INTRODUCTION
1.1
I had completed the project with topic “Robert control via wireless transmission” as a compulsory requirement to meet the criteria for degree of bachelor of electronics and communication engineering purposed by department of electronics and computer department of IOE, western regional campus, Lamachoor, pokhara. Mainly, project presents both hardware and software implementation for developing radio frequency based control mechanism via wireless transmission. The duration of the project was four months from September 2010 to December 2010. It was a group project with four members and was supervised by Er.Kamal chapagain. I was entirely involved in the design and implementation of hardware sections …show more content…
Ananda Kumar shah (Head of Electronics and computer Department)
Er.Kamal chapagin (Project coordinator) Sushil Thapa (Team Leader) Yuddhya Bd Aryal Bijaya Sapkota Govinda pandeya (Team member)
3
PERSONAL ENGINEERING ACTIVITY
1.6.1
My role in the project was to design, assemble and perform simulation of whole mechanical and electronic circuitry. As my project was based on wireless system, I plan to divide whole design into two section i.e. Transmission section and receiver section. Thus, the main idea of the project is to control mechanical robot interfaced with electronic connection at receiving section via wireless switching actions provided from transmission section.
In order to perform the task, I have chosen 4*4 matrix keypad. Basically, I was more familiar about how to interface keypad with ports of microcontroller that’s why I took 4*4matrix keypad then connects it with two port of microcontroller where the rows are connected to an output of port and columns are connected to the input port. So, if no key had been pressed then input port will yield 1’s for all columns since ports were connected to high Vcc.
Transmission