Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
23 Cards in this Set
- Front
- Back
In what component of the compressed air system is the air stores |
Receiver tank |
|
Air in a compressed air system must be free of what impurity’s |
Water Oil Dirt |
|
The most common compressor |
Reciprocating |
|
What controls the compressor cycle in and out pressures |
Pressure switch |
|
What should the delta tee be on a compressed air system |
15 psi |
|
At what pressure are pressure relief valves set at |
10 psi above the cut out pressure setting |
|
What is the location for the installation of pre-filters |
On the suction inlet to the compressor |
|
Name one style of aftercooler |
Plain |
|
Inter coolers are used to cool the compressor by how many degrees |
10f |
|
Diaphragm compressors need what |
Very clean air |
|
Compressors operate around what speed |
5000 |
|
Max allowable pressure drop |
5psi |
|
What two types copper can be used for med gas |
L&k |
|
When joining _______ metals flux is permitted |
Dissimilar |
|
Med gas copper tube must be a minimum grade of |
Type l |
|
Type k copper must be used for sizes over |
3” |
|
Minimum size fitting that can be concealed when using med gas |
1/2” |
|
Max pressure test for med vac system |
450kpa (60psi) |
|
Minimum test pressure for a nitrogen designed to operate at 120 psi |
180psi |
|
Each med gas system must be tested at every |
Terminal |
|
Minimum height of identification letters |
3/8 |
|
Flow test measures the |
Pressure drop |
|
Med gas to be tested at? |
150/24hrs |