• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/20

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

20 Cards in this Set

  • Front
  • Back

The shaft main function is to transmit______ from the motor to the impeller

Torque

What is the range of specific speeds for propeller pump?

9000 to 15000 RPM


Which of the following prevents the impeller of a pump from turning on the shaft?

Key

A split case pump has three impellers. Which type of multi-stage pump is this?

Two stage

Which type of pressure sensor uses a wire fastened to open a diaphragm?

Strain gauge

A vertical turbine pump would most likely have a specific speed of?

3000 RPM

Which type of valve is used to isolate a pump on a suction side?

Gate valve

Which is at the top of a stuffing box?

Packing gland

The heart of a pump is called a?

Impeller

Which is the most common cause for the surges in the distribution system?

Power failure shutting down a pump suddenly

A split case pump has two equal smaller impellers placed on either side of two equally-sized large impellers how many stages does this pump has?

2 stages

The height of a liquid can be raised vertically by a given pressure is called?

Pressure head

When fully opened, which valve will have the highest head loss?

Globe Valve

Which assembly holds the Lantern ring and packing?

Stuffing box

Which device has the same function as the packing?

Mechanical seal

The lowest pressure point in the pump is the?

Center of the impeller

Which two forces determine the behavior of electricity?

Electric and magnetic forces

Water hammer can be described as?

Acoustic waves

Which is used to stop air leakage into the casing around a pump shaft?

Seals

A pump loses its prime because the suction line has an air pocket. Which is the best solution?

Open suction piping, air bleed off valves