Abdullah Gül

Decent Essays
Improved Essays
Superior Essays
Great Essays
Brilliant Essays
    Page 7 of 50 - About 500 Essays
  • Decent Essays

    My Element is the Most Important Element (Argon) •Atomic mass 39.948 •Atomic Number -18 •Gas at 298 K •Density-0.0017837 grams per cubic centimeter •Third Noble gas •Chemical Symbol-Ar •It is also obtained from the air as a byproduct of the production of oxygen and nitrogen •It is the third most atmospheric gas •Argon is colorless and odorless •Argon is non reactive and has no effect on living organisms •Makes up 1% of the air around •Argon is found in the earth’s crust…

    • 397 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    The temperature at which enzyme activity is most effective is approximately at 40℃. This result was expected as this trial temperature was closest to internal body temperature, 38℃, and as catalase is present in all body organs (T. Fouad, Antioxidants). Temperature affects chemical reactions by increasing the kinetic motion of molecules and changing the rate of collisions between them. In lower temperatures, kinetic motion is decreased and there are not enough collisions between the molecules…

    • 1017 Words
    • 4 Pages
    Improved Essays
  • Superior Essays

    Boyle's Law Lab Report

    • 957 Words
    • 4 Pages

    physical law such as Boyle’s law states that P, the exerted fixed mass of gas at a constant temperature and V, the volume have a relationship. Their kind of relationship is V=f(P) relationship and it is believed that PV go together to remain constant. A water manometer is an instrument used to measure pressure. The model of kinetic theory of gases helps elaborate one of the most difficult…

    • 957 Words
    • 4 Pages
    Superior Essays
  • Improved Essays

    Importance Of Blender

    • 1316 Words
    • 6 Pages

    Introduction A blender generally consists of a plastic or glass pitcher that locks into a large base. Some of blenders are made of stainless steel. The lid of the pitcher has a seal that prevents the food or liquid from splashing out while the blender is in motion. The motor has varying speeds that turn either two or four sharp, stainless steel blades. The blades slice, crush and blend the contents of the pitcher..Blender is a must have kitchen equipment for nearly all families today, especially…

    • 1316 Words
    • 6 Pages
    Improved Essays
  • Improved Essays

    Although they may be oddly shaped, volumetric and Erlenmeyer flasks are closed-end air columns, and they abide by the conventional rules of resonance. When a rubber stopper is inserted into a flask some air is forced out of the flask, and the stopper seals the flask so the air cannot get back in. This creates an area of low pressure within the flask. When the stopper is quickly pulled out of the flask, the air rushes back into the flask because the pressure of the atmosphere is higher than the…

    • 1243 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    Heat Of Vaporization Essay

    • 1691 Words
    • 7 Pages

    Introduction Vapor pressure is the pressure of a vapor (gas) at equilibrium; equilibrium occurs when there is no net change between the amount of liquid and the amount of vapor because they balance each other. When the temperature of water becomes extremely low, as it does in this experiment, the rate of vaporization does not matter. The objective of this experiment is to determine the experimental heat of vaporization and compare it to the accepted heat of vaporization of water (40.7 kj/mol).…

    • 1691 Words
    • 7 Pages
    Improved Essays
  • Great Essays

    Purpose The purpose of this experiment was to collect three different fractions of a mixture of hexane and toluene at differing temperatures. From there, the fractions would be measured via gas chromatography to discover the percent composition of hexane and toluene in each fraction with the ultimate goal of having one fraction with mostly hexane, one with mostly toluene, and one with an even mixture of the two. Along with this, there is also the goal of redistilling one of the fractions in…

    • 1366 Words
    • 6 Pages
    Great Essays
  • Improved Essays

    sources at solid because it took time to sublime that solid and turn it into gaseous state for diffusion sources. The best efficient way is to use a gaseous diffusions sources. We got 2 candidates PH3 and POCl3. PH3 has a little quirk that escaping gas cannot be extinguished and exposure to fire may cause containers to rupture. This is a high temperature furnace which we will have a fire hazard so it would not wise to use PH¬3 in this. The best candidate will be POCl3 although it is an…

    • 793 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Sun Layers

    • 840 Words
    • 4 Pages

    cause certain temperature changes based on the latitude of the incoming lights on to the earth 's surface. Radiation from the heat in the atmosphere helps the earth circulate air and water currents to regulate temperatures. The temperatures inside gas molecules create frictions when they are charged increasing the temperature. The energy of motion also known as Kinetic energy is what atoms have within the molecules that give them the ability to power up and move quickly, thus friction that heats…

    • 840 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    In this figure (10°C trial), the two test tubes are clearly labeled with 1 and 7, test tube 1 contains the 1 cm³ liver and test tube 7 contains the 5 mL of hydrogen peroxide. these two test tubes are in a 250 mL beaker containing approximately 125 mL of tap water and ice. The thermometer was placed in test tube 7, which contains the hydrogen peroxide to measure the temperature of the solutions. The hydrogen peroxide was poured into the test tube containing to the liver and was observed.…

    • 1443 Words
    • 6 Pages
    Improved Essays
  • Page 1 4 5 6 7 8 9 10 11 50