Ways To Build Up A Truck Essay

Improved Essays
If you have spotted rust on the undercarriage of your truck, you need to act as soon as possible. Rust can easily spread and destroy the metal undercarriage of your truck. However, with a little knowledge about how to jack up a truck, a few simple supplies and a little time you can prevent this from happening to your vehicle.

Set Up The Truck

First, you need to park your truck on a solid, flat surface. You need to make sure that the parking brake is engaged. Then, you need to raise your truck up by placing jacks under the frame near the front tires. You should also place wood or brick blocks under the rear tires to ensure that your truck does not move. You are going to need to have easy access to the undercarriage.

Remove The Rust

Once
…show more content…
Work the stiff brush around all the rusty areas, scrubbing until the rust is gone. This could take a considerable amount of time depending on how much rust you have to remove.

After you have removed all the rust, you can use a high-pressured water hose to clean away the rust. If you choose to do this step, you will have to wait for the undercarriage to dry before proceeding.

Apply Grease And Wax Remover

Once the underside of your truck is dry again, you are going to need to apply a grease and wax remover to a rag. Then, use the rag to work off any remaining rust that is under your truck. If there is any grease or wax under your truck, you should also use the rag to remove that as well.

Apply An Anti-Rust Coating

Now that you have removed all the rust, you need to make sure that more rust does not take its place by applying an anti-rust coating to the undercarriage of your truck. You should use a paint brush to apply a coat of an anti-rust coating to your truck. Make sure that you apply it to all sides and angles of your undercarriage.

Let it dry according to the directions on the package, then get back under your truck and apply a second

Related Documents

  • Improved Essays

    In order for your fridge to keep your food, the seal around your fridge needs to be undamaged. If the seal around your fridge has become cracked or damaged in any way, you need to fix it. Follow the steps below to easily fix the door seal on your fridge. Deformed Door Seal If your door seal is just deformed, you may be able to fix it instead of replace it.…

    • 525 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    The Brukunga Mine site lies above Brukunga Township in South Australia, located 4km north of Nairre and 40km east of Adelaide, Mount Lofty Ranges. The operation of iron sulfide (pyrite and pyrrhotite) quarrying in Brukunga mine occurred between 1955 and 1972 (PIRSA, 2005). The manufacture of sulfuric acid in fertiliser industry caused the production of superphosphate fertilisers. The sponsorship from the state and federal government for the development of the mine provided employment and self-authority in local agriculture. During the operation, 5.5Mt of iron sulfide, 8Mt waste rocks and 3.5 tailings were produced.…

    • 972 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Preparing Dilutions of the Silver Nanoparticles 1. Gather all materials. 2. Put on a pair of disposable gloves. 3.…

    • 1087 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    Truck Observation Paper

    • 646 Words
    • 3 Pages

    My truck my sanctuary she means a lot to me to great care of her. I have special methods for which I follow in detail and I will girl to pristine condition. I have conducted various experiments with different products and have handpicked the best overall cleaners for my truck. For I love to have my truck looking the same as if she just had driven off the dealership lot.…

    • 646 Words
    • 3 Pages
    Improved Essays
  • Great Essays

    Parana Pine: For the Parana Pine I obtained the published value from a website since the values on the lab sheet didn’t have a values for Parana Pine. Firstly, I calculated my own Young’s Modulus Value with the result got from the tests using the equation for Young’s Modulus in Bending: E= l³/(4bd^3 ) x ( Δw)/( Δx) From using this equation, I achieved 14.44 E/GPa as a value, the published value, was: 11.37 E/GPa found on ‘The Wood Database’. The difference between my results and the Published values is: 3.07, and it was still within the range of the published value. Regarding the accuracy of the test, since this was my first time conducting this type of test, there may have been some mistakes I made that could have affected the results…

    • 1494 Words
    • 6 Pages
    Great Essays
  • Improved Essays

    Purpose: By doing this experiment, students will properly complete a redox titration well also determining the amount of hypochlorite ions present in the commercial bleach given. Introduction: Commercial Bleach and other commercial products like hair colouring agents, contain oxidizing agents. Oxidizing agents are substances that remove electrons from one or more reactants and thereby oxidizes it, whereas reducing agents are substance that give electrons to other reactant. There is some reaction that are called oxidation-reduction reaction, theses reactions are commonly seen in our day to day lives.…

    • 1086 Words
    • 5 Pages
    Improved Essays
  • Decent Essays

    Once the lug nuts are all on you can lower the jack by turning the jack handle counterclockwise until the tire is fully on the ground. After the tire is on the ground you may pull the jack out from under the car and tighten up the lug nuts as tight as you possibly can. Be sure to put the tools away and then you will be on your way ready to start driving once…

    • 479 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    Skateboard Research Paper

    • 1145 Words
    • 5 Pages

    Get into every small crack and crevice in there and spray it down. When you feel like you have cleaned every part of the bearing you could possibly clean, lay it down on a paper towel and let it dry out. Do the same exact thing for all of your bearings and place them back into your wheels when you are finished. Spin your wheels and you will notice your wheel now…

    • 1145 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    Clear Your Deck Clean

    • 530 Words
    • 3 Pages

    Follow the instructions on the packaging. Most deck cleaners contain strong chemicals, so you'll want to wear protective gloves, goggles and a face mask. Scrub In The Deck Cleaner…

    • 530 Words
    • 3 Pages
    Improved Essays
  • Decent Essays

    Essay On Chevy'ss

    • 562 Words
    • 3 Pages

    This new truck from Chevy is expected to perform well as its predecessors. Now, let us have some discussion on the changes and spec of the new Chevy’s model. The new Chevy’s model will have some desirable changes in the exterior. The exhaust system will be completely replaced with a new one.…

    • 562 Words
    • 3 Pages
    Decent Essays
  • Decent Essays

    This is the chemical structure of PTFE, the blue circles are Carbon atoms and the red circles are Fluorine atoms. Because of the particular structure, PTFE sticks to itself but not to anything else, which is why it does not stick to food. Not even geckos can stick to PTFE. Carbon-Fluorine bonds are very hard to break which is why PTFE is so strong.…

    • 116 Words
    • 1 Pages
    Decent Essays
  • Improved Essays

    Carports Research Paper

    • 555 Words
    • 3 Pages

    Individuals contribute a lot of cash to construct decorative carports, which improve the visual interest of their homes. A very much developed carport can experience its magnificence just when it is kept free of stains and earth. Diverse cleaning strategies like water cleaning, weight cleaning and steam cleaning can be received for cleaning carports. Among these cleaning strategies, weight cleaning is the most effective. Keeping in mind the end goal to rearrange the way toward cleaning, solid fixing should be possible on the carport.…

    • 555 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Then with the Rem-Rag, wipe all of the Rem-Oil off. Doing this takes all of the dirt and grease off the surface of the gun. Now grab the lower receiver and spray moderate amount of Rem-Oil into it. Use the Rem-Oil to get the easy to reach oil, and for the hard to reach places, use the toothbrush. When doing this, make sure all of the Rem-oil residue and powder is off the lower receiver.…

    • 1103 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    Qn1 Ans Decision tree analysis will involve step determination of the chemical and physical characteristics of this chemical. By knowing them, it will be very easy to determine the best control method to be employed. Firstly, the compound is corrosive and it therefore suggests that it is highly reactive and use of water and any other chemicals that can lead to an undesired chemical reaction will be ruled out. Also, the spilled chemical is producing fumes, mostly it suggests that it is either a strong acid or an alkali in addition to its corrosive nature. Use of carbon dioxide to manage the fumes/vapors will also be ruled out as the carbon dioxide is likely to react with the chemical to form dangerous substance.…

    • 956 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Abstract The paper present the investigation on the effect of temperature, time and current density on surface roughness in electropolishing process on 316L stainless steel. The cathode material under study was 316L stainless steel. The electrolyte was composed of sulfuric acid, phosphoric acid, and DI water. Full factorial design method was used.…

    • 1054 Words
    • 5 Pages
    Improved Essays