Reading...
Play button
Play button
Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
23 Cards in this Set
- Front
- Back
|
A(n) ____ has an opening at each end that determines its size.
|
open-end wrench
|
|
|
Also called a speed square or magic square, the _____ is a combination protractor, try square, and framing square.
|
Rafter Angle Square
|
|
|
The _____ is the cut or channel made by a saw.
|
Kerf
|
|
|
A box-end wrench has 6 or 12 _______.
|
Points
|
|
|
The ______ is used to drive nails and to pull nails out of wood.
|
Claw Hammer
|
|
|
A(n) _____ is a tool used to remove nails.
|
Nail puller
|
|
|
A(n) ______ is a claw hammer with a slightly rounded face.
|
Bell-faced Hammer
|
|
|
A(n) _______ is a hexangon steel bar that is bent to form a right angle.
|
Allen Wrench
|
|
|
To ______ is to cut on an angle that is not a right angle.
|
Bevel
|
|
|
A(n) _______ has a closed socket that fits over the head of a bolt.
|
Box-end wrench
|
|
|
A(n) ________ is a flat, steel square commonly used in carpentry.
|
Carpenter's square
|
|
|
A(n) ______ is a metal tool with a sharpened, beveled edge used to cut and shape wood, stone, or metal.
|
Chisel
|
|
|
A(n) _______ is a tool with a claw at each end , comonly used to pull nails.
|
Cgisel Bar
|
|
|
A(n) _______ is a pin, usually round, that fits into a corresponding hole to fasten or align two pices.
|
Dowel
|
|
|
A(n) ______ is a steel used to indent metal.
|
Punch
|
|
|
To ______ is to damage the threads on a nut or bolt.
|
Strip
|
|
|
TO _______ is to smooth out threads or edges on a screw or nut.
|
Round off
|
|
|
To _______ is to heat or fuse two or more pices of metal so that the finish piece is as the original.
|
Weld
|
|
|
A(n) ________ is a square whose legs are fixed at a right angle.
|
Try Square
|
|
|
A(n) ________ is a perfectly horizontal; completely flat; a tool used to determine if an object is level.
|
Level
|
|
|
A(n) ________ is a proccess of bending, shaping, or cutting metal.
|
Peening
|
|
|
A(n) ______ is a unit of measure used to describe the amount of pressure exerter to tighten a small object.
|
Inch-pounds
|
|
|
A(n) _______ is a claw hammer with a slightly rounded, or convex, face.
|
Bell-faced Hammer
|
