Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
35 Cards in this Set
- Front
- Back
What is the very first thing you should check before operating the APU?
|
ADB
|
|
What do you look for in the ADB?
|
1. Recent discrepancies against the APU.
2. What type of APU. 3. Other limiting descrepancies. (i.e.AE's no power, AM's no hydraulics) |
|
Where is the APU HRD bottle located?
|
In the nose wheel well.
|
|
Where is the APU HRD bottle placard located?
|
In the nose wheel well.
|
|
What should the Refrigerant tubes be serviced to?
|
More than a quarter way to the top of sight guage.
|
|
What should the APU oil be serviced to?
|
More than half way to the top of sight guage.
|
|
What should the Air Multiplier be serviced to?
|
More than half way to the top of sight guage.
|
|
What three things will the APU safety switch do when switched to the "SAFE" position?
|
1. Disables Intake and Exahust Doors
2. Disables HRD bottle. 3. Disables detection. |
|
What is the minimum battery voltage required for starting the APU?
|
22 VOLTS DC
|
|
Where would you find what type of APU is installed in your aircraft?
|
In the ADB.
|
|
What will automatically shut down an APU?
|
1. Engine overspeed.
2. Loss of APU oil pressure. 3. APU compartment fire. |
|
What fuel tank normally feeds the APU?
|
Tank #2.
|
|
How much fuel is required to run the APU? Why?
|
1000 LBS minimum.
For adequate hydraulic cooling. |
|
What should you check if the APU does nothing when depressing the start switch?
|
1. Connect Battery
2. Reset nose landing gear uplock. |
|
What will happen if APU fire alarm goes off?
|
APU fire extinguisher system will be activated.
|
|
What should you do if the APU fire alarm goes off?
|
Evacuate the aircraft immediately.
|
|
What is the power source for the APU fire detection system?
|
The battery.
|
|
How much fuel does the APU consume while operating?
|
300 pounds per hour.
|
|
What mode should you operate the air conditioner in when starting the APU?
|
Off position.
|
|
What mode should you operate the air conditioner in when you dehumidify?
|
AUTO 2-DOT, then gradually increase to 3-DOT.
|
|
What position should the TAS probe heater be in prior to APU start?
|
Off position.
|
|
Which covers shall be removed prior to APU operation?
|
Pitot, TAS and AOA probe covers NTB removed.
|
|
Which sight guage inside the "Fire Extinguisher" door is the APU oil level sight guage?
|
The lower sight guage.
|
|
What position should the bomb bay doors switch be in?
|
It should agree with bomb bay door position.
|
|
What position should the flap position handle be in?
|
Flap lever position should agree with flap position.
|
|
What is the only thing measured in Fahrenheit?
|
The fire detection system.
|
|
What are the RPM limits and auto shutdown for the APU?
|
98-102% (On Ground)
98-103% (In Flight) 106% (Auto Shutdown) |
|
What circuit breaker should be closed before starting APU?
|
The intake door breaker.
|
|
What is the maximum PSI for aircraft fueling?
|
55 PSI
|
|
If RPM limits drop, what can you do to maintain them within limits?
|
Turn on No.2 Fuel boost pump.
|
|
If RPM limits rise, what can you do to reduce RPM to within limits?
|
Turn on air multiplier.
|
|
what are the egt limits for -10
|
732 max peak 710 max 10 seconds 649 max continuous |
|
what are the egt limits for -3
|
704 max peak - max 10 seconds 649 max continuous |
|
what are the egt limits for -2
|
715 max peak 710 max 10 seconds 688 max continuous |
|
what does egt stand for
|
exhaust gas temperature
|