What Is Polyoxyethylated Castors?

Decent Essays
Molecules like cyclosporine that are non-ionisable, lipophilic and non-polar are challenging to formulate due to their low solubility and no effect of pH on solubility, and they are also solubilised in non-aqueous solutions composed entirely of organic solvents. The combination of polyoxyethylated castor oil and ethanol that are water miscible surfactants and solvents can be used to solubilise the non-polar active ingredient, cyclosporine. Therefore, the excipients are appropriate for the formulation.
Polyoxyethylated castor oil is a surface active agent that increases the solubility of drugs that are poorly soluble in water with the formation of micelles. Surfactants have an amphipathic nature, so it will form micelles when placed in water,

Related Documents

  • Improved Essays

    Ethyl vinyl ether was used to protect –OH on glycidol based on a literature reported protocal.59 In a typical procedure, 0.675 mol glycidol and 200 mL ethyl vinyl ether were loaded in a round-bottom flask, to which 1.25 g TsOH was then added. The reaction was allowed to proceed at room temperature (RT) for 3h. The resulting mixture was then purified by washing with 100 ml saturated aqueous solution of NaHCO3 for 3 times. The organic layer obtained was dried by MgSO4. After filtration of MgSO4, the excess ethyl vinyl ether was removed by rotary evaporation.…

    • 988 Words
    • 4 Pages
    Improved Essays
  • Decent Essays

    Spacer Lab Report

    • 393 Words
    • 2 Pages

    General procedure: One equivalent of spacer was coupled using 2.4 equivalents of inhibitor, 0.18 equivalents of copper sulfate, 0.36 equivalents of (+)-sodium-L-ascorbate, in a mixture of 10% H2O in DMF, 24 mL/mmol spacer. The mixture was placed in the microwave for 30 minutes at 80oC Pro6 Spacer (10) (30 mg, 0.036 mmol) and 18 (36 mg, 0.087 mmol) were dissolved in 778 µL DMF. Copper sulfate (1.62 mg, 0.006 mmol) and sodium-L- ascorbate (2.57 mg, 0.013 mmol) were dissolved in 86 µL H2O. The two solutions were combined in a microwave tube and put in the microwave for 30 minutes at 80oC. The solvent was evaporated under reduced pressure.…

    • 393 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    Minoxidil Research Paper

    • 398 Words
    • 2 Pages

    The definition of solubility is the quantity of any given substance that can be dissolved in the other, or the maximum amount of solute that can be dissolved in a solvent, which is why the solubility of Minoxidil is water. In other words, it is a substance that dissolves in another substance ranging from a solid mixed with a liquid, liquid mixed with other liquids, and gases mixed with liquids, but the only two things that can affect…

    • 398 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Goals The goal of the lab was to investigate the properties and structure of an unidentified compound that was discovered in a local landfill. The group was called in to help determine the chemical and physical properties of the compound so we can let the people of the town know so it can be taken care of properly with or without further precautions to be taken. Another goal of this project was to devise the synthesis of the unknown compound. Experimental Design In order to determine the correct identity of our unknown compound, we first started with a couple preliminary tests, which include physical state and smell.…

    • 757 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Ann Chery Latex Girdle Vest Body Shape Ann Chery’s Cinchers are one of the top waist cinchers being sold on amazon.com, made from a latex core that has a soft cotton exterior and interior lining, Ann Chery is a perfect innerwear to be worn during your workout sessions. Cinchers work by increasing the thermal energy in your body, it sticks to your body, and as a result it produces heat. Heat is often generated during your workout sessions, it increases the perspiration in your body that causes the fat to be burnt. The more you perspire, the more fat you burn.…

    • 501 Words
    • 3 Pages
    Improved Essays
  • Superior Essays

    Identifying an Unknown Compound Using Various Chemical Analysis Techniques Joshua Nash and Aquilla Young Abstract The introduction of this lab report exposes the reader to the different scientific concepts that are to be used such as melting point calculations, retention factors, and solubility in various aqueous solutions. The experimental provides the basics of using a melting point apparatus, determining solubility, and performing thin layer chromatography. In the results section the findings of my experimental are tabulated and presented in a well-organized manner so that the reader can understand how each value was calculated.…

    • 2190 Words
    • 9 Pages
    Superior Essays
  • Decent Essays

    What Is Methylparaben?

    • 91 Words
    • 1 Pages

    Methylparaben: This chemical is used to preserve food and cosmetics by acting as an anti-bacterial agent and helping extend the lifespan of products. However, researchers have suggested that methylparabens may increase the risk of breast cancer, or accelerate the growth of tumors. The chemical does this by mimicking the effects of estrogen in the human body. In addition, skin treated with creams that contain methylparaben can be damaged when exposed to the sun.…

    • 91 Words
    • 1 Pages
    Decent Essays
  • Improved Essays

    These dispersants was injected into the oil well in hope of breaking up the oil. The dispersants could break down the oil by increasing speed of decomposing, diluting it or evaporating it before reaching surface and shores that could be harmful to underwater life. Dispersants are made of solvents that mix well with the oils being released; as well surfactants and these mix well with water making it hydrophilic. This issue is that oil does not mix well with water because it is a lipid and lipids are hydrophobic; does not mix well with water. It also is made up of hydrogen bonds that increase water’s surface tension keeping the oil over the water.…

    • 131 Words
    • 1 Pages
    Improved Essays
  • Improved Essays

    This technique uses two solvents which are immiscible, for example an organic solvent such as dichloromethane can be used to extract an organic compound from an aqueous solution leaving water soluble impurities behind. A variation of this is acid - base extraction where acidic or basic compounds are extracted out of organic solutions using basic or acidic aqueous solutions. A solvent will be chosen that does not mix with the compound in which the substance of interest is currently dissolved, so that, when left undisturbed, they will form two separate layers, as with oil and water. It is also important that the compound to be extracted should have greater solubility in the solvent that has been added, and that this should not dissolve any unwanted…

    • 190 Words
    • 1 Pages
    Improved Essays
  • Great Essays

    What Is Pruitt-Igoe?

    • 1247 Words
    • 5 Pages

    Introduction The 19th and early 20th century witnessed a rapid economic growth of the United States. During that time, federal government largely supported laissez-faire policies to provide a free-market environment for large corporations. What was even more advantageous for them is that both internal and external migrations fulfilled the large requirement for cheap labor. The populations in industrial cities was never more concentrated, which created a serious problem --- housing. Low-income working class gathered in cheap tenement houses and these areas are called “the slums”[ Von Hoffman, Alexander.…

    • 1247 Words
    • 5 Pages
    Great Essays
  • Improved Essays

    In recent years polyhydroxyalkanoates (PHAs) have received considerable attention due to their diverse properties regarding thermoplastic and elastomeric nature as well as biocompatibility and biodegradability. PHAs produce by bacteria in the form of storage compound as carbon and energy source under the stress of nutrient(s) in the availability of abundant carbon source. While bacteria come under the stress of nutrient these energy storage compounds are break down in smaller fragments that degraded and consumed by bacterial cells. Polyhydroxyalkanoates (PHAs) create an ultimate carbon and energy storage material because of their lower solubility and high molecular weight, which apply slight osmotic pressure on the cell of bacterial species (Sudesh et al., 2000; Peters and Rehm, 2005; Keshavarz and Roy, 2010).…

    • 256 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Now Saad has to synthesize the compound in order to see if he will get a solid instead of another liquid. The characterization of soluble on polar solvents are that ETOH, DMF, Isopropanol, and Ethyl acetate are soluble for the polar solvents. However Chloroform, Hexane and Benzene are insoluble for polar solvents. The characterization of infrared spectrophometry there is symmetric vibration and asymmetric vibration. Symmetric vibration is pulling in two different direction and the asymmetric vibration is pulling in the same direction.…

    • 1132 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    Of the organic compounds listed- pentan-1-ol, pentan-2-ol, 2-methylpentan-2-ol, and 1-chloropropane- are slightly soluble in water. Alcohols are compounds which contain an OH group; therefore the solubility of the alcohol compounds is dependent on the strength of the intermolecular forces between water and the hydroxyl group (OH) of the alcohol compound. The molecules of water are attracted, by means of the intermolecular forces, to the OH group on pentan-1-ol, pentan-2-ol, and 2-methylpentan-2-ol, thus making the compounds slightly soluble. These forces make hydrogen bonds with the OH groups of the water as well as oxygen bonds with the OH bonds of the respective compound, thus enabling the dissolving process. 1-chloropropane is a slightly…

    • 174 Words
    • 1 Pages
    Improved Essays
  • Decent Essays

    chemicals are written from the left to the right like an example would be: Copper + oxygen= copper Oxide BaCl2 (ag) + H2SO4 (ag) = BaSO4(s)+ HCL (ag) Ba2SO4+ HCL2== BaCL + HSO4 Ni=33.1 x 100/41.9=79.0 O= 8.8 x 100/41.9=21.0 HCI- Hydrogen Chloride. The H stands for hydrogen the CL stands for Chlorine…

    • 78 Words
    • 1 Pages
    Decent Essays
  • Decent Essays

    What Is Bisphenol-A?

    • 275 Words
    • 2 Pages

    Bisphenol-A Bisphenol-A is a chemical compound used in the manufacturing of lightweight plastic and epoxy. According to www.bisphenol-a.org, it “possesses a unique balance of toughness, optical clarity, high heat resistance and excellent electrical resistance.” The chemical compound is used in the mass production of plastic bottles used for housing many cleaning solutions. In addition, it is used a sealant to line canned goods, produce sports water bottles, baby bottles, and a variety of other products used on a regular basis by a vast majority of western society.…

    • 275 Words
    • 2 Pages
    Decent Essays