Usn Diving And Manned Hyperbaric Systems Safety Certification Manual, Rev 2, Chap. 2

Front 1

What documents will the SCA request from the applicant upon certification? 2-2

Back 1

1. Initial Scope of Certification (SOC)
2. Milestone Event Schedule (MES)
3. Initial Presurvey Outline Boklet (PSOB)
4. Certification Scope Notebook, if required
5. Mission configuration Matrix, if required

Front 2

Who finalizes the SOC boundries and approves it?
2-2.1

Back 2

The SOC boundries shall be finalized by the applicant and approved or modified by the SCA when the system design is complete.

Front 3

What is included in the certification milestone event schedule? 2-2.2

Back 3

A list of sequential events in the certification process with estimated dates of completion.
documentation submissions, technical reviews, and deficiency corrections shall be considered in the MES to ensure timely completion of the certification process prior to the desired use date of the system.

Front 4

When may the initial MES be submitted to the SCA?
2-2.2

Back 4

Initial MES may be submitted at the same time of shortly after the the initial SOC is submitted.

Front 5

Upon approval of the negotiated initial SOC by the SCA, a _____________ shall be prepared by the applicant? 2-2.3

Back 5

Pre-survey Outline Booklet (PSOB)

Front 6

What does the SCA need to conduct an onsite survey?
2-2.3

Back 6

1. Pre-survey Outline Booklet (PSOB)
2. System Certification requirements/guidelines Checklist (SCA Survey Checklist)

Front 7

What happens to the SCA survey Checklist upon completion of a survey? 2-2.3

Back 7

It becomes an official part of the SCA's proprofile, providing evidence that the certification requirements were met during the survey.

Front 8

What must be prepared by the applicant each time the system comes due for recertification or continuation of certification? 2-2.4

Back 8

A new Pre-survey Outline Booklet (PSOB)

Front 9

What items are included in the PSOB for standard SSD and R/C systems? 2-2.4

Back 9

1. Equipment ID
2. Operating Parameters
3. air supply system
4. Mixed gas/O2 supply system
5. Electrical systems
6. Diver Handling systems
7. Validation of as-built systems drawings
8. Inspection, test and REC records
9. OP's and EP's
10. PMS
11. Operational Demonstration

Front 10

What are 2 items produced be the applicant but are generally not mandatory for the certification process?
2-2.5

Back 10

1. The Certification Scope Notebook
2. Mission Configuration Matrix

Front 11

Who's responsibility is it to ensure detailed reviews of the system design are conducted and formally documented? 2-5

Back 11

The diving system Acquisition Manager

Front 12

A request for a on-site survey should reach the SCA at least ____ days prior to the desired date of the survey? 2-6

Back 12

90 days

Front 13

What is the purpose of the onsite survey? 2-6

Back 13

To verify that the "As-built" system has been fabricated IAW the approved documentation.

Front 14

Corrective action shall be completed prior to manned use? 2-7

Back 14

Category 1A

Front 15

Corrective action must be accomplished prior to system certification? 2-7

Back 15

Category 1B

Front 16

Corrective action must be accomplished prior to the date or event specified on the card to sustain certification?

Back 16

Category 1C

Front 17

Corrective action must be accomplished on a specified component

Back 17

asdfa