• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/29

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

29 Cards in this Set

  • Front
  • Back
WHAT IS COVERED IN NAVAIR 16-30PRC149-1 CHAPTER 2?
GENERAL INFORMATION ON THE PRC-149-1 RADIO SET
WHAT IS COVERED IN NAVAIR 16-30PRC149-1 CHAPTER 3?
THEORY OF OPERATION
WHAT IS COVERED IN NAVAIR 16-30PRC149-1 CHAPTER 4?
MAINTENANCE PROCEDURES
AN/PRC-149
If the embedded GPS receiver
has acquired a position fix, then an even more
accurate location of the beacon (within ____ft) is
made available to the SAR forces.
300 ft
AN/PRC-149
121.5 MHz
IS WHAT FREQUENCY?
Civilian Emergency Frequency
AN/PRC-149
243.0 MHz
IS WHAT FREQUENCY?
Military Emergency Frequency
AN/PRC-149
282.8 MHz
IS WHAT FREQUENCY?
International Emergency Voice Transceiver
Frequency
AN/PRC-149
406.025 MHz
IS WHAT FREQUENCY?
International Emergency Message Frequency
AN/PRC-149
251.9 MHz
Training Radio Frequency.
This frequency is used only in the
AN/PRC-149-T1 and AN/PRC-149A-T1 training
radios. All other frequencies listed above are
disabled when this frequency is in use
AN/PRC-149
Frequency Stability. 121.5 MHZ
Does not vary by more than 30 Parts Per
Million (PPM) over a five-year period
including temperature, initial setting and
aging effects.
AN/PRC-149
batteries are capable of
providing operation without degradation in the
406 MHz Beacon mode for a minimum of _____hours
48 HOURS
AN/PRC-149
at minus 20 degrees Centigrade (-20°C or
-4°F) or in the Triple Frequency Beacon mode
for ____ hours
24 HOURS
AN/PRC-149
Maintenance BIT
The operator initiates this mode while the Mode Control Switch is in the GPS position. The operator starts the test by ?
depressing the volume up
and down control buttons simultaneously for
approximately 10 seconds or until the Beacon (BCN) LED display turns on
AN/PRC-149
Mode Selector
Switch Position 1 is?
GPS MODE
AN/PRC-149
Operator toggles between 243 MHz (Channel #1), 282.8 MHz (Channel
#2), and 121.5 (Channel #3) voice channels by pressing Up and Down ON ?
Volume buttons simultaneously. Operator must hold both in the pressed
position for at least 1.5 seconds for channel change to occur
AN/PRC-149
Mode Selector
Switch Position 2 is?
VOICE MODE
AN/PRC-149
GPS Position
acquisition might take____ minutes (typical),
2 MINUTES
AN/PRC-149
The GPS receiver is turned off after acquisition, and then
powered ON every ____ minutes and left powered ON until a valid position
fix is acquired again
20 MINUTES
AN/PRC-149
Mode Selector
Switch Position 3 is?
406 BCN
AN/PRC-149
Mode Selector
Switch Position 4 is
TRIPLE BCN
AN/PRC-149
MAINTENANCE BIT
2 blinks followed by 5 seconds
off indicate a ?
battery failure
AN/PRC-149
3 blinks followed by 5 seconds
off indicate a ?
RF Output Level
failure
AN/PRC-149
4 blinks followed by 5 seconds
off indicate a failure in the?
AM
receiver.
AN/PRC-149
TRUE OR FALSE
The GPS mode yields
the longest BATTERY life.
TRUE
AN/PRC-149
REPLACE BATTERIES EVERY ___YEARS
3
AN/PRC-149
PERFORM MAINT BIT EVERY?
90 DAYS
AN/PRC-149
PERFORM GPS AQUISITION CHECK EVERY?
180 DAYS
AN/PRC-149
PERFORM BATTERY HOLDER VISUAL INSPECTION EVERY?
180 DAYS
AN/PRC-149
Clean dirt, dust or salt residues from the
unit’s exterior surfaces, using a clean dry
cloth or brush and compressed air (___psig
maximum)
30 PSIG