Part B 1

Front 1

Which of the following is not a quality control procedure?

Back 1

D. None of the above

Front 2

An assurance report submitted every quarter of the month

Back 2

CQCA

Front 3

What is not required in conducting nuclear density test?

Back 3

Use a calibrated sand

Front 4

Which of the following is not a responsibility of a materials engineer?

Back 4

Setting sched for delivery of materials

Front 5

Where should the Contractor’s Material’s Engineer directly report?

Back 5

Contractors project engineer

Front 6

lt means to regulate:

Back 6

Control

Front 7

lt means excellence

Back 7

Quality

Front 8

Which of the following are documents is prepared by a materials engineer?

Back 8

Mat. Logbook

Front 9

compaction of an embankment is 80% which below the required compaction. As a materials engineer, what should you do?

Back 9

Use rollers with high compactive effort

Front 10

minimum testing apparatus requirements are necessary for _______ contractors.

Back 10

AOTA

Front 11

Which of the following is not the job for a materials engineer?

Back 11

Survey and measure line and grade at site

Front 12

During construction of a road project, if all the materials to be used are tested for quality, inspection is no longer required

Back 12

False

Front 13

he physical and engineering properties of soils may be improved by:

Back 13

Both a and b

Front 14

The density to which a soil can be compacted is related to

Back 14

Aota

Front 15

As a Materials Engineer, what will you do with major honey-combed area that is considered as defective work?

Back 15

Remove and replace at the expense of the contractor

Front 16

lf the strength of control specimen does not meet the requirement Materials Engineer what will be your decision?

Back 16

Remove and replace

Front 17

Specifies the minimum number of tests required for an item of work which corresponds to the quantities stated in the approved Program of Work of a project

Back 17

Quality Control program

Front 18

Prescribed in each project based on estimated quantities. The requirements specify the kind and number of test for each item of work:

Back 18

Minimum testing requirements

Front 19

It shall have at least a minimum dimension of ___ sq. m. for a district laboratory and ____ sq. m. for regional laboratory and shall contain the required testing apparatus/equipment, supplies, furnishings required by the work.

Back 19

10,20

Front 20

All samples should be submitted with the corresponding ______

Back 20

Sample card

Front 21

Refers to the process of determining the degree of compliance of delivered or constructed materials with the specification

Back 21

Materials testing

Front 22

The basis of acceptance or rejection of any construction materials?

Back 22

Mills certificate

Front 23

The monthly materials status report is submitted to DPWH on or before:

Back 23

25th day of the month

Front 24

A joint which controls the location of transverse crack and permits the slab to contract and expand with changes in temperature?

Back 24

Contraction joint

Front 25

Materials shall be obtained from approved materials sources and should be known in advance

Back 25

True

Front 26

The accomplishment of Quality control logbook is prepared by:

Back 26

Materials engineer