Spongebob Chemistry Lab

Decent Essays
The purpose of this experiment was to observe and measure the effect of an unknown solute on the freezing point of a solvent and to determine the molar mass (molecular weight) of said unknown solute. In the experiment, the solvent, cyclohexane, and the unknown solute “Spongebob” were used throughout the experiment. According to theory as the unknown (nonvolatile) solute was added in the solution the vapor pressure should have decreased. When the vapor pressure decreases the freezing point will decrease along with it in the solution. In the experiment the cooling curves corresponds with that hypothesis. The freezing point of cyclohexane appeared to decrease more each time the unknown solute, “Spongebob,” was added to the solution. From the data

Related Documents

  • Improved Essays

    Alka Seltzer Experiment

    • 1056 Words
    • 5 Pages

    surface area vs rate of time Introduction: In the investigation an experiment is conducted investigate if the breaking of alka seltzer into ½, ¼ and none effect the time it dissolves. The context of the problem is the time it dissolves to have the medicine show its effect. This problem exist in real life as people take alka seltzer to relief heartburn, acid digestion and stomach aches.…

    • 1056 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    While the experiment was indeed fascinating to watch, several strengths and weaknesses existed in the research. In the beginning of the episode, Adam and Jamie went to Stanford University to look for a suitable measure for pain tolerance. They were introduced to four standard measures of pain, including extreme heat, capsaicin injection, electricity, and cold pressor test by Dr. Chu, who specialize in pain. After testing out themselves, the hosts of the show chose the cold pressor test (Rees, 2010). Thus, the measurement selected for the experiment is reliable, as it is approved by specialist.…

    • 294 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Alka Seltzer Reaction Lab

    • 545 Words
    • 3 Pages

    Observations: This experiment was divided into two parts: one part was to observe the properties of a single Alka Seltzer tablet and the second part was to find the percentage of CO2. In the first part of the experiment, the visible properties of Alka Seltzer were observed and recorded. Each Alka Seltzer contains the same three ingredients: 325 mg of Aspirin, 1000 mg of Citric Acid, and 1916 mg of Sodium Bicarbonate.…

    • 545 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Ice Melt Fastest

    • 435 Words
    • 2 Pages

    I. Science fair Question What material will make ice melt fastest? II. Background Research Did you ever wonder what makes ice melt fastest? This research paper is going to talk about how ice melt works.…

    • 435 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Dry Ice Lab

    • 289 Words
    • 2 Pages

    When dry ice is put into water they start to reacting and boiling. That reaction is called sublimation. Sublimation is when something solid goes straight to gas skipping the liquid phase. So because the water is warm it heats up the dry ice which causes it to form a gas. The gas is carbon dioxide.…

    • 289 Words
    • 2 Pages
    Improved Essays
  • Decent Essays

    Jimmy Neutron completed his KWL chart in five minutes. The only section of the chart that was completed was the first section. Jimmy is gifted and is savvy with the sciences, so he knows most of the concepts associated with General Chemistry. When I am meeting each group of students, I realize that Jimmy does not have anything written in his second section of the chart. In order for Jimmy to learn from the lab, I will conduct extra research or meet with a local college instructor, and I will provide Jimmy an advanced version of the procedure that includes greater detail and theory dissection.…

    • 191 Words
    • 1 Pages
    Decent Essays
  • Improved Essays

    However, this temperature was lower than the boiling point of acetone, the most volatile solvent possibly present in the unknown solution, pointing to a source of error in the measurement of the temperature. This could have been due to an inaccurate thermometer or to an error in placing the thermometer too high. Because the boiling point was so low, the more volatile solvent was estimated to be acetone, which has a boiling point of 56.5°C. After fraction A was collected, the temperature of the stillpot was increased and should have produced a steady increase in a plot of the temperature versus total volume distilled while fraction B (a mixture of the two components) was collected, until a second plateau at the boiling point of the less volatile component. The temperature of the stillpot needed to be increased after collecting fraction A because the liquid left in the stillpot was then composed of a higher percentage of the less volatile component, with a correspondingly higher vapor pressure, meaning that it would boil at a higher temperature.…

    • 958 Words
    • 4 Pages
    Improved Essays
  • Superior Essays

    The experiment that I will be conducting focuses on how fast one tablet of Alka seltzer can dissolve in various temperatures of water. The core of this procedure is to determine the impact that temperature has on how fast something dissolves. My hypothesis for this experiment would be that the Alka Seltzer that dissolves the fastest would be the one that was placed in the water with the highest temperature. There will be controlled and manipulated variables explained throughout the experiment. The two main things used in this experiment will be the solute and the solvent, which is Alka Seltzer and water.…

    • 1462 Words
    • 6 Pages
    Superior Essays
  • Decent Essays

    The freezing point of the cyclohexanol was about 17.7°C, and the freezing point for the unknown solute mixed into the cyclohexanol was about 6.2°C. So the approximate change in temperature of the two freezing points was about 11.5°C. With this calculated information, the found molar mass of the unknown solute B was about 278.4g/mol, which is close to given molar mass of octadecanol. Conclusion-…

    • 267 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    Ice water 1 min 9c 48.2f 282.15k Ice water 5 mins 3c 34.4f 276.15k Table 3. Mass Measurements Object Estimated Mass (g) Actual Mass (g) Actual Mass (kg) Pen/pencil 3g 4g .004kg 3 pennies 7.5g 8g .008kg 1 Quarter 8 7G .007…

    • 1009 Words
    • 5 Pages
    Improved Essays
  • Great Essays

    Gummy Bear Lab Answers

    • 2165 Words
    • 9 Pages

    Analyzing Osmosis in Gummy Bears Stephania Turyk and Anastasija Racic March 2016 Pre Lab Questions Why is it so important not to eat or drink anything in the lab? It is important not to eat or drink in the lab because the lab may be full of many contaminations that may enter your food or drink causing you to be very ill. Describe the direction of the flow of water when plant cells are placed in a hypertonic solution.…

    • 2165 Words
    • 9 Pages
    Great Essays
  • Great Essays

    The purpose of this lab is to understand the effect that dissolved impurities will have on the freezing point of a mixture and what additive will affect the the freezing point the most. The freezing point of a liquid is, the point of a substance when the temperature of the solid and the liquid is equal. When water freezes the water molecules become organized and come closer together forming crystal particles of ice. When a solute (like salt) and a solvent (like water) mix together the salt becomes an impurity and makes it so the solution can’t crystallize.…

    • 1596 Words
    • 7 Pages
    Great Essays
  • Improved Essays

    Discussion Graph 1 displays the reaction time (in minutes) of how long it took for the Alka-Seltzer tablet to completely dissolve per trial. Graph 2 displays the averages of the reaction time which showed the higher the water temperature is, the faster the reaction time would be. At 65⁰C the average time for the Alka-Seltzer to completely dissolve was 1 minute 4 seconds followed by 1 minute 20 seconds at 35⁰C and ending with the highest average at 2 minutes 1 second (1.61). The hypothesis stated that hot water temperature would make the Alka-Seltzer tablet dissolve the fastest.…

    • 711 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Intermolecular Forces

    • 1213 Words
    • 5 Pages

    INTRODUCTION The trends in physical properties of organic compounds such as boiling points and melting points can be deducted from their structures, including size (molecular weight, surface area), shape and functional groups. These factors significantly influence the strength of the intermolecular forces of attraction present; and the nature and strength of intermolecular forces determine the variations in boilingpoints of organic compounds. The boiling point of a liquid is the temperature at which its vapor pressure equals the external or atmospheric pressure. At this temperature, every molecules of the liquid acquire enough kinetic energy to overcome the intermolecular forces attracting them to the other molecules.…

    • 1213 Words
    • 5 Pages
    Improved Essays
  • Great Essays

    Investigative Question Does sugar or salt effect the freezing point and period of time that water takes to freeze? Hypothesis If you add either sugar or salt to water it will affect the freezing point of the water and will therefor take longer to freeze. Aim…

    • 1362 Words
    • 6 Pages
    Great Essays