• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/42

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

42 Cards in this Set

  • Front
  • Back

ZAE/ZFW


During periods of automated data transfer between facilities, coordination shall be effected with the receiving ARTCC before departure of an aircraft, when the departure point is ___________ from the ARTCC boundary.

5 minutes flying time

ZAE/ZFW, ZAE/ZHU


When an aircraft will cross the boundary in a climb or descent, the transferring controller shall:



-Initiate the handoff and APREQ the climb/descent.


-Effect a point out (if transitioning through additional sector)



ZAE/ZFW, ZAE/ZHU


Transponder codes may be changed w/o coordination upon initial contact, provided...

Both facilities are operating under ERAM

ZAE/ZFW, ZAE/ZHU


The time requirement for Inter/Intrafacility Automated Information Transfer (AIT) may be reduced from ___ to ___ mins when using ______.

15 mins to 5 min.


Automated Systems



ZAE/ZHU, ZAE/ZHU


When ERAM equipment is being used to effect coordination, coordinate with the reciving center before departure of an aircraft when the departure point is _______ form the boundry

less than 5 minutes flying time

ZAE/ZHU


Houston ARTCC shall ensure all aircraft landing VKS or in the Jackson terminal area cross the boundary ___________________________.


Prop/Turboprop shall be issued __________________.

At or below FL230, descending to 11,000.


A descent clearance to 7,000.



ZAE/ZHU


Aerocenter shall ensure all aircraft above 13,000 and west of J35 lander AEX or ESF.....

cross the center boundary at or below FL230 descending to 13,000

ZAE/ZHU


Aerocenter shall ensure that all aircraft above 6000 and west of ZAE sector 66/65 boundary landing at HEZ or MCB cross the center boundary.....

at or below 12,000 descending to 6000

(unless otherwise coordinated)



ZAE/GWO


When FDIO is operational, arrival info need NOT be forwarded unless...

the sequence of aircraft changes and/or the aircraft is issued an approach to a runway other than the tower specified runway-in-use.




ZAE/GWO


When FDIO is NOT operational, ARTCC shall...

forward arrival information, including specific approach issued, prior to clearance permitting flight in Class D Surface Area.

ZAE/GWO


ATCT is authorized to clear aircraft for visual approach, weather permitting, provided...

prior coordination is effected with ARTCC before clearance is issued.



ZAE/GWO


Transfer of com shall be accomplished prior to the time an aircraft reaches the final approach fix inbound or, if executing a visual approach ____.

5 miles from the airport or prior to entering the surface area (unless otherwise coordinated).

ZAE/GWO


ATCT shall inform ARTCC immediately of....

aircraft executing an unscheduled missed approach.

ZAE/GWO


ATCT shall request ___________________ from ARTCC, in the order Aircraft will depart

a release, specifying the destination airport.

ZAE/GWO


ATCT shall issue __________ utilizing data on FDIO. Aircraft may be ____________________ unless ARTCC has issued alternate routing instructions or ("FRC" is included in remarks)

clearances,


Cleared "As Filed"

ZAE/GWO


ATCT shall advise aircraft to expect req altitude ________

10 mins after departure when ARTCC releases aircraft to an interim altitude.

ZAE/GWO


ATCT shall advice ARTCC if aircraft will no depart ___________

within 3 mins of the time ARTCC issues the release. (This is NOT a clearance void time).



ZAE/GWO


ATCT shall advise IFR departures to contact ARTCC on

125.0 / 325.0

ZAE/GWO


When FDIO is not available, ARTCC assumes responsibility for

issuing full departure clearances.



ZAE/GWO


When issuing a release, ARTCC shall assign ____

an altitude to maintain and any alternate routing or other instructions as necessary.



ZAE/GWO


Special VFR Ops

2 way radio, within Class D Surface Area


at or below 2700


with ARTCC approval

ZAE/JAN


ATCT vertical limits shall be

at and below 10,000.

ZAE/JAN


ARTCC shall clear all arrivals to the destination airport via routings which

ensure transition within the confines of the Arrival Transition Areas.

ZAE/JAN


ARTCC shall clear turbojet arrivals, operating at or above 11,000 to the destination airport, to _____.


Prop aircraft shall____

cross the ATCT lateral boundary at 11,000 feet and 250 kts.




cross the lateral boundary at 7000 feet.

ZAE/JAN


Turbojets operating at and below 10,000 ft, require

individual coordination

ZAE/JAN


ARTCC shall transfer control for ___________


after a radar handoff and communications transfer have been completed.

all arrivals for decent, speed reduction, and turns to the airport.

ZAE/JAN


When notified that holding is required, ARTCC shall ________

clear subsequent arrivals to the appropriate holding fix and not transition aircraft beyond the arrival holding fix above 10,000 feet

ZAE/JAN


ATCT shall clear all departures via routings which ensure aircraft transition _____

within the confines of the Departure Transition Areas



ZAE/JAN


ATCT shall clear aircraft requesting 11,000 feet or above to _________

maintain 10,000 feet and to expect the requested altitude 10 mins after departure.

ZAE/JAN


ATCT shall clear aircraft requesting 10,000 feet or below ______

to the requested altitude.



ZAE/JAN


ATCT shall provide a minimum of _____________ between departures and/or en route aircraft entering ARTCC airspace at the same altitude.

5 nm seperation, constant or increasing

ZAE/JAN


the Transfer control point shall be

the ARTCC / ATCT boundary

ZAE/JAN


When aircraft that will cross the boundary in a climb or descent, ARTCC shall:



Initiate the handoff and APREQ climb/descent (if final alt is at or below 10,000)




Effect a point out, if required, before aircraft transitions approach airspace.



ZAE/MLU


ATCT Vertical Limits shall be

at and below 12,000 feet.

ZAE/MLU


Turbojets shall cross 31 miles east of MLU VORTAC at ____________

13,000 feet. Turbojets below 13,000 ft require individual coordination

ZAE/MLU


All other arrivals shall cross 31 miles east MLU VORTAC at _____

7000



ZAE/MLU


ATCT shall transition arrivals into terminal airspace prior to ____

the ZFW boundary (ATCT is responsible for any point out if they fail to do so)

ZAE/MLU


When notified that holding is required, ARTCC shall clear all subsequent arrivals to

the RINKY intersection at or above 13,000 feet to hold NE on V18

ZAE/MLU


When holding at RINKY

ARTCC is responsible for point out coordination with ZFW (individual coordination is required for aircraft at or below 12,000 feet.



ZAE/MLU


ATCT shall clear aircraft requesting 13,000 feet or above to _______

Maintain 12,000 feet and expect further clearance to the req alt 10 mins after departure

ZAE/MLU


ATCT shall clear aircraft requesting 12,000 ft or below to_____

the requested altitude.



ZAE/MLU


When an aircraft that will cross the boundary in a climb or descent, ARTCC shall.....

Initiate the Handoff and then APREQ the climb/descent IF their final altitude is at or below 12,000


Effect a point out, if required, before the aircraft transitions approach airspace.