Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
15 Cards in this Set
- Front
- Back
What two commands could tell you information about the IOS version on a given switch SW1 without establishing a Telnet connection to it but using another connected switch?
|
'show cdp entry SW1' or 'show cdp neighbors detail'
|
|
What two commands could tell you information about a connected switch SW1's model of hardware?
|
'show cdp neighbors' or 'show cdp entry SW1'
|
|
If a given interface Fa0/1 is listed as 'disabled' by 'show interfaces status', what two status codes will be displayed by 'show interfaces Fa0/1'?
|
Administratively down and line protocol down
|
|
What two commands list the MAC address table entries for MAC address configured by port security?
|
'show mac address-table static' or 'show mac address-table port-security'
|
|
Cisco Discovery Protocol (CDP) displays what information about other devices connected to it?
|
Hostname, MAC and IP addresses, interface number, Device type, and model/IOS version
|
|
How can you disable CDP from interface configuration and from global configuration?
|
'no cdp enable' and 'no cdp run', appropriately
|
|
What are the only ports on a switch that need to use CDP?
|
Ports connected to another switch, router, or IP phone
|
|
Cylic redundancy check (CRC) errors on an interface are caused by what?
|
A frame failing the FCS error detection
|
|
Frames that do not meet the minimum frame size requirement of 64 bytes, sometimes caused by collisions, are called...
|
Runts
|
|
Frames that exceed the maximum frame size requirement of 1518 bytes are called...
|
Giants
|
|
Frame errors are generated when, sometimes from a collision, a frame has an...
|
Illegal format
|
|
Late Collisions occur after the 64th byte of a frame has been transmitted. What is this normally caused by on a modern Ethernet LAN?
|
Duplex mismatches
|
|
If a switch has a large number of CRC errors but a few collisions, what problem may be causing this?
|
Electromagnetic interference
|
|
What occurs when two switches are both configured with 'switchport mode dynamic auto' and how can you resolve this?
|
Changing one of the switches' configurations to 'switchport mode dynamic desirable' or 'switchport mode trunk'
|
|
If SW1's trunk port with DTP enabled is connected to SW2 with trunking enabled, but DTP disabled, what occurs?
|
One switch will remain in access mode and the trunk will work, but only on the native VLAN
|