Base station

M) * MM(CH3COOH) (0.5967M) * (65.05 g/mol) = 35.85 g/L 4) Percent Acid ((g/L)/(given density)) * 100 ((35.85 g/L)/(1005 g/L)) * 100 = 3.57% UNKNOWN ACID 1) Moles of NaOH ((Vf - Vi)/1000) * M Run #1: ((31.11 – 0.51)/1000) * 0.2116m = .006475 Run #2: ((31.35 – 0.38)/1000) * 0.2116m = .006553 2) Calc Moles of Acid because 1:1 ratio moles acid equals moles NaOH moles acid = Run 1: .006475 and Run #2: .006553 3) Molar Mass (grams used/moles acid) Run #1: (1.3160g/…

“normal” range for the human body? If not, when was the pH value outside of the normal range, and what acid/base imbalance did this pH value indicate? No, acidosis occurred at 40 seconds when the pH dropped out of “normal” range to 7.29. 6. Did the PCO2 level change during the course of this run? If so, how? Yes, the Pco2 level elevated. 7. If you observed an acid/base imbalance during this run, how would you expect the renal system to compensate for this condition? …

Part A: Background Information Acids and bases are very common in today’s society, and they can be found in most households. Acids can be found as by-products of air pollution, concrete cleaner, food flavouring and is produced by the muscle. Bases are found in most cleaning products as ammonia or sodium hydroxide, and they also treat indigestion. There are many ways that acids and bases can be defined by their chemical properties. The Bronsted-Lowry definition states that acids are proton…

Table: Summary of method validation parameter results Validation parameters Acceptance criteria Results Aminexil Minoxidil System suitability Theoretical plates should be NLT 2000 2411 11620 The tailing factor should be NMT 2.0 1.50 1.10 The RSD of five replicate injection should be NMT 2.0% 0.42 0.90 Specificity Peak of Aminexil and Minoxidil should be pure Peaks of Aminexil and Minoxidil are pure. The degradation products should be well resolved from Aminexil and Minoxidil peaks All…

Experiment 1: Standardisation of approximately 0.25 M Hydrochloric Acid Abstract The aim of the study was to standardise a solution of hydrochloric acid with an approximate concentration of 2.5 M against sodium carbonate solution. The main steps of this experiment were preparing the sodium carbonate solution, transferring the solution into a conical flask by using a pipette, adding the bromophenol blue indicator and titrating with hydrochloric acid until the first green colour appeared. The…

filter paper to remove impurities. Next, weigh 5g of coconut oil into 250ml Erlenmeyer flask. Then, add 100ml of neutralized ethanol and 2ml of phenolphthalein indicator. After that, shake until the mixture is completely dissolved. Titrate with standard base 0.1N NaOH, shake vigorously until the endpoint is reached. This is indicated by a slight pink color that persists for 30 seconds. Record the volume of the titrant used. Finally, repeat the steps more carefully in triplicate, recording each…

In this case methyl orange can be used as the indicator, pH arc being 3,1...4,4, or methyl red, pH arc being 4,4...6,2. If the pH value is bigger than the arc then the indicators will give a yellow colour to the solution, if smaller then a red colour. Total hardness is the sum of amount of Ca2+ and Mg2+ ions and is determined via complex-titration. Here is the stoichiometric point found by using different complex ions with different colours. The solution is titrated with…

Introduction The objectives in this laboratory were to explore the titrations of several known acids and bases as well as observing the mole reactions of the chemical reactions that each compound undertook. The four following acids and bases were used to predict when a set amount of reactant would reach equilibrium: Hydrochloric Acid (HCl), H2SO4 (Sulfuric Acid), NaOH (Sodium Hydroxide), and Ba(OH)2 (Barium hydroxide). An unbalanced equation of each reaction was given so the balanced equation…

DISCUSSSIONNN ————————— 1+2.) The results gathered showed that compound A had two spots, lower spot had an rf value of 0.48 and upper spot had an rf value of 0.77, this shows that compound A contained both paracetamol which has an rf value of 0.48 and caffeine which has an rf value of 0.77. Compound B had an rf value of 0.77 which is the same as caffeine therefore compound B contained caffeine. Compound C had an rf value of 0.48 which is the same as paracetamol therefore compound C contained…

NOSIPHO ZUMA A00018164 BIO 120 DR HAYATU RAJI LAB 1: PH TEST FOR VARIOUS SUBSTANCES LAB PARTNERS: AMINA SULEIMAN, SEDOO ORJE-ISHEGH DATE: 27 SEPTEMBER 2016 Abstract The primary purpose of this experiment was to determine pH levels of various substances using different methods. Two techniques were used, the pH paper indicator and the pH meter. Out of ten substances that were used, five of them were found to be acidic, namely: hydrochloric acid, coke, toothpaste, milk, and acetic acid. Sodium…