Petri Dish Lab Report

Improved Essays
Two petri dishes containing a medium were obtained. The petri dishes were labeled and divided into four quadrants. The control plate, labeled control, contained regular growth medium and the experimental plate, labeled NH4NO3, contained 1% ammonium nitrate. Using a sterile pipette, three drops of the C-Fern spore culture were added into each petri dish and spread across the surface of the medium with a sterile, disposable inoculating loop. After the spores were observed under a dissecting microscope, the petri dishes were placed under the plant lights, where they were stored for five weeks. During the fifth week, the number of spores germinated was counted and recorded after viewing each petri dish under a microscope. The class data from lab

Related Documents

  • Improved Essays

    Pt1420 Unit 4 Lab Report

    • 1693 Words
    • 7 Pages

    * For the first one this is what I would do... okay so we have the original equation for the first one & based off that this is what I would do... I would discover f ( 2 ) by inserting x equals 2. f…

    • 1693 Words
    • 7 Pages
    Improved Essays
  • Superior Essays

    Distance from gene to centromere • Control- Sordaria Fimicola culture, slide, time, strains being crossed, area viewed, temperature, microscope used, age of sample Data Under the microscope, we saw brown asci surrounded by and filled with small, almond shaped spores in two similar shades, gray-purple and black-purple. Some of the spores appeared darker because their color was distorted by the brown color of the remaining…

    • 1551 Words
    • 7 Pages
    Superior Essays
  • Improved Essays

    Nt1310 Lab Report

    • 1745 Words
    • 7 Pages

    The Channel EQ and the Compressor are perhaps the most used Plugins on your Channel Strips. To add them to a Channel Strip is as simple as clicking on the Plugin Button ➊ and select them from the Plugin Menu ➋. However, there are faster ways to do that. ➡ Attention There are two Channel Strip Components that are visible by default (you can toggle them in the Channel Strip Component Window ➌ (open as popup menu or Popover window): Channel Strip Components ➌ • Gain Reduction Meter ➍: When the Compressor Plugin (or the Limiter, or Adaptive Limiter) is loaded on the Channel Strip, then this purple meter displays the amount of gain reduction. • EQ Thumbnail ➎: This area displays the frequency curve of the Channel EQ Plugin.…

    • 1745 Words
    • 7 Pages
    Improved Essays
  • Improved Essays

    Nt1310 Unit 12 Lab Report

    • 177 Words
    • 1 Pages

    Procedure 1- Set up the DAQ to output port 2 to send a binary data. 2- Run the LabView in continues mode, change the numerical input on the control panel, and observe the LEDs on the terminal block between (PB0- PB7).…

    • 177 Words
    • 1 Pages
    Improved Essays
  • Decent Essays

    Pt1420 Unit 6 Lab Report

    • 136 Words
    • 1 Pages

    A sketch or view of test setup and arrangement of gauges and loading protocol should be presented. It is not clear the location of gauge 1 and 2 listed in Figure 11. Why the results of two mentioned gauges are presented in comparison with analytical one? Are the both of them comparable? Why the results of two gauges are different?…

    • 136 Words
    • 1 Pages
    Decent Essays
  • Improved Essays

    Domestos Lab Report

    • 818 Words
    • 4 Pages

    The purpose of this report is determine whether the natural product; vinegar, is better than man made chemical products; Domestos and Pine O clean. This will be determined by the results of the experiment which product has created the largest zone of inhibition. To determine which of the three disinfectants are the most effective depend the one with the largest inhibition zone. Bacteria are tiny microorganisms that colonise together and are found in every living organism.…

    • 818 Words
    • 4 Pages
    Improved Essays
  • Decent Essays

    Wv5 Unit 5 Lab Report

    • 252 Words
    • 2 Pages

    The valves were set up so that the water would flow from Tank 2, through the ½” nominal diameter, type L copper pipe, through the needle valve WV5 (Appendix A), and back to Tank 2. WV5 was initially closed. The Honeywell STD 924 DP meter’s pressure tap lines were placed at PT 1, just before the P-1 Sterlings Fluid System Peerless Pump PE50B1, and PT 10, just after WV5. A Fluke 179 multimeter was attached to the DP electrical box. The multimeter was set to read electrical signal in the form of DC current with units of mA.…

    • 252 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    E. Coli Lab Report

    • 494 Words
    • 2 Pages

    The hypothesis tested was that if the incubation temperature of Escherichia coli is lower or higher than 37°C, the amount of bacterial growth will decrease. The results of the plates which experienced growth without contamination supported the hypothesis. The plate incubated at 4°C was contaminated, and therefore the E. coli colonies present on the plate, if any, could not be counted. The plate incubated at 23°C had no growth, which supported the hypothesis that if E. coli was incubated at temperatures higher or lower than 37°C, no growth would be present. The bacterium did not begin to have any uncontaminated growth until the incubation temperature was set to 37°C, which had 71 noticeable E. coli colonies.…

    • 494 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    The fourth step was for the colonies to be gram stained and the procedure was performed as followed in the laboratory manual (1). The gram staining showed a result of Gram-negative rods. To interpret which biochemical tests to perform, the Gram positive and negative chart handed out by the professor was referred to. The different tests were preformed to…

    • 1057 Words
    • 5 Pages
    Improved Essays
  • Superior Essays

    Unknown Microorganism

    • 1849 Words
    • 8 Pages

    For the culture media tests, synthetic medium, tryptic soy broth (TSB), SF medium, MacConkey agar, and nutrient agar and glucose were used to detect if specific organisms would grow on each media. Synthetic medium is defined media and the contents are exactly known. A positive result would be if one could see cells within the medium after incubation, and means that the the media provides all the nutrients the organism needs to grow. A negative result would be a clear medium without physical signs of growth, and means that the organism requires supplementation. TSB is a complex medium in which the exact chemical composition is unknown.…

    • 1849 Words
    • 8 Pages
    Superior Essays
  • Great Essays

    Unknown Bacteria Essay

    • 1069 Words
    • 5 Pages

    Cell and colony morphology have been very useful taxonomic features in the differentiation and classification of microorganisms (2). Microscopic examination allows microorganisms to be viewed under magnification, to allow cell morphology to be determined. The most common cell shapes are…

    • 1069 Words
    • 5 Pages
    Great Essays
  • Improved Essays

    Microbiology Lab Report

    • 840 Words
    • 4 Pages

    To determine the unknown’s morphology is the first step in narrowing down possible organisms. A MacConkey and Mannitol Salt Agar tests were conducted on the organism and revealed the following. No growth on the MacConkey plate resulting in a gram positive bacteria and the Mannitol Salt Agar result showed it could be Staphylococcus or Micrococcus. (1) A gram stain test was used in determining the shape, size and arrangement of the unknown bacteria (1). The unknown organism is heat fixed onto the slide, in order for the organism to be stained.…

    • 840 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    Pglo Lab Report

    • 1131 Words
    • 5 Pages

    Purpose: The overall goal of this lab was to perform a procedure on E. Coli which involved transferring genes that encoded for the green fluorescent protein into E. Coli to see if the transferred genes would make a difference on the growth and whether or not the bacteria would glow under UV light. Hypothesis: If the bacteria with the pGLO plasmid was grown on a plate containing LB and ampicillin then the bacteria will grow but not glow under UV light. If the bacteria with the pGLO plasmid was grown on a plate containing LB, ampicillin, and arabinose then it will be able to grow and glow under UV light. If the bacteria without pGLO plasmid was grown on a plate containing LB and ampicillin then it will not be able to grow or glow under UV light.…

    • 1131 Words
    • 5 Pages
    Improved Essays
  • Improved Essays

    Blue Beaker Lab Report

    • 685 Words
    • 3 Pages

    Catherine Delker Honors Chemistry – Yellow Blue Beaker Experiment Lab Report 8/20/15 Blue Bottle Experiment Problem: The purpose of this lab was to determine the oxidation rate of the Methylene blue solution when tested with varying amounts of solution. Background:…

    • 685 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Introduction: Genetic transformation is used in many areas of biotechnology. In medicine, diseases caused by defective genes are beginning to be treated by gene therapy by genetically transforming a sick person’s cells with healthy copies of the defective gene that causes their disease. Genes can be cut out of human, animal, or plant DNA and placed inside bacteria, which could treat a person with that disease. For example, a healthy person’s gene for the insulin can be put into bacteria. Under the right conditions, the bacteria can make useable human insulin.…

    • 686 Words
    • 3 Pages
    Improved Essays