Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
6 Cards in this Set
- Front
- Back
|
Imagine that you have configured the ENABLE SECRET command, followed by the ENABLE PASSWORD command, from the console. You log out of the switch and log back in at the console. Which command defines the password that you had to enter to access privileged mode? |
Enable secret |
|
|
An engineer wants to set up simple password protection with no usernames for some switches in a lab, for the purpose of keeping curious co-workers from logging into the lab switches from their desktop PCs. Which of the following commands would be a useful part of that configuration? |
A login vty mode subcommand |
|
|
Am engineer had formerly configured a Cisco 2960 switch to allow Telnet access so that the switch expected a password of mypassword from the Telnet user. The engineer then changed the configuration to support Secure Shell. Which of the following commands could have been part of the new configuration?(Choose two) |
A username name secret password global configuration command. A login local vty mode subcommand |
|
|
An engineer's desktop PC connects to a switch at the main site. A router at the main site connects to each branch office through a serial link, with one small router and switch at eachbranch. Which of the following commands must be configured on the branch office switches, in the listed configuration mode, to allow the engineer to telnet to the branch office switches?(choose three) |
The ip address command in interface configuration mode./ The IP default-gateway command in global configuration mode./ The password command in vty line configuration mode. |
|
|
a layer 2 switch configuration places all its physical courts inter VLAN 2. The IP addresses plan shows that address is 172.16.2.250 (with mask 255.255.255.0) is reserved for use but if new lands switch in the 172. 16. 2. 254 it's already configured on the router connected to that same VLAN. I switch needs to support SSH connections into the switch from any subnet and the network. Which of the following commands are part of the required configuration in this case? (Choose two) |
The IP address 172.16.2.250, 255.255.255.0. 0 command in interface VLAN 2 configuration mode./ The IP default-gateway 172.16.2.254 command in global configuration mode. |
|
|
Which of the following line subcommands tells a switch to wait until a show commands output has completed before displaying log messages on the screen? |
Logging synchronous |
