• Shuffle
    Toggle On
    Toggle Off
  • Alphabetize
    Toggle On
    Toggle Off
  • Front First
    Toggle On
    Toggle Off
  • Both Sides
    Toggle On
    Toggle Off
  • Read
    Toggle On
    Toggle Off
Reading...
Front

Card Range To Study

through

image

Play button

image

Play button

image

Progress

1/47

Click to flip

Use LEFT and RIGHT arrow keys to navigate between flashcards;

Use UP and DOWN arrow keys to flip the card;

H to show hint;

A reads text to speech;

47 Cards in this Set

  • Front
  • Back

If the oil filter becomes block a bypass valve, the filter head opens at what pressure?

18-21 PSI

If the oil collet becomes blocked, the bypass opens at what PSI?

52

What is the ratio of the planetary gear box assemblies?

27:1

What is the turning radius of the spotting dolly?

0 inches

What is the maximum loaded speed of the spotting dolly?

2 mph

What is the maximum unloaded speed of the spotting dolly?

3 mph

What is the maximum lifting capacity of the spotting dolly?

16 thousand pounds

What is the maximum drawbar pull of the spotting dolly?

14 thousand pounds

What provides power to the lifting linkage of the spotting dolly?

Auxiliary system

What provides power to drive the two driving wheels on the spotting dolly?

2 hydrostatic transmission

At what value does the accumulator store nitrogen for emergency spread of the lifting arms?

650 PSI

What type of needle valve is used on the spotting dolly?

Gate

What type of engine is incorporated into the spotting dolly?

3 cylinder Detroit diesel 3-53 series engine

What is the purpose of the additional pump on the unit?

To circulate oil from the pump assembly this replaces the standard oil pan

How are ports in the cylinder walls opened and closed?

By the position of the piston

The ports and valves are closed during which engine cycles?

Compression and combustion?

When does the exhaust valve open?

Just before fresh air enters the cylinder

What is the cycle of the fuel flow?

Supply tank, fuel strainer, primary fuel filter, fuel pump, secondary fuel filter, into the manifold

What permits pressure retention?

Orifice (restrictive fitting?

What component forces coolant through the oil cooler into the cylinder block?

The water pump

At what temperature is coolant restricted by the thermostat?

When engine temperature falls below 170 Fahrenheit

Where is the spotting dolly's transfer case located?

Between the engine flywheel and the takeoff for the hydraulic pumps

What component transmits engine power from the crankshaft to the main gear driver in the transfer case through the splined shaft?

The engine flywheel

What component transmits torque to the hydrostatic transmission, pumps and auxiliary hydraulic pump?

Transfer case

What solenoids control lifting arm movement?

L1-L6

How is the output voltage level adjusted on the alternator?

A small square cap on the rear of the alternator casing.

How does the alternator supply and control the output voltage?

With the internal solid state voltage regulator

What is the normal setting of the voltage regulator?

A level slightly above battery voltage

What relay is used for emergency stop?

K3

How many microns is the return filter rated at?

3

What component controls the speed of the lifting arm?

FD2B

What valves are used to control the left arm spread valve?

L1 and L3

What valve are used to control the right arm spread valve?

L2 and L4

What wod be the probable cause of lack of power, excessive vibrations, and hard starting?

Low compression

How do you locate misfiring injector?

The misfiring cylinder will not change the sound and operation of the engine

What is the maximum compression pressure alloted at sea level?

540 PSI

Variation in compression between cylinders should not exceed what PSI?

25 at 600 RPM

What could be the possible cause of low compression pressure?

Broken or stuck piston rings, compression pressure leaking past the cylinder head gasket.

What indicates the amount of air passing between the oil control rings and cylinder liners into the crankcase?

Crankcase pressure

What is a good indicator of excessive crankcase pressure?

A loss of engine oil through the breather tube, crankcase ventilator or dipstick hole

What would be the result of excessive exhaust back pressure?

Poor combustion and high temperature

If the lifting arms cannot be lowered, what would be the probable caused?

Contaminated hydraulic fluid

If the lifting arms cannot be spread in an emergency what would be the probable cause?

NV open or accumulator precharge is empty

If the lifting arms cannot be raised on the spotting dolly, what would be the probable cause?

MV1 open (emergency arm control)

What is the spotting dolly accumulator used for

Emergency assistance with spreading the arms

What is the tire pressure for the main tires

260 PSI

What is the tire pressure for the caster tire

205 PSI