+ Lb Lab Report

Decent Essays
Conclusion My initial hypothesis was that the -LB plate will have no growth, the -LB/AMP with have a lawn of bacteria, the +LB/AMP plate would have a number of small colonies filling about half of the plate and the +LB/AMP/ARA plate would be filled with with colonies but not enough to create a lawn (approximately half of the +LB/AMP). Based on the data solely from our group my hypothesis is somewhat supported. The -LB plate had no growth, as predicted. The -LB/AMP plate had a lawn of bacteria making the plate translucent. The +LB/AMP plate barely had any colonies, after counting we got approximately thirteen colonies which was much less than I had predicted. The +LB/AMP/ARA plate met my prediction of filling the whole plate but it was much more than half the +LB/AMP plate. In any experiment there is always a chance of error, this lab was no exception. It is very likely that when we were transferring the Luria Broth and the plate there may have been a varied amount of the luria broth in in each plate because it was very hard to hit the prescribed mark and make sure there was no residue left over in the pipet. Also unwanted microbes could enter the plate if they were open for too long. If I were to do this lab a second time in order to get more successful and accurate …show more content…
that protein synthesis is the way the genetic code puts together proteins in the cell and gene expression is the characteristic or effect attributed to a particular gene also by completing this lab the concept of an inducible operon system became for clear. In the case of this lab adding an inducer, in this case the arabinose, would cause the repressor to become inactive, which allows the RNA Polymerase to enter and make the green fluorescent protein (GFP) through the process of protein

Related Documents

  • Decent Essays

    Pt1420 Unit 6 Lab

    • 109 Words
    • 1 Pages

    One thing that definitely went wrong in the lab was that we had to round about two of our measurements and the reason being was that they were exact. To exemplify, when we were reading the volume for the finishing measurement of the base for trial three, we got exactly 45.00 mL. The only problem was that, we had didn’t really have the two significant decimal numbers. Hence, we rounded our volume to 45.01 mL. Also, we got exactly 23.00 mL for our finishing volume of the acid for trial three. Therefore, once again we rounded it to 23.02mL in order to get at least two significant decimal numbers.…

    • 109 Words
    • 1 Pages
    Decent Essays
  • Decent Essays

    Wv5 Unit 5 Lab Report

    • 252 Words
    • 2 Pages

    The valves were set up so that the water would flow from Tank 2, through the ½” nominal diameter, type L copper pipe, through the needle valve WV5 (Appendix A), and back to Tank 2. WV5 was initially closed. The Honeywell STD 924 DP meter’s pressure tap lines were placed at PT 1, just before the P-1 Sterlings Fluid System Peerless Pump PE50B1, and PT 10, just after WV5. A Fluke 179 multimeter was attached to the DP electrical box. The multimeter was set to read electrical signal in the form of DC current with units of mA.…

    • 252 Words
    • 2 Pages
    Decent Essays
  • Great Essays

    M. Luteus Lab Report

    • 715 Words
    • 3 Pages

    Several tests were accomplished technically and carefully to identify the unknown # 230 to be M.luteus bacteria. Most of the observed results do match the expected ones, except two tests. The observed results for glucose fermentation and oxidase test did not match the expected results. The expected result for fermentation of glucose test was negative while the observed result was positive.…

    • 715 Words
    • 3 Pages
    Great Essays
  • Improved Essays

    Unit 4 Test Lab Report

    • 581 Words
    • 3 Pages

    Results In the lab, 478 trials were conducted using a total of 956 crickets. The 478 pairs resulted in 264 wins for the resident cricket and 214 wins for the intruding crickets. These results produced a chi squared value of 5.230. The p-value calculated from this lab was .022.…

    • 581 Words
    • 3 Pages
    Improved Essays
  • Decent Essays

    The purpose of this lab was to measure the exact mass of a primary standard, to find the precise number of moles of potassium hydrogen phthalate (KHP) included to the reaction, the molarity of NaOH at the equivalence point, the molarity of an aqueous solution containing NaOH, as well as how much volume was needed to get to the equivalence point specified by the end point. The first step in this experiment was to prepare a solution of NaOH with an unknown molar concentration. Then, determine the concentration of the NaOH by titration, using KHP which has a known concentration and is considered a primary standard. during this experiment, Phenolphthalein was found to be the best indicator for the titration of vinegar with NaOH, due to it having…

    • 202 Words
    • 1 Pages
    Decent Essays
  • Decent Essays

    Chem 115 Lab Report

    • 348 Words
    • 2 Pages

    Lab 4 in Chem 115 has three parts all calculating density. In part one, a 100 mL beaker, a volumetric pipet, and an analytical scale were obtained. To begin, the mass of the beaker was taken using an analytical scale. Then, 10.0 mL of an unknown liquid was transfered to the beaker using the volumetric pipet. Next, the mass of the beaker and liqiud was recorded along with the letter identifying the unknown liquid.…

    • 348 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    The first step was to streak the bacterium with a sterilized look onto a Mueller Hinten plate. The MH plate was incubated at 37 degrees Celsius for 48 hours. Upon return and observation, the MH plate did not isolate the colony enough to be able to test the bacterium. The professor then handed an alternate 10 that was a pure culture to streak. It was with a sterilized loop that some of the pure culture was taken out and gram stained as directed by the laboratory manual (1).…

    • 1057 Words
    • 5 Pages
    Improved Essays
  • Superior Essays

    Unknown Lab Report

    • 1472 Words
    • 6 Pages

    An unknown sample #18 was obtained on November 6, 2017. The sample came in a glass test tube with a cotton swab that contain the unknown sample. To find the identity of the unknown sample, we had to conduct several biochemical tests to eliminate and narrow down possible organisms that fit the biochemical description to accurately identify our unknown organism of interest. These biochemical tests provided insight on the physical color retention of our unknown sample, and through’s the unknown organism’s ability to break down tested compounds to determine if it had the corresponding enzyme that would allow it to do so. The testing of unknown organisms to accurately discover its identity is crucial in the field of health science.…

    • 1472 Words
    • 6 Pages
    Superior Essays
  • Improved Essays

    It is often necessary to prepare a series of different dilutions when diluting a sample for a plate count because a series of dilutions help to ensure at least one countable plate in the series, ranging from 30-300 countable colonies. As the number of bacterial cells are reduced through serial dilution, working backwards allows us to use multiplication and the dilution factor to calculate the colony-forming units present in the…

    • 358 Words
    • 2 Pages
    Improved Essays
  • Improved Essays

    Mixed Unknown Lab Report

    • 911 Words
    • 4 Pages

    After being given the broth, using sterile methods I streaked a TSA plate using the quadrant method with the given broth, in hope to grow the bacteria in isolated colonies. TSA plates are a growth media that is used for the general growth of bacteria needed for culturing. It works well because the media is nonselective…

    • 911 Words
    • 4 Pages
    Improved Essays
  • Great Essays

    One huge experimental error I made was not doing the gram staining correct the first time but I tried to fix it. I had to redo my nutrient agar plates twice because the first time it seemed like there was only one microbe. It was hard to isolate the microbes…

    • 1301 Words
    • 6 Pages
    Great Essays
  • Improved Essays

    How Do Bacteria Grow

    • 881 Words
    • 4 Pages

    Throughout this experiment I have learned several things. One thing I learned is that you can find bacterial growth in most places. However, different types of bacteria grow in different places depending on the environmental conditions and the required factors for growth for the specific bacteria. Also, I learned is the impact an error in the procedure can have. I think there were some errors in our environmental sampling lab.…

    • 881 Words
    • 4 Pages
    Improved Essays
  • Improved Essays

    According to my collected data, my group's hypothesis would be correct. Hurray! Sadly, science is never that simple. After getting over the initial disgust at my self, I began glancing at the rest of my group's dishes, and as they began to talk, I quickly realized that each of their petri dishes was the total opposite of mine. Every member of my group except me had more bacteria showing from their index finger instead of their mouth.…

    • 738 Words
    • 3 Pages
    Improved Essays
  • Decent Essays

    An operon is a cluster of genes in a bacteria that are clustered together and have related functions. Genes in an operon are coexpressed, which means that they are turned on or off under a single promoter. The genes of the arabinose operon are Ara A, Ara B, and Ara D (or the B. A. D. genes) which are all digestive enzymes that allow bacteria to break down arabinose. When Ara A, Ara B, and Ara D cluster together they form the arabinose operon. The gene that replaces the arabinose operon is the pGLO gene.…

    • 263 Words
    • 2 Pages
    Decent Essays
  • Improved Essays

    Next reflame the loop, then return to the TSA turning it at 90 degree angle while streaking quadrant two dragging some of the substance from quadrant one. Follow the same steps until all three quadrants are completed, but avoid entering quadrant one only take from quadrant two. The purpose of the streak plate method is to produce isolated colonies of an organism. The TSA plate was incubated for approximately 48 hours at 37 degrees simply to grow bacteria. After returning back to the laboratory and noticing growth on the TSA plate the same streak plate method was applied to the MacConkey agar and the Mannitol salt agar.…

    • 416 Words
    • 2 Pages
    Improved Essays

Related Topics