Reading...
Play button
Play button
Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
93 Cards in this Set
- Front
- Back
|
Radar surface-angular measurements are referenced to true north and measured in what plane?
|
Horizontal plane.
|
|
|
The distance from a radar set to a target measured along the line of sight is identified by what
term? |
Range.
|
|
|
What is the speed of electromagnetic energy traveling through air?
|
Approximately the speed of light (162,000 nautical miles per second).
|
|
|
How much time is required for electromagnetic energy to travel 1 nautical mile and return to the
source? |
12.36 microseconds.
|
|
|
In addition to recovery time, what determines the minimum range of a radar set?
|
Pulse width.
|
|
|
Atmospheric interference with the travel of electromagnetic energy increases with what rf energy
characteristic? |
Frequency.
|
|
|
How is prt related to prf?
|
1/prt= prf
|
|
|
What type of radar transmitter power is measured over a period of time?
|
Average power.
|
|
|
What term is used to describe the product of pulse width and pulse-repetition frequency?
|
Duty cycle.
|
|
|
What type of target bearing is referenced to your ship?
|
Relative bearing.
|
|
|
What type of radar detects range, bearing, and height?
|
Three-dimensional.
|
|
|
What characteristic(s) of radiated energy is (are) altered to achieve electronic scanning?
|
Frequency or phase.
|
|
|
What term is used to describe the ability of a radar system to distinguish between targets that are
close together? |
Target resolution.
|
|
|
The degree of bearing resolution for a given radar system depends on what two factors?
|
Beam width and range.
|
|
|
What happens to the speed of electromagnetic energy traveling through air as the altitude
increases? |
Speed increases.
|
|
|
What term is used to describe a situation in which atmospheric temperature first increases with
altitude and then begins to decrease? |
Temperature inversion.
|
|
|
What radar subsystem supplies timing signals to coordinate the operation of the complete
system? |
Synchronizer.
|
|
|
When a transmitter uses a high-power oscillator to produce the output pulse, what switches the
oscillator on and off? |
High-voltage pulse from the modulator.
|
|
|
What radar component permits the use of a single antenna for both transmitting and receiving?
|
Duplexer.
|
|
|
What is the simplest type of scanning?
|
Single lobe.
|
|
|
How does the operator of a single-lobe scanning system determine when the target moves off the
lobe axis? |
The reflected signals decrease in strength.
|
|
|
What are the two basic methods of scanning?
|
Mechanical and electronic.
|
|
|
Rotation of an rf-feed source to produce a conical scan pattern is identified by what term?
|
Nutation.
|
|
|
The Doppler effect causes a change in what aspect of rf energy that strikes a moving object?
|
Frequency.
|
|
|
The Doppler variation is directly proportional to what radar contact characteristic?
|
Velocity.
|
|
|
The Doppler method of object detection is best for what type objects?
|
Fast-moving targets.
|
|
|
The beat frequency in a swept-frequency transmitter provides what contact information?
|
Range.
|
|
|
What factor determines the difference between the transmitted frequency and the received
frequency in an fm transmitter? |
Travel time
|
|
|
What type of objects are most easily detected by an fm system?
|
Stationary.
|
|
|
What transmission method does NOT depend on relative frequency or target motion?
|
Pulse modulation.
|
|
|
What transmission method uses a stable cw reference oscillator, which is locked in phase with the
transmitter frequency? |
Pulse-Doppler.
|
|
|
What type of radar provides continuous range, bearing, and elevation data on an object?
|
Track radar.
|
|
|
Radar altimeters use what type of transmission signal?
|
Frequency modulated (fm).
|
|
|
A surface-search radar normally scans how many degrees of azimuth?
|
360 degrees.
|
|
|
What limits the maximum range of a surface-search radar?
|
Radar horizon.
|
|
|
What is the shape of the beam of a surface-search radar?
|
Wide vertically, narrow horizontally.
|
|
|
Air-search radar is divided into what two basic categories?
|
2D and 3D.
|
|
|
What position data are supplied by 2D search radar?
|
Range and bearing.
|
|
|
Why do 2D air-search radars use relatively low carrier frequencies and low pulse-repetition
rates? |
Increased maximum range.
|
|
|
Why is the range capability of 3D radar usually less than the range of 2D radar?
|
Higher operating frequency.
|
|
|
Fire-control tracking radar most often radiates what type of beam?
|
A narrow circular beam.
|
|
|
Tracking radar searches a small volume of space during which phase of operation?
|
Acquisition.
|
|
|
What width is the pulse radiated by fire-control tracking radar?
|
Very narrow.
|
|
|
Which beam of missile-guidance radar is very wide?
|
Capture beam.
END CH. 1 |
|
|
What is the purpose of the synchronizer in a radar system?
|
Controls system operation and timing.
|
|
|
What is the purpose of the majority of circuits in a radar system?
|
Timing and control
|
|
|
A self-synchronized radar system obtains timing trigger pulses from what source?
|
Transmitter.
|
|
|
What type of multivibrator can be used as a radar master oscillator?
|
Free-running.
|
|
|
In an externally synchronized radar, what determines the prr of the transmitter?
|
The master oscillator
|
|
|
What basic circuits meet the requirements of an externally synchronized master oscillator?
|
Sine-wave oscillator, single-swing blocking oscillator, and master-trigger (astable) multivibrator.
|
|
|
Name a disadvantage of sine-wave oscillator synchronizers.
|
It requires additional shaping circuits
|
|
|
Which of the basic timing circuits produces sharp trigger pulses directly?
|
Blocking oscillators
|
|
|
What are the two basic types of transmitters?
|
Keyed oscillator and power-amplifier chain.
|
|
|
What controls transmitter pulse width?
|
The modulator
|
|
|
In addition to a flat top, what characteristics must a modulator pulse have?
|
Steep leading and trailing edges.
|
|
|
What type of modulator is most commonly used in modern radar systems?
|
Line-pulsed.
|
|
|
What three types of storage elements most often are used in modulators?
|
Capacitor, artificial transmission line, or pulse-forming network.
|
|
|
What characteristic is determined by the time required for a voltage wave to travel from the input
end of an artificial transmission line to the output end and back again? |
Pulse width.
|
|
|
What type of tube best meets the requirements of a modulator switching element?
|
Thyratron.
|
|
|
What modulator element controls the rate at which the storage element charges?
|
The charging impedance.
|
|
|
What is the frequency range of magnetron oscillators?
|
600-30,000 megahertz.
|
|
|
What two forms of instability are common in magnetrons?
|
Mode skipping and mode shifting.
|
|
|
What is the effect on magnetron operation if the magnetic field strength is too high?
|
The magnetron will not oscillate.
|
|
|
What is the typical frequency range about the center frequency of a tunable magnetron?
|
±5 percent.
|
|
|
What is the primary advantage of power-amplifier transmitters over keyed-oscillator
transmitters? |
Frequency stability.
|
|
|
What type of klystron is used as the final stage of a power-amplifier transmitter?
|
Multicavity klystron.
|
|
|
What transmitter component allows the radiation of a large number of discrete frequencies over
a wide band? |
Frequency synthesizer.
|
|
|
What is the result of pulsing a pulsed rf amplifier when no rf is present?
|
Oscillations at an undesired frequency.
|
|
|
What type of switches are used as duplexers?
|
Electronic.
|
|
|
What tube in a duplexer has the primary function of disconnecting the receiver?
|
Tr tube.
|
|
|
How may the tr tube ionization speed be increased?
|
Apply keep-alive voltage.
|
|
|
The actions of the tr and atr circuits depend on the impedance characteristics of what length of
transmission line? |
Quarter-wavelength section.
|
|
|
During which of the transmit or receive cycles are both the tr and atr tubes of a parallelconnected
duplexer ionized (arcing)? |
Transmit.
|
|
|
In a series-connected duplexer, what tube (tr or atr), if any, fires during the receive cycle?
|
Neither fires.
|
|
|
To propagate energy down an arm of a hybrid ring duplexer, the two fields at the junction of the
arm and the ring must have what phase relationship? |
180 degrees out of phase.
|
|
|
What is the greatest limiting factor in a receiver’s detectable range?
|
Noise.
|
|
|
What type of receiver is most often used in radar systems?
|
Superheterodyne.
|
|
|
What IF frequencies are normally used in radar receivers?
|
Thirty or sixty megahertz.
|
|
|
Which component of the receiver produces the signal that is mixed with the received signal to
produce the IF signal? |
Local oscillator.
|
|
|
What receiver circuit actually produces the IF frequency?
|
Mixer.
|
|
|
The IF amplifiers are connected in what amplifier configuration?
|
Cascade.
|
|
|
Which receiver component converts the IF pulses to video pulses?
|
Detector.
|
|
|
Which of the two types of automatic gain control, agc or iagc, is most effective in radar use for
the Navy? |
IAGC.
|
|
|
Immediately after the transmitter fires, stc reduces the receiver gain to what level?
|
Zero.
|
|
|
How does ftc affect receiver gain, if at all?
|
FTC has no effect on receiver gain.
|
|
|
What type of target has a fixed phase relationship from one receiving period to the next?
|
Stationary.
|
|
|
What signal is used to synchronize the coherent oscillator to a fixed phase relationship with the
transmitted pulse? |
Coho lock pulse.
|
|
|
What is the phase relationship between the delayed and undelayed video?
|
Opposite.
|
|
|
When a large signal and a small signal are applied to a lin-log amplifier at the same time, what
is the effect on the small signal? |
Amplification is reduced.
|
|
|
What happens to the overall gain of a lin-log amplifier as each stage saturates?
|
Decreases.
|
|
|
A monopulse receiver has how many separate channels?
|
Three.
|
|
|
If a target is on the bearing axis of the radiated beam, what is the input to the bearing IF
channel? |
Zero.
|
|
|
What characteristic of the bearing and elevation output signals determines the direction of
antenna movement? |
Phase
|
