Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
12 Cards in this Set
- Front
- Back
As wire gauge decreases, wire thickness: |
Increases |
|
Most common sizes of circular saws are: |
184mm-210mm (7 1/4 - 8 1/4) |
|
Circular saws cut on the ____ rotation: |
Upwards |
|
Blades should not project more than ____ from the material being cut: |
6mm (1/4") |
|
Circular saw kickback is often the result of: |
Backing up or cutting backwards in the material |
|
Mitre saw sizes are determined by: |
Recommended blade diameter |
|
Common detent angles of mitre saws are : |
0°, 22.5°, 45° |
|
Table saw blades are tightened: |
Against the rotation |
|
Typical size range of table saws are: |
7 1/4 - 12" |
|
Push sticks should be used when the distance between the blade and the fence is less than: |
100mm (4") |
|
Bandsaw size is designated by: |
The wheel diameter |
|
Throat measurement determines: |
Maximum width of material that can be cut |