Eleventh Air Force

This will determine the force that can be generated within the muscle. The greater the strength required, the greater the number of motor units (and therefore the number of muscle fibres) that contract. Stimuli too weak to produce a spike do, however, set up a local electrotonus…

Degenerate Cases of Conic Sections: Conics are formed when a plane and a double cone intersect. These intersections can form a variety of conics. These include: circles, parabolas, ellipses and hyperbolas. A circle can be formed from a cone if a plane intersects with the cone at an angle perpendicular to the base of the cone. This circle is also formed by the equation: (x-h)2+ (y-k)2=r2. This equation creates a relation because the collection of points does not pass the vertical line test. To…

defining the coaster To create a replicated graph of the formulas To determine the maximum height of the coaster as well as the longest drop, in comparison to other great coasters in the world To determine how long the passengers will be in the air, how fast the coaster is going when hitting the “splashy zone”, and where the “splashy zone” should be built To determine the maximum height a passenger can reach during this ride, and how long it takes to reach that height. The values of the…

The larger draft both causes an increase in water resistance, due to the stern having a larger surface area, and a decrease, due to this larger draft leading to a larger buoyant force, causing the boat to float higher. Deducing whether the decrease in resistance is greater than the increase can only be accurately done through experimentation. HYPOTHESIS The main hypothesis being investigated is that a more buoyant boat will have…

uniform motion in a straight line, unless is compelled to change that state by forces impressed upon it’ (McGinnis, 2013, p.88). Simpler, the law of Inertia says that if there is no external force acts on a subject, that subject will not move and it will remain in states of rest or if it was moving it will continues moving at constant speed in the straight line. Gravity based on Frank Bell (1998) is an external force that acts on all objects that are near to earth. This is the conclusion of all…

this experiment to be very interesting since I’ve seen and used pendulums a lot before, but I have never really reflected on why they oscillate. After this lab and understanding of the theory, I even know how to relate measurements to figure out the force of gravity. That is why I love physics, everything is related which makes it possible to explain phenomena seen in the everyday life.…

Fig. 3(a), 3(b), 3(c), 3(d), 3(e), 3(f), 3(g), 3(h) & 3(i). Knee arthroplasty step by step simulation. The proximal tibia is shown in fig. 2(a) where the menus for adjusting the simulation is shown. In knee arthroplasty, virtual saw is used to cut the bones in the knee from front to back. This method of cutting enable the virtual saw to penetrated tibia and then femur part of the knee. The tracker is an interface that is attached to the surgical instrument to track the position and attitude of…

Because of the static configuration is a stable one, in the absence of streaming, the density of the upper fluid be lighter than the density of the lower one. The basic unperturbed flows have uniform velocities and . The two fluids are dielectrics and having the uniform dielectric constants and . The two fluids are influenced by an oblique electric field at the interface between the two media, according to: (2.1) where…

Investigation Hooke’s Law AIM: To investigate how a spring behaves when a force of load stretches it. To figure out the relationship between the loads added to spring and the extension of spring. HYPOTHESIS: I think that as the load added to spring increases, the extension of the spring will increase. The relationship between them will be directly proportional. The formula of these two variables might be F=kx. F stands for the load added to spring, k is spring constant and x stands for…

Omar Alawad Math SL Mr. Sidat Stopping distance Introduction When driving on roads, drivers may see an obstacle ahead that requires them to apply brakes suddenly to stop. The distance covered by the car from the moment the driver applied brakes to the moment the car stops is called the stopping distance, which is also referred to as the braking distance. For a car travelling at an initial speed of , the stopping distance traveled by this car is given in the formula: The stopping…