Analytical chemistry

Adsorption is the bond of particles, particles, or atoms from a gas, fluid, broken down and attached strongly to a surface. This procedure makes a film of the adsorbate on the surface of the adsorbent. This methodology varies from absorbtion, in which a liquid (the absorbate) pervades or is absorbed by a porous solid. Adsorption is a surface-based procedure while absorption includes the entire volume of the material. The term sorption envelops both methodologies, while desorption is the converse…

3.7 ANALYTICAL METHOD FOR ESTIMATION OF RALOXIFENE HYDROCHLORIDE IN HIGH PERFORMANCE LIQUID CHROMATOGRAPHY USING ACETONITRILE:0.05M AMMONIUM ACETATE (33:67) AS MOBILE PHASE 3.7.1 For Plain Drug Estimation Mode Reverse Phase HPLC Column C18 Detector UV Spectrophotometer Mobile Phase 0.05M Ammonium Acetate (pH 4): Acetonitrile Sample Raloxifene Hydrochloride in Methanol HPLC Flow Rate 1 mL/min Injection Volume 20µL Retention Time 4.6 min Λmax 289nm A stock solution of Raloxifene Hydrochloride was…

Introduction: This Laboratory experiment mainly focused on the fundamental concepts of basic Chromatography. We had a goal of learning about the properties of color additives, studying their molecular structures, and their rates of solubility when added to a strip of paper and temporarily placed into a beaker of solution. When actually performing the experiment, it is relatively easy and straightforward to do as long as you do not increase the concentration of the dye or leave the wrong side of…

2.4 Optical density Yang, Gao & Jiang (2012) investigated Study on the Relationships between the Optical Density and Ink Film Thickness Based on the Offset Overprint Trapping. D=D∞ (1-e-ml) formula represents the relationship between ink thickness and ink density. By using the formal of one-color ink thickness and ink density, the second density that corresponds the first major density is transferred to the equal thickness. Then they are added together. The experiment was carried out using 128…

HPLC column can be categorized into two types • Reverse Phase • Normal Phase 3.4.1.1. Reverse Phase Chromatography Reverse Phase system has a non-polar stationary phase over which polar solvents are used as mobile phase; it is generally used for separation of polar species. 3.4.1.2. Normal phase chromatography Normal Phase system has a polar stationary phase over which non-polar solvents are used as mobile phase; it is generally used for separation of non-polar species.[38]. A detection…

ABSTRACT Flakiness & Elongation index is one of the most prominent criteria that govern behavior and performance of aggregate in the bituminous mixes. The strength and serviceability requirements of bituminous mixture such as Stability, Flow, Voids in Total mix (VTM), Voids Filled with Bitumen and (VFB) highly depend on the physical properties of aggregates. This study conducted by observing the effect of flakiness & elongated index by adding different percentages from 0% to 50% of flaky &…

3. Results and discussion 3.1 Microstructural characterization The Roman spectrum of Cr-DLC coating was shown in Fig.1. The overlapped D peak and G peaks located at 1363cm-1 and 1564cm-1 were obtained after fitted with Gaussian curves, respectively. It’s well known that the content of the graphite crystal was closely related to the value of ID/IG [22]. And the ratio of intensity between D peak and G peak (ID/IG) of Cr-DLC coating could be calculated by the fitted curve. The value of ID/IG was…

3.3.9. Encapsulation efficiency of drug loaded NPs The encapsulation efficiency (EE) was determined by weighing the amount of unloaded drug recovered from lyophilization of the supernatant obtained after centrifugation of NPs. The drug encapsulation efficiency was calculated according to the following equation: Encapsulation efficiency (%) = (Winitial/Wfree)/Winitial *100%. Where, Winitial and Wfree are the weight of initial drug and the weight of free drug determined in the supernatant after…

“DEVELOPMENT AND VALIDATION OF STABILITY INDICATING METHOD FOR SIMULTANEOUS ESTIMATION OF CEFTRIAXONE AND TAZOBACTAM INJECTION USING RP-UPLC METHOD” 2.1 OBJECTIVE To develop and Validate Stability Indicating Method for simultaneous estimation of Ceftriaxone and Tazobactam in their combined dosage form by RP-UPLC method in various stress condition like, alkaline, acidic, oxidative, thermal and photo degradation. 2.4 METHODOLOGY 2.4.1 Chromatographic Condition Column Separation was achieved by…

RESULT AND DISCUSSION 7.1. Preformulation studies 7.1.1. Identification of pure drug by FTIR Figure7.1: Identification of Sample through FTIR Figure 7.2: FTIR Spectrum of Standard Prazosin hydrochloride (with references of B.P.- 2009) Table: 7.1 - Characteristics peaks of Prazosin hydrochloride S.No. Reference peaks (cm-1) Theoretical peak of Prazosin hydrochloride Obtained peaks (cm-1) Functional Group Stretching/ Bending 1 1750-1680 1529.92 1529.92 C=O Stretching 2. 1650-1580…