Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
10 Cards in this Set
- Front
- Back
The effective throat of a complete penetration groove weld shall be
|
The thickness of the thinner part joined
|
|
When welding lengthwise connecting two round bars, the proper symbol would be
|
Flare V Groove weld
|
|
Fillet welds may be used to connect skewed T joints provided the plates are set at an angle of not less than
|
30°
|
|
The minimum thickness for a plug weld in material 1" thick shall be
|
5/8"
|
|
Welding shall not be done when:
|
When ambient temperature is lower than 0°F or
Surfaces are wet or exposed to rain, snow, or high wind or When welders are exposed to in- clement conditions. |
|
Approved filler metal requirements for submerged arc welding are found in:
|
AWSA5.17 & A5.23
|
|
When welding 5/16" plate in the field, a welder must be certified for
|
Structural
|
|
Re-entrant copes shall have a minimum radius of:
|
1"
|
|
Where tight fit of intermediate stiffeners is specified, it shall be defined as allowing a gap of up to
|
1/16"
|
|
Spatter is caused by
|
Welding current too high or arc length too long
|