Activated carbon

In gloves industry, and for the maximum care of hands, Polyurethane-made gloves has shown the most remarkable effect than any other material. Known as one of the most versatile quality polymers, Polyurethane gloves are in huge demands at the consumer end. Well, what are the qualities that make a Polyurethane glove the best? To be honest, you can't find much stronger grip (and no sticky sensation) in a glove made by Polyurethane than any other material. The other qualities of this material are…

The role of oxysterols in human body and disease 1. Introduction Oxysterols are 27-carbon derivatives of cholesterol created by spontaneous or enzymatic oxidation (Figure 1, (Brown and Jessup, 2009)). The oxidation of cholesterol occurs either on the side chain or on the sterol core. Side chain oxidation generates, e.g., 24-hydroxycholesterol (24-HC), 25-hydroxycholesterol (25-HC) or 27-hydroxycholesterol (27-HC) while the core oxidation gives rise to ring oxysterols, mostly ring-B oxysterols,…

The zeolite XRD analysis result showed that it is 100% Clinoptilolite ─ Ca with the chemical formula Si29.04Al6.96O96.40Na1.92Ca1.57Ba0.32K0.56Mg0.72. Particle size distribution and Zeta potential for minerals have been carried out using Zeta sizer nano series (Nano ZS), Malvern, UK - Size range (nm):0.6:6000 nm and Zeta potential range (mV): (-200:200 mV) and analysis results are presented in Table 3. They The minerals were applied before planting in two separate rates ≈ 595.24 and 1190.48 5…

The polyurethane segments show high intersegment attraction such as hydrogen bonding and may be able to crystallize and form hard segments. In such polymers hard segments with Tg well above normal ambient temperature are separated by polyol soft segments, which in the mass are rubbery in nature. Hard and soft segments are arranged alternate along the polymer chain. Fig.7. Polyurethane chain configuration [32] 4.2.2. Polyurethane properties and advantages for product development…

2-methyl-2-butanol with HCl to form 2-chloro-2-methylbutane, and to understand Sn1 and Sn2 reactions, in terms of how they are different and why one is more likely to happen over the other. The OH group in 2-methl-2-butanol is attached to a tertiary Carbon, meaning the reaction should occur via Sn1, a two-step reaction, and Cl should replace the OH group, to form a tertiary halide. HCl was added to 2-methyl-2-butanol and then several extractions were done to purify the product. The percent…

Cyclohexene distillation A fraction containing primarily cyclohexene primarily cyclohexene and water is separated from raw cyclohexanone in Cyclohexene column. Raw Cyclohexanone is fed from storage tank to Cyclohexene Column via Cyclohexene heater. In Cyclohexene Heater, the feed is heated up to about 1200C with the heat carried by the bottom product from Alcohols column. The Cyclohexene column is operated at atmospheric pressure and temperatures of 850C at top and 1650C at bottom. The vapours…

In this study, we use the modified organo nanoclay as a new sorbent for separation and preconcentration trace amounts of Au(III) in aqueous solutions. Nanoclay was modified with 5-(4'-dimethylamino benzyliden)-rhodanine. Modified nanoclay was used as a solid sorbent for separation and preconcentration trace amounts of Au(III) ions. The sorption of gold ions was quantitative in pH range of 2.0 to 6.0, whereas quantitative desorption occurs instantaneously with 6.0 mL of 1.0 mol L-1 Na2S2O3. The…

The remaining acid chloride then reacts with diethylamine. Diethylamine is used in excess to neutralize the hydrogen chloride produced in the reaction. The lone pair of electrons on the nitrogen atom performs a nucleophilic attack on the carbonyl carbon, while a pair of electrons in the double bond is pushed to the oxygen atom. When an electron pair from the oxygen atom restores the double bond, the chloride ion will act as a leaving group. The nitrogen atom is deprotonated by a chloride atom,…

There is no mistaking the distinctive sound of a chainsaw, screaming as it bites through a hunk of wood or the bark of a tree. There are even chainsaws which are used to cut through concrete, brick and natural stone. Chainsaws are perhaps one of the most convenient power tools available, and can save a lot of time and effort in construction and felling. Although the origin of the chainsaw is debatable, it is determined that the first chainsaw was made around 1830 by Bernard Heine, a German…

panel. This panel stretches across a plain and gives enough power for almost all of Australia. The third one is Geothermal energy. This is when you mine into the ground and use the heat from the earth and tears it to energy. The next one is called Carbon Capture and Storage or CCS for short. This is when…