Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
41 Cards in this Set
- Front
- Back
What is mounted to a drive pad on left side of No. 2 & 3 engine RGB?
|
Engine Driven Compressor
|
|
What type of compressor do we utilize?
|
Single Stage Centrifugal Air Compressor with fully automatic controls
|
|
What are the 2 different models that supply the aircraft with air at a constant flow rate?
|
1. 101 horsepower maximum drive power at 72lb per min air flow
2.81 horsepower maximum drive power at 64lb per minute air flow. |
|
What is splined to RGB, drives the EDC, and contains worm gear and shear section?
|
Input Shaft
|
|
What is located at Drive end of EDC, mechanically disconnects EDC from RGB in the even of a malfunction?
|
Compressor Disconnect
|
|
To prevent dame to the EDC/RGB during disconnect, the engine must be operating in __________ RPM range.
|
Normal
|
|
What is the power source for Compressor Disconnect (EDC Disconnect Solenoid)
|
MEDC
|
|
What drives the oil pump and compressor Torsion Shaft (Quill Shaft) that drives the compressor impeller wheels and is direct step - up type?
|
Gear Train
|
|
What is located in scroll assembly, creates air flow, and is single stage impeller splined to torsion (Quill) shaft?
|
Centrifugal Compressor
|
|
What is in respective engine air intake scoop?
|
Intake
|
|
What is constructed in 2 pieces and bolted together around impeller to form inlet and discharge ducts for compressor?
|
Scroll Assembly
|
|
What is in the middle of scroll assembly and receives air from engine air intake?
|
Inlet Duct
|
|
What is located int he EDC inlet, controls amount of air flow through compressor, and is pneumatically controlled, hydraulically actuated and spring loaded closed?
|
Pre-Swirl Vanes (Inlet Flow Control Vanes)
|
|
What is located output side of compressor and direct discharge air into the aircraft?
|
Discharge Duct
|
|
Where do the Rake Tubes send pneumatic reference signals to?
|
Flow Control Sensing Head (Pre-Swirl Controller) and
Surge Control Sensing Head |
|
What does the overboard discharge duct that discharges air overboard to reduce back pressure incorporate?
|
Flapper Check Valve
|
|
What is located in the discharge duct and prevents compressor surges when discharge air is restricted allowing compressor discharge air to flow overboard?
|
Dump Valve
|
|
How is the Dump Valve operated, what is it controlled by and what position is it spring loaded to?
|
Hydraulically operated
controlled by surge control servo valve and dump solenoid valve spring loaded open |
|
What holds a supply of oil for EDC operation?
|
Oil Sump
|
|
What is the wet sump capacity and compressor capacity?
|
0.7 Gal
1.0 Gal |
|
What ensures positive oil flow for lubrication and control if the oil cooler becomes clogged?
|
Oil Cooler Bypass Valve
|
|
What is at the bottom of the nacelle and is used to cool EDC oil?
|
EDC Oil Cooler
|
|
EDC Oil cooler is what type of heat exchanger ?
|
oil -to - oil
|
|
At what temperature does the Temp High signal light illuminate?
|
121*C
|
|
True or False
The oil filter is NOT bypassable |
False
|
|
At what pressure does the Press Low signal light illuminate?
|
Below 50 psi
|
|
What ensures variable pressure in air flow control cylinder do not effect other oil system functions?
|
Flow Control Metering Orifice
|
|
What hydraulically positions the pre-swirl vanes?
|
Air Flow Control Cylinder
|
|
What controls the amount of oil pressure in the air flow control cylinder and is pneumatically controlled by flow control sensing head?
|
Flow Control Servo Valve
|
|
What controls the position of the pre-swirl vanes in order to maintain constant volumetric output of compressor?
|
Flow Control Sensing Head (Pre- Swirl Controller)
|
|
What positions the flow control servo valve to increase or decrease flow control cylinder pressure that is positioning the pre-swirl vanes?
|
Flow Control Sensing Head (pre-swirl controller)
|
|
What prevents variable dump valve actuating cylinder pressure form effecting the air flow control cylinder?
|
Pressure Ratio Metering Orifice
|
|
What hydraulically positions Dump Valve?
|
Dump Valve Actuating Cylinder
|
|
What controls position of the surge bleed valve by sensing static and total discharge air pressures to dump excessive EDC output overboard?
|
Surge Control Sensing Head
|
|
What prevents excessive back pressure at the EDC?
|
Surge Bleed Valve
|
|
What ports dump valve actuating cylinder pressure to sump allowing spring pressure to open the dump valve?
|
Dump Solenoid Valve
|
|
Is the Dump Solenoid Valve spring loaded open or closed?
|
Closed
|
|
True or False
The Firewall SOV does not have to be fully opened for EDC's to dump |
False
Has to be fully opened |
|
What reduces excessive back pressures at the EDC by limiting use of air cycle cooling system?
|
Pressure Ratio Limiter (PRL)
|
|
What isolates the EDC from the supply duct in the event ofan engine/EDC malfunction or fire?
|
Firewall Shut-Off Valve
|
|
What provide independent temperature control for cabin and flight station air cycle cooling Station (ACCS)?
|
Temperature Programers
|