• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/20

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

20 Cards in this Set

  • Front
  • Back

A plat is?

A map

Water behind a dam and above a water treatment plant has energy by virtue of its elevation this difference in elevation is called elevation head or?

Potential energy

Which one of the following is a type of joint for ductile iron piping?

Push on joint

Which type of distribution system configuration has interconnected mains?

Grid system

The arrangement of pumps in parallel is typically used?

To increase flow

Which of the following is a disadvantage for using steel pipe?

It has the potential for both internal and external corrosion

Which type of distribution system configuration surrounds the distribution area with large diameter mains?

Arterial Loop system

The C valve is a measure of the pipe's wall?

Roughness that retards flow due to friction

Although velocity head can usually be ignored it should be considered when it is____to____percent of the pressure head?

1:2

The highest degree of protection for the exterior of a coated steel pipe is?

Cathodic protection

The amount of energy in feet that a pump supplies to a fluid is called?

Pump head

Which type of valve will prevent the collapse of a pipe?

Air and vacuum relief valve

As the total head on a system increases, the volume that a centrifical pump delivers is reduced?

Proportionately

Which type of joint should be used for a ductile iron piping in unstable soils?

Restrained joint

Head is measured in?

Feet

In which time of the day is the age of the water stored in the distribution system the highest?

Early morning

In general areas that require high fire flow capacity require the minimum static pressure to be?

35 psi or greater

Friction head loss can be calculated using tablets based on?

The Hazen Williams formula

The amount of liquid that can be raised vertically by a given pressure is called?

Pressure head

The correct protective methods for backflow prevention devices in order of decreasing effectiveness?

Air gap, RPZ, DCVA and VB