Tin Wire Research Paper

Obtain a tin paint can, and cut the bottom off with a can opener. Cut a piece of wire mesh 7.5 inches in length, and 12 inches in width. Tie the ends of the wire mesh together with a piece of wire to form a cage. Place approximately 2 inches of Roxul Insulation on the inside of the can, and set the wire cage inside the can to secure the position of the insulation. Next, bind the tin can, wire mesh, and insulation together, with foil tape, by taping from the inside to the outside two or three times. Acquire a clean, and empty soda can. Remove the pull-tab, and wrap the aluminum soda can in two layers of foil tape. With a drill and a 9/64th inch bit, create one hole 11/16th inches down the soda can, and another directly across from the first hole. …show more content…
Obtain a tin wire??? and insert the tin wire through one of the 9/64th inch hole in the paint can leaving approximately 2 inches of wire outside of can. Next, place soda can in the center of the paint can, and continue tin wire through the 11/16th inch hole in the soda can to the other 11/16th inch in the soda can. Thread the tin wire to the second 9/64th inch hole so that there is also approximately 2 inches of wire outside of can. This will result with the suspension of the soda can in the paint can. Attain a clean and empty tuna can, with the lid removed. Produce five holes 7/16th inches in diameter, 9/16th inches down from the top of the can, approximately 1 1/2 inches apart. Cut out a piece of wire mesh to fit the circumference of the tin tuna can, and mold the wire to the side of the can, creating a grill for the Cheetos to burn. Wrap the sides of the can with foil tape, without blocking the holes. Obtain a copper pipe, 11 5/8th inches in height, and 5/8th inch diameter, and tape the the pipe to the inside of the can with 5 1/2 inches sticking out the