Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
9 Cards in this Set
- Front
- Back
Name three tools that can be used to remove the cast from a resin denture base after it has been processed
|
Plaster knife, plaster saw, and/or a pneumatic air hammer
|
|
Strategic cuts are made in the cast with the plaster ______ so that the cast may be removed from the denture without breaking the denture or causing _________.
|
SAW, DISTORTION
|
|
A plaster _______ is placed in to the saw cuts and the cast is gently fractured along the cut.
|
KNIFE
|
|
After removing the cast from the denture the "flash" around the borders of the denture are removed with an arbor band on a lathe. What is flash?
|
EXCESS RESIN
|
|
Name an alternate less satisfactory method to remove "flash" from a denture.
|
Using a stone in a handpiece
|
|
To remove flash around the denture teeth what kind of instrument should be used?
|
A sharp instrument
|
|
When using a carbide bur to remove excess resin from around the teeth what must be done to the bur first?
|
It must be sharpened to a chiseled edge and held in an instrument
|
|
What's next after the flash has been removed from the denture?
|
The start of polishing stage is next.
|
|
Name a downside of using an acrylic bur to remove excess resin from a denture.
|
It may produce bur marks on the denture which become difficult to remove during polishing.
|