Circumference

happened to the egg during its time in the syrup. Both the long and short circumference of the egg decreased. The long circumference before the egg was placed in syrup was 18.75 cm and after it was taken out of the syrup the long circumference was 16.9 cm, a decrease of 1.67 cm from before the syrup. The short circumference before the egg was placed in syrup was 16.15 cm and after it was take out of the syrup the short circumference was 15.1 cm, a decrease of 1.05 from before the syrup.…

variables and maximum jumping performance were recorded in Table 1. These combined results were then studied using both the regression and correlation analysis methods to predict which morphological traits (body size, mass, muscle length and muscle circumference) determined the source of variation in toad locomotor performance; with the longest jump distance of the toads as the dependent variables and the various scaling variables as the independent variables. Then the p value will be evaluated…

Vulcanizing mold To form a tread on green tire, a mold must mold and melt the rubber. The inside circumference of the circular tread face part of the mold that will be in contact where the tread of the green tire will be is a negative shape of the tread to be on that green tire to be shaped. The outside of the circular tread face is in contact with the pre-heating or curing molds inside circumference. The tread shapes on the tire is formed by ribs and/or lugs on the inside of the circular…

At 28 days after burn, pig circumference in picture B was measured and compression garments were applied at a 10 percent reduction in circumference and vest with no reduction in circumference was placed over control burns. To evaluate the magnitude of pressure exerted by the compression garments, compression garment fabric was wrapped around a load cell of a mechanical tester (TestResources, Shakopee, Minn) at a 10 percent reduction in circumference and pressure was tracked continuously…

Throughout the review Deurenberg, Deurenberg-Yap and Guricci states the use of anthropometric measurements such as skinfold thickness, waist circumference or bioelectrical impedance measurements are suitable for assessing body composition. Throughout the review it was identified that Asian populations have a higher BF% at a lower BMI measure than Caucasians. Highlighting the flaw with utilising BMI in measuring obesity especially with various ethnicities. Deurenberg, Deurenberg-Yap and Guricci…

for calculation. A paper tape measure consisted on units of centimeters and approximation to the nearest tenth could have limited the exercise. The best method was picking the closest centimeter measurement visibly possible for the diameter and circumference by wrapping the paper tape measure around the circles. The worst method would be using a ruler or meter stick. The only improvements that could be made is the use of smaller units to minimize uncertainty. Report Question: Wood The…

The vinegar was next dumped out, and the mass, short circumference, and long circumference of the egg was measured in the same manner as the measurements of the egg without vinegar. The plastic cup was cleaned and the egg was placed back in the cup. Next, the egg was submersed and fully covered in the corn syrup. The cup…

The waist circumference will be measured by finding the right ilium and marking the site at the mid-axillary plane (CDC, 2007). Using measuring tape, one will measure the circumference from the right ilium around to the left ilium. The tape will remain parallel to the floor, and it will not compress the skin. The waist-hip ratio will be calculated by taking the value from the waist circumference measurement and dividing it by the measurement of the hip circumference. The hip circumference will…

In mathematics, Eratosthenes calculated the Earth’s circumference by measuring the shadow of different points in Syene and in Alexandria. He then compared those points to find the circumference of Earth which was nearly correct. He concluded the distance between Syene to Alexandria, the angle of elevation of the Sun, and these factors came together to help him conclude the circumference of Earth (Crystal). Another contribution Eratosthenes had in mathematics was his…

recognized that the Earth was not flat that is was indeed a sphere. As that information was known they still did not know exactly how big this sphere actually was. This lead Eratosthenes to make observations and begin his process to figure out the circumference of Earth. Eratosthenes observed and compared the position of Earth’s rays as they shone upon two different locations. One of the locations was a well in Syene, Egypt, known as Aswan in today’s society. The second location was in the city…