Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
32 Cards in this Set
- Front
- Back
apu is equiped with a ________ pressure system
|
high
|
|
the oil filter and filter by-pass are located
|
in the oil cluster
|
|
oil tank may be serviced by opening
|
left access door
|
|
the low oil pressure switch is located
|
on the right side of the oil tank
|
|
with aircraft on the ground what initially gets the apu rotating for start
|
dc motor
|
|
what parts of the compressor serves to convert mechanical energy into pneumatic energy
|
impeller and diffuser
|
|
what kind of energy is the pneumatic energy converted to in the combustion section
|
thermal
|
|
where is the gearbox mounted on the apu
|
front
|
|
at what percent (rpm) does combustion normally occur
|
10%
|
|
at what percent (rpm) does the starter normally cut out
|
35%
|
|
at what percent (rpm) does the ignition normally cut out
|
95%
|
|
what component protects the turbine from excessive temperatures during a bleed load
|
thermostat
|
|
apu should not droop more than ___ percent under full load
|
2
|
|
what kind of generator is on the apu
|
ac generator
|
|
what kind of stater is on the apu
|
dc starter
|
|
the apu turbine wheel rotates at _____ rpm at 100%
|
41,100 rpm
|
|
what is the apu max operating altitude
|
35k
|
|
apu consumes _____ at idle
|
250 pph
|
|
apu consumes _____ with a load
|
350 pph
|
|
what is the apu max starting range altitude
|
30k
|
|
the ram air door is opened during start up until what rpm
|
95%
|
|
the non ram door is opened at what percent
|
95%
|
|
______ reduces speed and drives accessories
|
gearbox
|
|
________ converts ambient air to pneumatic energy
|
compressor
|
|
________ converts pneumatic energy to thermal energy
|
combustor
|
|
_________ converts thermal energy to mechanical energy to drive the compressor, accessories, and load
|
turbine
|
|
oil pressure sequencing switch requires how much psi to start apu
|
2 1/2-4 psi
|
|
OIL SUB-SYSTEM
cleans, cools, and lubricates bearing areas, seals, and accessory gear case |
pressure
|
|
OIL SUB-SYSTEM
removes oil from the main engine and accessory drives and sends it back to the oil tank |
scavenge
|
|
OIL SUB-SYSTEM
pressurizes and/or depressurizes bearing area |
breather
|
|
the apu oil filter has how many microns
|
10
|
|
the oil high temp. light goes on at
|
121-124c
|