Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
13 Cards in this Set
- Front
- Back
The purpose of the I/O section is to operate outputs based on its interpretation of inputs.
|
True |
|
State two reasons for employing optical isolation.
|
Separate line voltage from logic circuits
To reduce the effects of electrical noise. |
|
Triacs are susceptible to "dielectric-type” breakdown if the maximum peak voltage level is exceeded.
|
True |
|
Briefly describe why a hardwired emergency-stop circuit is recommended for PLC installations.Select one:
|
To protect personnel and equipment.
|
|
Briefly describe the function of an interposing relay.
|
Separate line voltage from logic circuits or accommodate current(loads) larger than the rating of an individual terminal or circuit.
|
|
I/O modules are keyed to prevent unauthorized personnel from programming in the run mode.
|
False |
|
Which of the following are not normally sources of electrical noise?
|
Indicator Lamp
Overload Heaters |
|
To ensure maximum benefit of shielding, the shield of a shielded cable must be terminated and grounded on both ends.
|
False |
|
E-Stop refers to;
|
Emergency Stop
|
|
Electromagnetic interference (EMI) can be reduced with the proper grounding of equipment.
|
True |
|
Solid-state output devices tend to;
|
fail in the shorted or on condition.
|
|
List four environmental considerations when installing PLC equipment.
|
Temperature
Dust Vibration Humidity |
|
A screwdriver should be used to change the position of DIP switches.
|
False |