Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
29 Cards in this Set
- Front
- Back
1. One a lattice boom crawler crane, the main boom length is measured from the
|
A. Center of the boom heel pins to the center of the boom tip sheave.
|
|
2. What is the main purpose of mid point suspension pendants?
|
A. To relieve the load on the bottom when it is being raised.
|
|
3. The main purpose of a gantry or a mast on a crane is:
|
C. To increase the crane's leverage on the boom.
|
|
4. What effect does having the crawlers retracted have on a crawler crane with long boom?
|
A. Decrease structural capacity.
|
|
5. When using a mobile crane on a barge, the crane's load capacity chart shall be
|
B. Replaced by a list chart.
|
|
6. Blocking can be placed under the ends of tracks to
|
D. Increase the crane's stability when operating over front or back.
|
|
7. A crawler crane is based on _____stability of static load.
|
C. 75%
|
|
8. What quadrant produces the least amount of ground pressure on a lattice crawler?
|
A. Side
|
|
9. When a crawler is crane on a barge the list chart must be provided by the
|
D. Superintendent.
|
|
10. When operating a crawler crane, the ground pressure will always be highest over the
|
A. Corner
|
|
11. Unless working in loose soft soil, a crawler crane should always travel ___on pick and carry operations.
|
B. Towards the load
|
|
12. Why use mats of cribbing?
|
B. To reduce ground pressure.
|
|
13. Mats are usually ____to hold together.
|
A. Bolted
|
|
14. A crawler crane traveling forward is defined as traveling in the direction of
|
D. The idler
|
|
15. When disassembling or assembling booms on lattice boom cranes, it is extremely important to
|
D. Never touch any pin on any boom section located between the pendant attachment points and the crane.
|
|
16. A crane with 100 foot boom will be operating at a 41-ft. radius. The load chart shows an entry indicating 25,000 lbs. at a 40-ft. radius, followed immediately by an entry listing 21,000 lbs. a 45-ft radius. What is the crane's capacity at the 41-ft. radius?
|
A. 21,000 lbs.
|
|
17. A crane requires fourth gear to climb a one-mile hill with a 7% grade. Which of the following is a correct about driving the crane back down the hill?
|
C. Either fourth or fifth gear should be used.
|
|
18. On a lattice boom crane, the device that automatically stops the boom when it nears the maximum angle is the
|
A. Boom hoist kick-out.
|
|
19. When is it safe to handle loads under power lines?
|
D. No part of the crane of load can come closer to the power lines than regulations allow.
|
|
20. Manufacture specifications only permit a certain amount of boom to be suspended out past the connection point of the pendants during assembly or disassembly of the boom. The portion of boom is called the
|
B. Cantilever length.
|
|
21. A correct statement about installing a pin-connected lattice boom on mobile crane is that the
|
A. Boom hoist pawl should be used during the installation.
|
|
22. On a lattice boom truck crane, boom angle is measured between the centerline of the
|
C. Loaded boom and the horizontal.
|
|
23. If the angle from the jib to the ground is changed from 50 degrees to 40 degrees, the operator has
|
A. Decreased the capacity of the jib.
|
|
24. When a carrier-mounted lattice boom crane is operating on properly set outriggers, then axis is located at the
|
D. Point where the outriggers touch the ground.
|
|
25. Swinging a fixed-length boom to a different quadrant increases the possibility of tipping over backward in a crane that is working on
|
C. Tires at a short radius.
|
|
26. When leveling a crane on outriggers, check the level in one direction, then rotate the upper works
|
A. 90 degrees and recheck.
|
|
27. When making a lift with a lattice boom crawler crane, ground pressure can be reduced by lifting over the
|
D. Side.
|
|
28. Pendant spreader bars on long booms are used to prevent
|
A. Main pendants from scrubbing the boom sides.
|
|
29. What effect does having the crawlers retracted have on a crawler crane with a long boom?
|
B. Decrease in capacity.
|