Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
74 Cards in this Set
- Front
- Back
After a hurricane warning has been issued, when do you need to re check the truck?
|
Only if you have ran a call since the AM check out.
|
|
Drafting, A preferred lift should not exceed ___________ to __________.
|
10-12ft,
|
|
A strainer should be placed at least ________ in. below the water, _________ in. above the bottom and ________in. around it clear.
|
18, 12, 24
|
|
If the priming device does not discharge water within ______ sec. stop the procedure and start troubleshooting.
|
45
|
|
Maintain _____ psi. to ______ psi. on the discharge to avoid losing the prime.
|
30 -40psi
|
|
While drafting the pump should be in the ___________ position.
|
Volume
|
|
Inspecting all valves would be considered a part of __________ maintenance.
|
Daily
|
|
An ammeter indicates two things…
|
1. the amount of current flowing into the battery
2. the amount of current flowing out of the battery |
|
Try a dry vacuum test after 5 min. you should not lose mor than _________ inches of vacuum.
|
10
|
|
Safety bars are on fire trucks and designed to _______________.
|
Deep a FF from falling out of a jump seat
|
|
A force imposed upon a fire apparatus partially filled water tanks? ______ ________
|
Liquid surge
|
|
During an evasive maneuver, the DE should __________________.
|
Always leave a way out
|
|
Ratings _______% 250
|
50
|
|
Pressure control devices must operate within _______ with an increace of 30 psi.
|
3-10 sec.
|
|
__________ operation is operating a pump at its rated capacity.
|
Parallel
|
|
Ratings ______% 100
|
150%
|
|
____________ in. is considered the min. size pipe to be used in residential areas.
|
6 in.
|
|
A hydrant with a green bonnet = _______________ gpm.
|
1000-1500 gpm
|
|
When filling a pumper during flow operations don’t let the RPM’s increase by more than ____________.
|
200 psi
|
|
Ratings 100% ______
|
150
|
|
If the pump does not discharge the water for _______ sec. the engine will return to idle.
|
8 sec.
|
|
. The RAM weighs ____ lbs.
|
17 lbs.
|
|
Old Ladders- When the cab is fully tilted it is approx. ______ft.
|
15ft. remember to turn off the headlights and AC
|
|
Old Ladders- Strobe lights, where are they located and when are they used.
|
-under the lower section of the ladder tip
-flashes any time the aerial ladder is in operation |
|
Old Ladder- Turntable, what are the dimentions.
|
96” wide x 80” long
|
|
Old ladder- What is mounted on each stablilzer cover panel?
|
Red strobe warning lights
|
|
Rescue Truck brakes must be _________ two times a shift to avoid damage to the truck.
|
Bled
|
|
Max speed for laying 5’ hose is ______.
|
15 mph
|
|
When spotting a hydrant, try not to ____________________.
|
Block the entire road
|
|
A high reading on the vacuum gage without water entering the pump indicates 2 things. ______________- _____________
|
-the lift may be two high
-the strainer could be clogged |
|
Where would you want to re fuel the Honda WH20X pump?
|
Outside the structure in a well ventilated area, no ignition sources
|
|
The majority of collisions occur during what kind of conditions?
|
Day/dry conditions
|
|
Braking distance of a heavy two-axle truck doubles when speed increases from ____ to ______ mph.
|
25 to 35 mph
|
|
What is the most common cause of skids?
|
Driver error
|
|
Why are fog nozzles not recommended for structural fire fighting?
|
Fog nozzles are not recommended, due to a low volume of water.
|
|
What is the max amount of water flowed thru a handline nozzle?
|
350 gpm
|
|
Nozzle pressure for handline nozzles?
|
50psi- but it can be raised to 65 psi when needed.
|
|
What is the simplest method of mixing foam?
|
Batch
|
|
Ladders- Fluid level checked only when ___________- and ___________ is stowed.
|
Stabilizers and aerial device
|
|
Ladders- Maintain _________ft. from electric lines.
|
10 ft.
|
|
Ladders- Maintain ______ ft. from railroad tracks.
|
25 ft.
|
|
Ladders- Correction of lateral unevenness can be achieved on grades of ____ %.
|
5% grade
|
|
Ladders- What method is used with fires involving spills around damaged or overturned transport vehicles?
|
Bank Down
|
|
What shall the driver do after exiting the station and prior to entering the street?
|
Gently apply the brakes to confirm their operation.
|
|
What is the max allowable speed through any intersection?
|
The posted legal speed limit
|
|
What is the max elevation angle for the aerial ladder?
|
75 degrees
|
|
That is the initial desired pressure to uncoil the Metro Load?
|
150 psi
|
|
What is the grade the Ladder’s brakes will hold?
|
20%
|
|
When pumping a “Sprinkler Only” building, the pump should be in the _______________ position.
|
Volume
|
|
While pumping into a ladder, what is the psi needed to flow 1000 gpm from the 2” aerial nozzle?
|
210 psi
|
|
To UNLOCK the Scott regulator, you make a ¼ turn ___________?
|
Clockwise
|
|
When spotting the truck in front of a building, where is it considered to be the safest position?
|
The corners of the building
|
|
What is always the first tactical priority at any fire incident?
|
Rescue situations
|
|
Do not exceed ______ mph when leaving the station
|
10 mph
|
|
At speeds above _______ mph an emergency vehicle may “outrun” the effective range of its audible warning devices.
|
50mph
|
|
The ________________________ is the distance a vehicle travels from the time the D/E realizes the need to stop and when the apparatus actually is stopped.
|
Total Stopping Distance
|
|
The apparatus should be at a ______ degree angle when using the front intake.
|
45 degrees
|
|
Liquids with a specific gravity less than 1 are ______________ than water.
|
Lighter, so they will float
|
|
At sea level a column of mercury is ______ inches tall.
|
29.9
|
|
Any extinguisher that uses agents other than dry chem., or dry powder, must be able to discharge ______% of its contents.
|
95%
|
|
What class of extinguishers do not receive a numerical rating?
|
Class D
|
|
Class K rated fire extinguishers are rated for their ability to fight fire in _________________________ environments.
|
Commercial Cooking Environments
|
|
Extinguishers that use water stored under pressure must have a minimum effective discharge of ______ ft. for a _______sec. period.
|
30 feet for 40 sec.
|
|
Dry Chem and Dry Powder extinguishers must have a minimum horizontal discharge range of _______ ft.
|
10 ft.
|
|
Monoammonium Phosphate is also known as ___________.
|
Purple K
|
|
In all occupancies, the maximum travel distance to an extinguisher for Class A hazards is _______ feet.
|
75 feet
|
|
In an area where Class K fires are likely, the max travel distance from the hazard to the extinguisher is reduced to ______ feet.
|
30 feet
|
|
Placement of extinguishers less than 40 lbs is ______ feet.
|
5 feet
|
|
The maximum height for extinguishers more than 40 lbs is ______ feet.
|
3 1/2 feet
|
|
The minimum clearance from the bottom of the extinguisher can’t be less than _______ inches.
|
4 inches
|
|
When using a secondary power supply, this power supply system must be able to make the detection and signaling system fully operational within ______ seconds of main power loss.
|
30 sec.
|
|
A _______ is the amount of heat required to raise the temperature of 1 pound of water 1 degree.
|
BTU
|
|
At 212 degrees water expands approximately ___________ times its original volume.
|
17,000 times
|
|
The recommended size for fire hydrant supply mains is at least _____ inches and ______ inches in high-value districts.
|
6 inches 8 inches
|