Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
24 Cards in this Set
- Front
- Back
What are the before start checks? |
Circuit breakers Crew oxygen (emerg, mask, 1300psi) Smoke goggles Forward outflow valve to norm Clock Nav radios Flight instruments Static selector norm Roll spoiler pressure switches norm EFIS control panel set, test COMs and ADF set EFB set |
|
What is done after the before start checks |
Obtain ATIS Complete Aerodata Load FMS (plan, flt no, fuel) ATC clearance (capt to prompt) Review flt plan CTWO plus brief Load sheet, notoc, door closure |
|
What is done after before start checklist? |
Takeoff data, sydney, runway 16r, intersection x, weight, flaps x Speeds Vr told, v2 and vbg book |
|
When do you action the start checklkst? |
Once the APU bleeds are set or with red anti collision light no apu |
|
How to start engines if PF? |
Confirm your side clear Select start switch Press start NH 10 first flight NH 10 to 19% start feather Battery load below 0.4 before next eng start
|
|
What are the fo after start checks that the captain will call for |
Top down
AC Volts and Loads Bleed air on/norm Stby hyd pressure switces on (2900psi) Autofeather select Tank aux pumps on Flaps set Deice pressure 18 plus minus 3 |
|
24hr system checks for FO |
Manual PTU switch Autofeather test Flt idle Autofeather select Hold both switches up, amber af arm, torque >50 nh, dec 3 Release switch 1 Release switch 2 Both switches back up, do test in reverse Both switches back up, release Autofeather switch select light out, switch select light on |
|
Taxi |
Turn taxi light on at commencement of taxi
Cpt to call takeoff review.
PF hdg sel, GA, 3000 alt sel no changes
Taxi checks for FO Cabin ready light (dont press) Caution panel clear Radar on EHSI terr/wx EFB flt mode dep page
|
|
What does FO do when captain calls ready checks |
Pitots on Windshield heat norm if needed Bleeds min, off Flight controls free Do checklist |
|
Entering runway flow for FI |
Approach lights pulse Taxi off Anti Collison white |
|
What to do when pf calls after to checks |
Taxi off Windshield heat warm up norm
Do after takeoff checklist
|
|
What are climb checks that PM does |
PM
Stby Hdy Press (fo) norm Tank aux pumps off Approach lights off Logo light off Pressurisation check Bleed on/norm Climb power set 900/1050 Clb power set
Do climb checklist |
|
Holding |
Program hold PF xfer controls Or Pm program Brief the sector entry, speed and alt Call ARM or DTO hold Completion call PM to proceed or DTO waypoint |
|
Approach prep |
PF nominates flap setting and vapp
PM Ldg weight check Ldg performance check (dist ldg clb perf wat limit) Pressurisation set for dest Told card FMS program Tcas 6nm blw
Both set frequencies cdis and speed bugs
FMS verify Brief approach TCAS ynm below |
|
PF calls descent checks 10000ft |
PM Stby hyd pressures FO on Tank aux pumps on Approach lights pulse Logo on Do descent checklist |
|
What are the landing callouts |
PF Gear down Flap selections
Once final flaps done
PF calls Condition levers max after fo turns synchros off Bleeds min on or off if hot Press diff 0.t or below PF call ldg checklist |
|
Go around |
PF Select GA and advance power Call set power, power set Call flaps 1 less Call pos rate Gear up, select hdg, alt sel Accel alt after normal takeoff |
|
After landing cpt my controls |
Control lock on Bleed air on norm Clear runway approach flare off Anti coll red |
|
When captain calls after landing checks FO does? |
Flaps 0 Radar off Tank aux pumps off Yaw damper off Pitot static off Ice protection off Main bus tie tie
|
|
Single engine taxi |
After 30 sec FO bleed air 1 off When cpt calls 1 fuel off, check both stby hyd press on 1 cond conf, fuel off |
|
Approaching bay |
Taxi off and hydraulic pressure checked |
|
Once stopped |
Stby hyd press norm Start feather once called Xpdr stby After 30 secs cpt call fuel off Bleed air min off Cond fuel off Shutdown checklist once props stop |
|
Which checklists are done without prompting and when? |
Start - once cpt finishes start checks After start - after FO deice pressure and cpt EFB Ready - after FO checks flt controls Aft To straight after checks Climb - after checks and power set Descent - after checks Shutdown - after cpt anti collision off |
|
Transition |
PM Transition, 1013 set PF 1013 set, 11000feet PM checked |