Reading...
Play button
Play button
Use LEFT and RIGHT arrow keys to navigate between flashcards;
Use UP and DOWN arrow keys to flip the card;
H to show hint;
A reads text to speech;
50 Cards in this Set
- Front
- Back
|
When can a QA inspector sign off grounding discrepencies and/or flight control work if they are not a primary QA?
|
when approved by a supervisor possesing maintenance release authority.
|
|
|
What are the three factors that contribute to FOD?
|
Poor housekeeping, poor maintenance practices, carelessness
|
|
|
What is JOAP responsible for?
|
The determination of wear metal concentrations in the lubricating fluid.
|
|
|
What is the MIL SPEC # for fuel system icing inhibitor?
|
MIL-DTL-85470B
|
|
|
Introduction of icing inhibitor will lower the flash point of jp-5 by how many degrees?
|
by 4 degrees
|
|
|
In what manual can the corrosion control program be found?
|
PG-85-00-60
|
|
|
Who shall manage the coast guards TEMPEST program?
|
ALC. as directed by CG-41
|
|
|
How long is an AVGFET certification valid for?
|
1 year
|
|
|
What form is used to make changes to the authorized chemical use list?
|
CG-22
|
|
|
Who can authorize a one time purchase of a chemical not found in the authorized chemical use list?
|
the EO
|
|
|
The electrolyte level must not be adjusted until the battery has been charged and allowed to sit for how long?
|
2 hours
|
|
|
When checking the battery temperature the case reaches 115F what should be done?
|
it may be necessary to add water to the affected cells or discontinue charging until battery cools.
|
|
|
To eliminate the possibility of damage by electrostatic discharge, all maintenance
personnel should utilize what? |
a personnel ground device.
|
|
|
A personnel ground device consists of what?
|
a conductive bracelet, 200K ohm resistor, a length of #20 standard copper
insulated wire and a clip/clamp, connected in series and attached to an adequate “ground |
|
|
Harmful effects from industrial solvent exposure come principally from...?
|
inhalation of vapors and skin contact
|
|
|
All static grounds will have resistences of less than how many ohms?
|
14,000 ohms
|
|
|
How often will existing static grounds be tested and IAW what manual?
|
14 months and MIL-HDBK-274(AS)
|
|
|
With a fuel spill of 18 inches or less, ramp personnel shall do what?
|
stand by until aircraft is dispatched.
|
|
|
With a fuel spill of 10 feet or less in any dimension or 50 square feet or less what shall ramp personnel do?
|
have a fire guard posted, up wind, with a foam-type or
Halon-type fire extinguisher until the area is inert and purged |
|
|
Fuel spills over 50 square feet or continous shall be....?
|
reported to
the supervisor in charge, who shall notify the airport or local fire department to inert the spill. Anyone in the spill area shall leave at once. |
|
|
What is the number for the Hazardous Waste Management manual?
|
COMDTINST M16478.1
|
|
|
What is the number for a serviceable tag?
|
DD-1574
|
|
|
What is the number for a unserviceable (repairable) tag?
|
DD-1577-2
|
|
|
What is the number for a Unsatisfactory report?
|
CG-1577-A
|
|
|
Who conducts a monthly check of all aircraft log books?
|
the EO
|
|
|
What does an ACMS configuration report list?
|
All serial number tracked components on aircraft or major assembly
|
|
|
What does the absence of a serial number for a particular component indicate?
|
the component is not installed in the data base and
required maintenance is not being scheduled against it. |
|
|
As a minimum, how often shall a new MDL be printed?
|
Once a month. and it should have calender and hourly tasks for a two month period.
|
|
|
what is the color of the pre mission and servicing record?
|
Yellow
|
|
|
What is the color of the flight record?
|
blue
|
|
|
What is the color of a flight generated maintenace record?
|
Pink
|
|
|
What is the color of a flight safety maintenance document?
|
Pink
|
|
|
Paper logbook forms will be used when non-connectivity exceeds how many hours?
|
4 hours
|
|
|
How long are paper form logbooks retained for?
|
90 days
|
|
|
All deferred maintance actions shall be authorized by who?
|
the EO or whoever he has appointed.
|
|
|
With the exception of deployed aircraft, no deferred discrepancies shall remain open for a period longer than how many days?
|
30 days and the approval of the EO or their designated person.
|
|
|
Aircraft engines, high value components, items requiring special configuration control procedures, items in ciritcal supply and of sufficiently high cost are what type?
|
Type 1 materiel
|
|
|
aeronautical materiel, less avionics for which ALC has servicewide support responsibility. Unit price of $250 or more, procured from a commercial source of supply, flight critical, repairable. what type is this?
|
type 2 materiel
|
|
|
Consumable aeronautical materiel, less avionics, with a unit price less than $250 and procurable from an OGA source. what type?
|
Type 3 materiel
|
|
|
Avionics materiel for which ALC has servicewide support responsibility. Unit price of $800 or more, procured from a commercial source of supply, flight critical, repairable. what type is it?
|
Type 4 material
|
|
|
Consumable avionics materiel with a unit price less than $800 and procurable
from an OGA source. Units set their own allowance quantities and procure material using unit AFC 30 funds |
Type 5 material
|
|
|
Aeronautical Support Equipment (SE): For items costing more than $250 but
less than $2500 ALC will provide initial provisioning but will not provide subsequent replacement or repair |
Type 6 material
|
|
|
Material used to support the Turbomeca Arriel 2C2 CG engine.
|
Type 7 material
|
|
|
Unit price of $2500 or more, Difficult to procure through OGA or commercial sources, Critical support item, ALC managed Depot Level Repairable (DLR) program, Reparables beyond unit capability and funding of $2500 or more
|
Type 8 material
|
|
|
Priority 2
requisitions are selected for what type of shipment and will be filled as long as there are parts on the ALC shelf |
immediate shipment
|
|
|
Priority 5 requisitions will be filled if there are more than how many parts on the ALC
shelf? |
2 parts
|
|
|
Priority 12 requisitions will be filled if there are more than how many parts on the ALC shelf?
|
5 parts
|
|
|
Materiel shall be shipped to ALC or other designated repair facility with the
appropriate documentation within how many days of removal from service? |
15 days
|
|
|
What is the maximum amount of days you can wait before shipping an item back to ALC?
|
30 days.
|
|
|
For Preservation, Packaging, and Packing of Military Supplies and Equipment you should refer to what manual?
|
NAVSUP PUB 503
|
