Similarities Between Window Frames And Foils

Decent Essays
For the specific sample that you used, briefly explain why you think that the purity was not 100%.
The scraps of aluminium were not pure because of the oxidation of the surface of the container along with the coats of paint and plastic that covered the aluminum.
Name two other aluminum containing substances with which you are familiar that could be analyzed by the method used in this experiment.
Two other substance that contain aluminum that could be analyzed using this experiment are window frames and foils.
Why was it necessary in the procedure to equalize the level of liquid inside the buret and the liquid level outside the buret?
The total pressure will be read by using the barometer when both the water level in the barometer and outside

Related Documents

  • Decent Essays

    3.03 Calorimetry Lab

    • 136 Words
    • 1 Pages

    The densities of 3 different solutions, water, saltwater, and an unknown solution, were calculated using a triple beam balance and a graduated cylinder. Density was also used to discover how much zinc and copper are found in a penny. The following results were found: water’s density, 1.02 g mL-1; saltwater’s density, 1.05 g mL-1; and the unknown substance labeled two’s density, 1.04 g mL-1. The percent error was calculated for water’s density as 2%. The composition of a penny was calculated using volume by water displacement and the mass of the pennies.…

    • 136 Words
    • 1 Pages
    Decent Essays
  • Decent Essays

    This lab is designed to find the mass of copper produced when excess aluminium is reacted with 2.00g of copper salt [Copper (II) chloride decahydrate]. This will be achieved by dissolving the given amount of copper salt in distilled water and then adding in the aluminium rod. The reaction will commence as copper will begin to form on the aluminium. Calculating the percent yield is commonly used in the atom economy of a chemical reaction, which is a measure of the initial substance which becomes the useful product(s). Reactions with low efficiency which generate a great amount of waste and produce a smaller amount of the product desired have low atom economies and therefore a lower percent yield.…

    • 303 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    Differentiating Axioms “Because power corrupts, society's demands for moral authority and character increase as the importance of the position increases (John Adams). ” This statement by John Adams explains how as society’s corrupt voracity increases, the need for moral citizens like Piggy are required because they satisfy the hunger while those with the characteristics of Jack add tinder to the fire. In Golding’s book, The Lord of the Flies, British schoolboys crash land on a deserted island in the Pacific Ocean. But every foreigner, even with similar backgrounds, all have differentiating axioms.…

    • 901 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Unknown Compounds

    • 816 Words
    • 4 Pages

    Given an unknown compound in container 3, solubility tests, cation tests, anion tests, and conductivity tests can be used to determine the various properties of the unknown to then make a positive identification of the unknown. These results will not only show chemical and physical properties but also what the unknown compound might react with to form other compounds. After performing the four anion tests, a positive identification was able to be made showing that the unknown compound contained a chloride ion since a white precipitate was formed from the reaction (Table 1). The sulfate, nitrate, and carbonate tests all yielded negative results when no precipitate was formed. The reaction of the chloride anion is as follows: Cl-…

    • 816 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Four Reasons Aluminum Is One of the Best Choices for Your Metal Needs Aluminum is thought by many to be the best choice for applications involving metal. Most people think of soda cans when they think of aluminum, but there are a great many other applications that make this the preferred choice for design work by engineers. The following are only a few of the most important reasons that aluminum is so popular.…

    • 430 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Atmospheric pressure changes with the higher sea levels, decreasing the degree at which it takes water to boil. B. Sample 1- 0.02 % error Sample 2--0.008% error A.1.2g/ML B.V = M/D V= 26.15/19.3 V= 1.35 ml C. Dropping the article into the water would not be fitting, in that the volume could conceivably diminish because of the danger of fluid coming out of the barrel.…

    • 1009 Words
    • 5 Pages
    Improved Essays
  • Great Essays

    Flame Test Lab Conclusion

    • 1167 Words
    • 5 Pages

    7. Based on your results and observations would this method be practical to determine the metals in a mixture? If not, why not. Explain your answer. Based on my results and observations this method would not be practical to determine the metals in a mixture because you wouldn’t know which color is for which substance in the mixture.…

    • 1167 Words
    • 5 Pages
    Great Essays
  • Improved Essays

    Density Lab Report Essay

    • 979 Words
    • 4 Pages

    If the procedure is performed correctly, the actual density of water will equal the theoretical density of water. In the second section, the density of an aluminum sample will be measured and afterwards compared to the accepted density of aluminum and an unknown sample…

    • 979 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    In this experiment, two cations in an unknown solution were found using qualitative analysis. For Part A, the solution was to contain either silver or lead, while in Part B, the solution that was set on the side form Part A was identified to contain either calcium or barium. Part C explored a different method through the use of cation flame tests to observe colored flames from six metal chloride solutions. In Part A, the initial step was to add HCl to the unknown sample.…

    • 885 Words
    • 4 Pages
    Improved Essays
  • Superior Essays

    Gas Law Experiment

    • 1610 Words
    • 7 Pages

    For the purposes of this experiment, attention is given to Boyle 's Law and Guy-Lussac 's Law. British scientist Robert Boyle discovered the relationship between volume and pressure by using a J-tube and observing the volume that the gas…

    • 1610 Words
    • 7 Pages
    Superior Essays
  • Decent Essays

    Titanium-gold alloy harder than pure titanium? A hard silver-grey metal, Titanium is known as a chemical element of atomic number 22. Titanium is used for artificial knee and hip joint because it’s strong. But unexpected discovery by the physicists the gold standard for artificial joint can be improved with the some with the addition of some actual gold with a specific atomic structure that imparts hardness.…

    • 91 Words
    • 1 Pages
    Decent Essays
  • Great Essays

    Economies of scale Flow 1) Examples how economies of scale is helpful, 2) New technology and economies of scale. 3) Critic of economies of scale. 4) Economies of scope(From PDF) 5) Govt initiatives to achieve economies of scale. Economies of scale: The change in long run average cost as output increases is the basis of economies of scale.…

    • 2736 Words
    • 11 Pages
    Great Essays
  • Superior Essays

    Hardness Test Lab Report

    • 892 Words
    • 4 Pages

    Hardness Testing Lab 1 Moriah Ausherman E882U679 Kunza Arifa ME-251-10959 Thursday 3:30 Experiment Date- 8/31/2017 Due Date- 9/7/2017 Introduction: The purpose of this lab is to ascertain the hardness of two different materials. One material is aluminum the other will be determined through testing.…

    • 892 Words
    • 4 Pages
    Superior Essays
  • Great Essays

    composite has been investigated. For that purpose, the PMMA samples with Al2O3 additive prepared with different percentages(0,15,25,35 and 45) wt.% and different thickness. The experimental results showed that the D.C electrical conductivity increased with increasing the alumina concentrations and temperature. Also the activation energy change with increasing of additional alumina. The dielectric constant, dielectric loss, A.C electrical conductivity are changed with change the concentration of the filler and frequency of applied electrical field.…

    • 1815 Words
    • 8 Pages
    Great Essays
  • Great Essays

    Al2o3 Economic Impact

    • 1466 Words
    • 6 Pages

    In this essay, I will explain how we can benefit from bonding of atoms of certain elements in our daily life. As I will show in this essay, with the help of understanding the surface chemistry, which is the study of chemical reactions at interfaces (surfaces), different desired affects can be produced by the formation of selected elements such as making improved chemical composition of a surface. Surface chemistry today can be applied to solve various issues and problems including fighting corrosion, making glucose biosensor to monitor the sugar levels for diabetic patients, making lubricants to help reduce the frictions between two substances, making semiconductors that are used in many modern electronic devices such as computers and cell…

    • 1466 Words
    • 6 Pages
    Great Essays