• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/12

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

12 Cards in this Set

  • Front
  • Back

What determines whether or not a 100–hour inspection is required for an aircraft?

100–hour inspections are required only on aircraft that carry persons for hire or are used to give flight instruction for hire.

Where can you find a list of items that should be inspected on a 100–hour and an annual inspection of an aircraft engine?

In Appendix D of 14 CFR Part 43.
In what publication can a mechanic find the operating limitations for an aircraft engine?
In the Type Certificate Data Sheets for the engine.
Who is authorized to perform the powerplant inspection that is required for an annual inspection?
An A&P mechanic who holds an Inspection Authorization.
What are two types of compression checks that can be performed on an aircraft reciprocating engine?
A differential compression check and a direct compression check.
What items are checked in a hot section inspection of a turbine engine?
The combustion section is checked for cracks or distortion. The turbine wheel, the turbine case, and the exhaust section are checked for cracks, indications of overheating, and any indication of warpage, erosion, or burning.
What is the most common type of damage that is found in the hot section of a turbine engine?
Cracks that are caused by the high concentration of heat in the hot section.
Is the use of a checklist required when performing an annual or 100–hour inspection on an aircraft engine?
Yes
What inspection must be performed on an aircraft reciprocating engine if it has been operated on turbine fuel?
The inside of the cylinders must be inspected with a borescope. The oil must be changed and the filters examined, and the engine given a careful run–up and operational check.
Where can you find the model of magneto that is approved for an engine specified by the examiner?
In the TCDS for the engine
What is a Supplemental Type Certificate?
An approval issued by the FAA for a modification to a type–certificated airframe, engine or component
What paperwork is necessary for the installation of a magneto that was not approved for an engine when it was certificated, but is approved for the engine when installed according to an STC?

A form FAA 337 must be completed stating that the installation was done in accordance with the specific STC