Humic acid

Decent Essays
Improved Essays
Superior Essays
Great Essays
Brilliant Essays
    Page 46 of 50 - About 500 Essays
  • Improved Essays

    Melting Point Value

    • 294 Words
    • 2 Pages

    A important tests were performed on the product to pressure the results: melting point value, percent yield, IR, and TLC. The experimental melting point value was found to be a range of 165-167 ºC being a little lower than the literature value for camphor, the intended product, was 175 ºC. The sharp range was resulted in a slightly pure product. The percent yield was lower than expected which can be the reason most of the product was lost during the extraction and almost completely sublimated…

    • 294 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Conclusion The empirical formula of the copper chloride hydrate compound is CuCl2 · 2H2O. Discussion of Theory The technique of gravimetric analysis can be used to find the empirical formula of a compound when the amount of it is known. By dehydrating the copper chloride hydrate sample and using it for an elemental copper-producing chemical reaction, one can isolate the masses of the water, copper, and chloride and determine their mole ratios. Since the Law of Definite Proportions states that a…

    • 417 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    concentrations 0.1M, 0.2M, 0.3M, 0.4M). // Hydrochloric acid (2M). // 100cm3 conical flask. // 10cm3 measuring cylinder. // Dropping pipette. // Small piece of plain paper with a large X drawn with think black pen. // Stopwatch. // Goggles. Variables: Independent - The concentration of sodium thiosulfate solution (0.1M, 0.2M, 0.3M, 0.4M). Dependent - The time taken for the cross to not be seen. Control - // Concentration and volume hydrochloric acid/ volume of sodium thiosulfate solution - to…

    • 416 Words
    • 2 Pages
    Improved Essays
  • Decent Essays

    solution, because it is the source of the Grignard reagent. Because the halide cannot be eliminated, the next best option is to minimize the amount of halide in the reaction. In this experiment, a small concentration of the halide is reacted with a high concentration of magnesium to ensure maximum contact between halides and magnesium. To do this, magnesium will be placed in the round bottom flask and then halides are slowly added. Another potential source of error is that Grignard reagents must…

    • 318 Words
    • 2 Pages
    Decent Essays
  • Decent Essays

    Experiments involving chemical reactions can be performed using simple household ingredients and products such as baking soda and vinegar. When baking soda (sodium hydrogen carbonate) reacts with ethanoic acid which is found in vinegar in a 1:1 ration, the reaction will produce three different products which are water, carbon dioxide and Sodium acetate. The reaction is: NaHCO3 + HC2H3O2 → NaC2H3O2 + H2O + CO2 In the experiment, the quantitative relationship between the two reagents which is the…

    • 503 Words
    • 3 Pages
    Decent Essays
  • Improved Essays

    Ethyl vinyl ether was used to protect –OH on glycidol based on a literature reported protocal.59 In a typical procedure, 0.675 mol glycidol and 200 mL ethyl vinyl ether were loaded in a round-bottom flask, to which 1.25 g TsOH was then added. The reaction was allowed to proceed at room temperature (RT) for 3h. The resulting mixture was then purified by washing with 100 ml saturated aqueous solution of NaHCO3 for 3 times. The organic layer obtained was dried by MgSO4. After filtration of MgSO4,…

    • 988 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Cabr2: An Ionic Compound

    • 284 Words
    • 2 Pages

    CaBr2 is an ionic compound, because the second element is a non-metal so it will form an ionic compound. The next step in naming an ionic compound, is to name each component as if they were ions. The first component is a cation so you leave the name alone. The second component is an anion, so you change the ending of bromine to "-ide" and it’s becomes bromide. The last step is to combine the names so, CaBr2 becomes Calcium bromide. The first element of the formula NBr₃ is nitrogen a nonmetal,…

    • 284 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Calorimetric Analysis Lab

    • 404 Words
    • 2 Pages

    The objective of the lab was to determine the densities of known and unknown metal solids and liquids. For the liquids, initially, an Electronic Scale was placed onto Work Bench, and it was zeroed. An empty 50 mL Graduated Cylinder was placed onto the scale, weighing 54.00 grams. In increments of 10 mL. Until the volume was 30.00 Ml, 10.00 mL of water was poured into the Graduated Cylinder. In between each increase of 10.00 mL, the total volume and mass were recorded. For the known metals, the…

    • 404 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    place. The temperature dropped about 6 degrees Celsius. The remaining solution was a filmy and diluted. The result was sodium acetate dissolved in water. This reaction was a double displacement reaction. The sodium bicarbonate reacted with the acetic acid vinegar and produced sodium acetate, water, and carbon dioxide. The carbon dioxide escaped from the solution leaving water and sodium acetate.…

    • 290 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Danika Ng CHEM 1252 L Exp 12: Thermodynamic Analysis of Chemical Equilibria INTRODUCTION The reaction being done with borax and HCl is an acid base reaction. The K constant expression of the reaction is Kc = [Na^+][B4O7^-2]. A titration is needed for this experiment because when a strong acid with a known concentration is added to a weak base, the unknown concentration of the weak base can be found, which can then find the moles of the weak base, which can then find the Kc. The first law of…

    • 1418 Words
    • 6 Pages
    Improved Essays
  • Page 1 42 43 44 45 46 47 48 49 50