cell. And the concentration loss occurs when reaction rates of hydrogen and oxygen are faster than their supply rates. (1) The diffusion flux created according to…
product obtained will be different. Primary alcohols have one carbon and two hydrogen atoms attached will produce aldehyde and then to carboxylic acid in two steps by oxidation. While secondary alcohols have two carbon atoms and one hydrogen atom attached will produce ketone by oxidation (Kotz, et al., 2015) Aldehydes, the compounds that the carbonyl group has a hydrogen atom attached to it together with either a second hydrogen atom or a hydrocarbon group. Ketones are the compounds that two…