Magnesium Ribbon Lab Report

Improved Essays
Procedure A : In Procedure A we placed a piece of a magnesium ribbon into a test tube and added drops of hydrochloric acid to it.

When the hydrochloric acid was added to the magnesium ribbon in the test tube it immediately caused a chemical reaction. The acid began to bubble and pushed the ribbon to the top of the acid. While observing the reaction we could feel heat coming off the test tube meaning that it was a chemical change because it caused energy. After a couple of seconds the magnesium ribbon had fully dissolved into the hydrochloric acid and some sort of gas came out of the test tube.

Related Documents

  • Improved Essays

    Elizabeth Lee James Poland CHEM 104A 21 September 2014 Discussion and Conclusion of Experiment #4: States of Matter Sleuth Discussion The results of this experiment enabled the experimenter to determine the identity of an unknown salt (#3) using ion-exchange chromatography by analyzing the inorganic salts of the unknown salt, which can be examined by acid-base titration using ion-exchange resin. The stationary phase is made up of acid groups which will attach to the resin, which is then rinsed down the column with water. The mobile phase contains the inorganic salt dissolved in a solvent, which is then added to the column. As it goes down the column, an exchange of H+ ions and cations occur. The solution collected at the bottom of the column contains the acid form of the inorganic salt.…

    • 539 Words
    • 3 Pages
    Improved Essays
  • Improved Essays

    Light the Bunsen Burner and then use the tongs to put the magnesium ribbon into the flame. Do not look at the ignited flame because the intensity of the flame could burn the retina in the eyes. Then you pull the magnesium ribbon out of the flame. 2 Mg(s) + O2(g) = 2MgO(s)…

    • 793 Words
    • 4 Pages
    Improved Essays
  • Superior Essays

    Gram Negative Unknown Lab Report #20 BIOL 3444-008 Giang Nguyen TA: Malini Kotak 11/05/2014 Abstract The experiment is conducted in order to identify a randomly given unknown gram-negative microorganism. By comparative analysis of biochemical tests that were performed throughout the semester to find out its characteristics and determine the identification of bacterium out of four potential unknown was given. To figure out the characteristics, T-streak was performed to isolate the sample from broth to a Tryptic Soy Agar plate, along with an additional slant in case something wrong with the original plate that can possibly affect the result.…

    • 1514 Words
    • 7 Pages
    Superior Essays
  • Decent Essays

    solution, because it is the source of the Grignard reagent. Because the halide cannot be eliminated, the next best option is to minimize the amount of halide in the reaction. In this experiment, a small concentration of the halide is reacted with a high concentration of magnesium to ensure maximum contact between halides and magnesium. To do this, magnesium will be placed in the round bottom flask and then halides are slowly added. Another potential source of error is that Grignard reagents must be placed far away from water sources.…

    • 318 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    6.03 Ph Lab

    • 2243 Words
    • 9 Pages

    The purpose of this experiment is to determine the pH of known substances by use of a pH color indicator of red cabbage and the use of a pH meter. As well as, to observe the pH changes in a substance by adding in more basic of acidic to buffered solutions and unbuffered solutions. This experiment will also will show how to calculate H3O+, OH- and pH by use of known values. In order to do this lab, there are a few key components one needs to know and understand first.…

    • 2243 Words
    • 9 Pages
    Improved Essays
  • Improved Essays

    Alka Seltzer Lab

    • 250 Words
    • 1 Pages

    The purpose of this lab was to understand the Law of Conservation of Mass and how it works, using half of an Alka-Seltzer tablet, concealed in a water to fill the container, while a balloon sealed the top to keep it a closed system. The hypothesis was, if the Alka-Seltzer chemical reaction is a closed system, then the mass of the products will equal the reactants. The data did not support the hypothesis because the products were almost always a different mass to the reactants but only the last trial revealed that the mass of the reactants was equal to the products. Usually, the trials indicated a loss of mass until the third trial was done, which was a success. Since the experiment was a closed system, matter could not leave or enter.…

    • 250 Words
    • 1 Pages
    Improved Essays
  • Improved Essays

    Lab Report Catalase

    • 786 Words
    • 4 Pages

    For this catalase experiment it was decided that the group was to keep the concentration of catalase and hydrogen peroxide the same and only change the level of pH buffer throughout the experiments conducted. This was done to observe the effect different levels of pH buffers have on the breakdown of hydrogen peroxide and the volume of oxygen released. The results from the majority of experiments conducted reflect that though they are in consensus with the hypothesis that the volume of oxygen will be at its highest at pH 7, it was found that the temperature of hydrogen peroxide and the batch of catalase may have varied which affected the precision of the results throughout the weeks of experimentation (see graphs in results section). Experiment 2 indicates that there were substantial errors and inaccuracies which occurred.…

    • 786 Words
    • 4 Pages
    Improved Essays
  • Superior Essays

    Displacement Reactions: single and double displacements Introduction There are two types of displacement reactions: One type is called the single displacement reaction, the other is called the double displacement reaction. During a single displacement reaction, an element substitutes another element in a compound, creating a new element and a new compound as products. (Ritter, Plumb, Jenkins, van Kessel, & A. Hirsch, 2001) In most single displacement reactions, either a metal replaces another metal, or a non-metal replaces another non-metal. The more reactive element takes the place of the less reactive element in the compound, the reaction will not occur otherwise.…

    • 1182 Words
    • 5 Pages
    Superior Essays
  • Improved Essays

    Determination of the Concentration of Acid in Gastric Juice Introduction Titration is a method where a solution of known concentration is used to find the concentration of an unknown solution. A standard solution is a solution of precisely known concentration. The aim of this experiment was to go over the use of pipettes, burettes, titrations and also to reinforce the concept of molarity.…

    • 814 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    In this experiment, two cations in an unknown solution were found using qualitative analysis. For Part A, the solution was to contain either silver or lead, while in Part B, the solution that was set on the side form Part A was identified to contain either calcium or barium. Part C explored a different method through the use of cation flame tests to observe colored flames from six metal chloride solutions. In Part A, the initial step was to add HCl to the unknown sample.…

    • 885 Words
    • 4 Pages
    Improved Essays
  • Great Essays

    Quantification of Iron in Whole Grain Cereal Jacob Rickman and Yasmeen Coan Submitted to: Curt Zanelotti CHEM 1045, Experiment No. 12, April 15, 2016 LABORATORY WRITTEN REPORT Honor Code Signature: _________________ Objective In this experiment, we gained an understanding of the relationship between chemistry and food products while developing and enhancing good lab techniques. We applied dilution concepts to carry out the experiment.…

    • 1251 Words
    • 6 Pages
    Great Essays
  • Great Essays

    Molar Volume of a Gas Lab The purpose of the lab was to do an experiment to determine the molar volume of hydrogen gas at standard temperature and pressure, or STP. To start the experiment, a beaker was filled with water and then a cage was created with a copper wire. A piece of magnesium was cut and placed inside the cage in order to keep the reaction going until all of the magnesium reacted with the hydrochloric acid. The eudiometer tube was filled with 15 mL of hydrochloric acid and water and then plugged with a one-hole rubber stopper that held the cage in place, ensuring that the magnesium would react with the excess hydrochloric acid.…

    • 1741 Words
    • 7 Pages
    Great Essays
  • Improved Essays

    Observations and Results: There were a variety of physical observations that could be made as the experiment progressed. Initially after the addition of the sulfuric acid from the Repipet, the solution was a slight yellow…

    • 1346 Words
    • 6 Pages
    Improved Essays
  • Improved Essays

    Magnesium Oxide Lab Report

    • 1193 Words
    • 5 Pages

    Our error could have been led back to the flame of our bunsen burner not being consistent due to the fact that it was put out by the wind coming into the room, meaning our crucible was not directly under heat at all time. It also could have been due to our mistake of not cleaning the magnesium ribbon from oxides at the beginning. Therefore, it might’ve not been luster enough for the experiment to…

    • 1193 Words
    • 5 Pages
    Improved Essays
  • Great Essays

    Unknown Salt Lab Report

    • 1742 Words
    • 7 Pages

    During the entire lab, the main purpose was to, Identify the given unknown salt through a variety of experiments which yielded valuable quantitative and qualitative data. Before any experiments were carried out, multiple properties were compiled in order to have a source to compare the found results with. Beginning with the first experiment to determine if the unknown salt was hygroscopic, efflorescent, deliquescent or none of the above properties. This test was done through weighing an amount of the salt and reweighing after 15 minutes which would show if the salt had one of the above properties (either by gaining mass from the air, losing mass to the air, turning to solution) or none of the properties. Furthermore, tests were done to identify…

    • 1742 Words
    • 7 Pages
    Great Essays