Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
25 Cards in this Set
- Front
- Back
What is the advantage of more equipment and expertise in the official dental laboratory?
|
B. The dentist or private laboratory technician can handle larger cases.
|
|
The ___ is used to polish or trim custom trays, provisional coverage, dentures, and indirect restorations.
|
D. dental lathe.
|
|
Which form of gypsum products is used for the creation of dies?
|
D. high-strength stone
|
|
Which of the following gypsum products has the highest powder-to- water ratio?
|
A. model plaster
|
|
A trimmed maxillary model will be ____ at the anterior portion, and the mandibular model will be ___ at the anterior portion.
|
A. pointed; rounded
|
|
When constructing ____ with a vacuum former, you will use a heavier-gauge, flexible plastic that does not require a spacer but does require an attachment for the strap.
|
D. mouth guard
|
|
The dental wax that is used for recording rims and for denture wax-ups and that is supplied in sheets is called ____wax.
|
B. baseplate
|
|
____wax is pre-formed with a thin sheet of aluminum foil between the layers.
|
D. bite registration
|
|
infection control in the dental laboratory is:
|
A. as important as it is when you are with a patient.
|
|
Safety precautions in the laboratory include all except:
|
C. this is the appropriate place for eating and drinking in the dental office.
|
|
Which are methods used to protect against biohazard contamination from impressions?
|
D. all are methods that can reduce contamination form impressions
|
|
Water should be running through a model trimmer:
|
B. at all times when trimming
|
|
The ____ is the measurement of where the teeth are positioned when the joints are aligned correctly and before the teeth actually come together.
|
D. both a and c ( bite record and centric relation)
|
|
When mixing gypsum, it is important to use the correct amount of water and powder. If additional powder is added after mixing has begun, the mix will be:
|
B. weaker
|
|
The powder-to-water ratio for high-strength stone is ___:100
|
C. 19
|
|
A custom impression tray should fit and adapt well to the model and should maintain __ mm of impression material between itself and the teeth.
|
C. 3 to 4
|
|
The purpose of ___ is to prevent a custom impression tray from sitting too deeply when taking the impression.
|
B. stops
|
|
What is a light gauge of vacuum0formed resin material used for?
|
D. Both a and b ( bleaching trays and provisional coverage)
|
|
Light-cured resin can be used to make trays for ___ impressions.
|
D. all types of impressions |
|
A dental assistant should wait ___ minutes before removing a model from an impression.
|
D. 45 to 60
|
|
When preparing impressions for pouring, it is important to:
|
B. use a gentle stream of air to remove excess moisture.
|
|
how should light-cured resin tray material be cured? |
C. for 2 minutes
|
|
Before constructing a light-cured tray, paint the model with a(n):
|
D. separator
|
|
What device holds maxillary and mandibular models in an occlusal relationship?
|
D. Articulator
|
|
true/false: When constructing custom trays it is best to remove excess material with a lab knife after it has cured. |
A. True
|